Transport Canada recall 2010139
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2010139 |
| Manufacturer's number | 099 |
| Reported | 2010-04-29 |
| Component | Steering |
| Notification type | Safety Mfr |
| Units potentially affected | 1415 |
What is wrong
On certain vehicles, the center position of the Steering Angle Sensor (SAS) may not be stored correctly due to improper logic of skid control ECU programming. If this occurs, in most cases the VSC/TRAC warning light will illuminate. However, in limited situations the Vehicle Stability Control (VSC) system could activate at low speed (approximately 15 km/hr) for a few seconds after acceleration from a stopped position, and the vehicle may not accelerate as quickly as the driver expects. This could increase the risk of a crash causing property damage, personal injury or death. Correction: Dealers will re-program the skid control ECU.
| 2003 TOYOTA SEQUOIA |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 00706 | 2007-09-26. Service bulletin. VSC-RELATED ZERO POINT CALIBRATION AND SENSOR CHECK. *KB |
|---|
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.