Transport Canada recall 2012091
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2012091 |
| Manufacturer's number | 159 |
| Reported | 2012-03-07 |
| Component | Lights And Instruments |
| Notification type | Safety Mfr |
| Units potentially affected | 30477 |
What is wrong
On certain vehicles, silicone grease may have come into contact with the stop lamp switch during vehicle assembly. If grease infiltrates the switch, instrument panel warning lamps could illuminate, a no start condition could result, or the shift lever may not shift from the PARK position. In some instances, the vehicle stop lamps could become inoperative. Failure of the stop lamps to illuminate when the brakes are applied may result in the following road users being unaware of the driver's intentions, increasing the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the stop lamp switch.
| 2009 TOYOTA CAMRY | |
|---|---|
| 2009 TOYOTA VENZA | |
| 2010 TOYOTA VENZA | |
| 2011 TOYOTA VENZA |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| T-SB-0041-14 Rev | 2017-08-01. Service bulletin. TSB: Some 2007 - 2011 model year Camry HV vehicles may exhibit a condition where the brake, ABS, and/or TRAC warning light(s) are ON and/or a Check VSC message is displayed. Diagnostic Trouble Code (DTC) C1391, C1252, C1253 or C1256 may be stored. This condition may be caused by a small internal brake fluid leak inside the brake actuator. |
|---|
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.