Transport Canada recall 2010114
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2010114 |
| Reported | 2010-04-13 |
| Component | Lights And Instruments |
| Notification type | Compliance Mfr |
| Units potentially affected | 172 |
What is wrong
On certain X5 M vehicles, the front side marker lamps are not illuminated as required by the Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. These vehicles were equipped with front side marker lamps, but not with the power supply cables leading to the lamps. As a result, the front side marker lamps do not illuminate. Reduced visibility increases the risk of crash causing property damage, personal injury or death. Correction: Dealers will install power supply cables for the front side marker lamps.
| 2010 BMW X5 |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 631009 | 2018-12-03. Service bulletin. INFORMATION Note: Failures that result from the installation of non-approved accessories and/or non-original parts are not covered. Procedure A with Reprogramming and Encoding the Vehicle Covered under the terms of the BMW New Vehicle/SAV Limited Warranty or the BMW Certified Pre-Owned Program. Labor operation code 00 00 006 is a Main labor operation. If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead. If a control module fails to program correctly or initializations are required, the additional work must be claimed with separate labor operations under the applicable defect code listed above; refer to KSD2. And, if necessary, also: Procedure A without Reprogramming and Encoding the Vehicle (Vehicle is already at the Correct I-Level) Covered under the terms of the BMW New Vehicle/SAV Limited Warranty. |
|---|---|
| 630414 | 2018-11-13. Service bulletin. Delay in Automatic Driving Light Switching On/Off. When driving out of a tunnel or exiting underground parking, the automatic driving light remains switched on for two minutes, even in daylight. The automatic driving light switching on/off can be shorter or longer when it starts to get dark. CAUSE The software for the switch-on threshold is lowered to protect the xenon light source. |
| SI B65 04 14 | 2015-06-22. Service bulletin. BMW:SOME BMW MODELS MAY OR MAY NOT DISPLAY AIRBAG WARNING LIGHT. *TA |
| SIB-63-09-14 | 2015-06-10. Service bulletin. BMW: SOME VEHICLES, WITH 552 OPTION, ARE EXPERIENCING A MALFUNCTION OF LED HEADLIGHT ON ONE WHERE IT FLICKERS ON AN DOFF DURING DRIVING AND THE CONTROL CHECK MESSAGE IS INDICATING DEFECTIVE DRIVING LIGHT OR PARKING LIGHT. *PE |
| SIB-27-02-12 | 2013-07-18. Service bulletin. BMW: DUE TO AN ERROR IN SOFTWARE CALIBRATION, SOME VEHICLES ARE EXPERIENCING WARNING ILLUMINATION OF DSC, ABS AND BRAKE AND A POSSIBLE WARNING IN CONTROL DISPLAY FOR CHASSIS CONTROL SYSTEM FAILURE. MODELS 2009-2012 F30, 01, 02, 07, 10, 12, 13, 25, E70, 71, 84. NO MODEL YEARS LISTED. *PE |
| SIB-63-05-11 | 2012-01-07. Service bulletin. BMW: ON CERTAIN VEHICLES, THE XENON HEADLAMP OFTEN HAVE NO TROUBLE FOUND WHEN RETURNED AND TESTED THRU WARRANTY PARTS SYSTEM. THE ROOT CAUSE IS NOT POSSIBLE TO BE IDENTIFY. *PE |
| SIB-63-10-09 | 2011-08-16. Service bulletin. BMW: THE BRAKE LIGHT FAILS AND THE BULB HOLDER IS DEFORMED DUE TO HIGH TEMPERATURES AND THE COMPOSITION OF THE HOLDER. *RM UPDATED ON 4/25/2013. *KB |
| SIB-63-01-11 | 2011-08-16. Service bulletin. BMW: CHECK CONTROL MESSAGE IS DISPLAYED WITH A STORED TROUBLE CODE RELATED TO HEADLIGHTS. *RM |
| SIB-63-11-10 | 2011-08-15. Service bulletin. BMW: WATER LEAKS INTO THE TAILGATE LAMP CAUSING CORROSION AND CAN LEAD TO ELECTRICAL FAILURE OF THE LAMP. THERE WILL ALSO BE A WARNING LIGHT IN THE INSTRUMENT CLUSTER. E70. *RM |
| SIB-66-09-10 | 2011-05-04. Service bulletin. BMW: AFTER STARTING THE VEHICLE THERE IS A CHECK CONTROL MESSAGE THAT SAYS THE HIGH BEAM ASSIST FAULTY. THE FUNCITON CANNOT BE ACTIVATED UNTIL AFTER DRIVING FOR 5 MINUTES. *RM |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.