Transport Canada recall 2009333
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2009333 |
| Manufacturer's number | J30 |
| Reported | 2009-11-19 |
| Component | Powertrain |
| Notification type | Safety Mfr |
| Units potentially affected | 12695 |
What is wrong
On certain vehicles equipped with an automatic transmission, operating under rigorous off-road conditions could cause the transmission fluid temperature to elevate to the point of causing transmission failure. Should the transmission fluid boil over, it may come into contact with a hot engine or exhaust component and cause a fire which could result in property damage, personal injury or death. Correction: Dealers will install a "HOTOIL" message in the instrument cluster and a chime to indicate elevated transmission fluid temperature.
| 2007 JEEP WRANGLER | |
|---|---|
| 2008 JEEP WRANGLER |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 101232 | 2024-11-07. Service bulletin. Plate - Planetary |
|---|---|
| S1121000006RevA | 2022-09-26. Service bulletin. (Revision A) No Start No Crank ? Starter Will Not Engage And There Are No Related Codes Or Concerns |
| 9004009 | 2022-09-26. Service bulletin. Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter. |
| S80 | 2022-09-15. Service bulletin. Customer Satisfaction Notification S80 Aftermarket Dana 60 Front Axle The aftermarket front axle steering knuckles have been machined with an incorrect taper during the manufacturing process on about 250 of the above vehicles, with approximately 80 of the axles sold by Mopar aftermarket. This condition can result in premature axle knuckle wear. The aftermarket front axle knuckles must be replaced with new axle knuckles for the left side and right side. |
| S1121000006 Rev. | 2020-09-28. Service bulletin. (Revision A) No Start No Crank ? Starter Will Not Engage And There Are No Related Codes Or Concerns |
| S80 | 2018-06-04. Service bulletin. Customer Satisfaction Notification S80 Aftermarket Dana 60 Front Axle The aftermarket front axle steering knuckles have been machined with an incorrect taper during the manufacturing process on about 250 of the above vehicles, with approximately 80 of the axles sold by Mopar aftermarket. This condition can result in premature axle knuckle wear. The aftermarket front axle knuckles must be replaced with new axle knuckles for the left side and right side. |
| WB-D-11-25 | 2012-08-17. Service bulletin. JEEP: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. INFORMATION REGARDING THE EXTENSION WARRANTY FOR DIAGNOSIS AND REPLACEMENT OF TRANSMISSION OIL COOLER LINES. *PE |
| CSN-L05 | 2011-09-26. Service bulletin. CHRYSLER SERVICE CAMPAIGN: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. THE TRANSMISSION COOLER LINES MAY LEAK TRANSMISSION FLUID AT THE HOSE TO TUBE JOINTS. *RM |
| SB-21-006-11 | 2011-09-20. Service bulletin. CHRYSLER: 2008-2010 JEEP WRANGLER. WEEPING TRANSMISSION OIL COOLER LINES. INFORMATION ON INSTALLING NEW TRANSMISSION OIL COOLER SUPPLY AND RETURN LINE ASSEMBLY. *RM |
| 21-018-08 | 2008-10-03. Service bulletin. CHRYSLER/DODGE/JEEP: FLASH:DIAGNOSTIC TROUBLE CODE, DTC P0740 OR P1798 AND AUTOMATIC TRANSMISSION SHIFT IMPROVEMENTS 1-2 OR 2-3 COLD SHIFT IMPROVEMENTS. *PE |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.