Transport Canada recall 2011157
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2011157 |
| Reported | 2011-04-18 |
| Component | Label |
| Notification type | Inconsequential |
| Units potentially affected | 2734 |
What is wrong
Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 110 - Tire Selection and Rims. The French-language wording displayed on the tire placard does not fully comply with the revised requirements of the Standard, which came into force on September 1, 2009. As the variation in the French text is minor, and all required safety information is displayed on the placard, no corrective recall action is required. This technical non-compliance is deemed to be non-safety related.
| 2010 NISSAN FRONTIER | |
|---|---|
| 2010 NISSAN PATHFINDER | |
| 2010 NISSAN XTERRA |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| NTB09131B | 2021-05-10. Service bulletin. SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement "Certification Label" or "VIN Plate / Label" may be needed. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. See this bulletin for further detail. |
|---|---|
| NTB-10-052 | 2010-04-21. Service bulletin. NISSAN: THE PROPELLER SHAFT U JOINT (JOURNAL/JOURNAL BEARINGS) IS THE SOURCE OF NOISE AND/OR VIBRATION ON AN APPLIED VEHICLE. DIAGNOSE BY EVALUATING THE U JOINT WITH THE PROPELLER SHAFT REMOVED. REPLACE THE U JOINT (JOURNAL/JOURNAL BEARINGS). *PE |
| NTB-09-129 | 2010-04-07. Service bulletin. NISSAN: VENT CONTROL VALVE REPLACEMENT. WHEN REPLACING THE EVAP CANISTER VENT CONTROL VALVE FOR REASON: USE THE ONE LISTED ON PAGE 2; FOR VENT CONTROL VALVE REPLACEMENT PROCEDURE, REFER TO THE APPROPRIATE SECTION OF THE ELECTRONIC SERVICE MANUALS (ESM; WHEN INSTALLING THE NEW VALVE, DO NOT ADD ANY LUBE TO ITS O RING; FOR FRONTIER (D40 SERIES) ONLY, INSTALL THE PROTECTOR LISTED IN PARTS INFORMATION. *PE INCLUDES 2005-09 FRONTIER. UPDATED 12/8/10. *PE |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.