Transport Canada recall 2008084
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2008084 |
| Reported | 2008-03-07 |
| Component | Fuel System |
| Notification type | Safety Mfr |
| Units potentially affected | 292 |
What is wrong
On certain motorcycles, the fuel tank breather hose may have been installed incorrectly, causing it to be pinched between the frame and other neighboring components. In high ambient temperatures, the pressure inside the fuel tank could build-up, resulting in the bulging of the tank near the rear tire. Severe suspension compression, with a high payload, can cause the bottom of the tank to rub against the rear wheel, potentially resulting in a fuel leak. Fuel leakage, in the presence of an ignition source, could result in a fire. Also, the rear wheel could lose traction as a result of fuel spillage, which could cause a vehicle crash with personal injuries or death. Correction: Dealers will reroute the fuel breather.
| 2007 BMW F800S | |
|---|---|
| 2008 BMW F800S | |
| 2007 BMW F800ST | |
| 2008 BMW F800ST |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| MC1100116 | 2018-12-10. Service bulletin. Coolant pump drain hose. Details The coolant pump is fitted with a radial shaft seal on the oil-side and on the coolant-side is a mechanical seal. Mechanical seals are reliable an durable, yet for technical reasons, they always exhibit minor seepage. The seepage amount is considered to be within permissible limits if the coolant does not need to be topped up between service intervals. The drain hole (arrow in the figure) of the coolant pump is in plain view. Even small, inevitable seepage is noticed and often perceived to be a faulty coolant pump. In many such cases, fault-free coolant pumps are replaced. In order to reduce misdiagnosis and repeat repairs, a drain hose is retrofitted. The hose diverts the seepage away from the field of view to under the engine. Yet large amounts of leakage that indicate a faulty coolant pump will be noticed. |
|---|---|
| SIB-16-02-09 | 2010-07-14. Service bulletin. BMW VEHICLES: FUEL LEVEL SENSOR REPAIRS. WHERE IT IS NECESSARY TO REPLACE THE RIGHT OR THE LEFT SIDE FUEL LEVEL SENSOR DUE TO A FAILURE, THE ENTIRE PUMP AND HOUSING OR DELIVERY UNIT (SUCTION JET ASSEMBLY) DO NOT NEED TO BE REPLACED AS WELL. IN SOME CASES, EPC DOES NOT SHOW THAT THE REPAIR KIT IS AVAILABLE SEPARATELY IN THE ILLUSTRATION, BUT IT IS AVAILABLE IN THE PARTS DESCRIPTION. ALL MODELS. NO MODEL YEARS LISTED. *PE |
| SB-00-021-07 | 2009-12-07. Service bulletin. BMW MOTORCYCLE: ENGINE FUELS CONTAINING ETHANOL. BMW MOTORRAD HAS NO OBJECTION TO THE USE OF SI ENGINE FUELS CONTAINING UP TO A MAXIMUM OF 10% ETHANOL AND IMPOSES NO WARRANTY RESTRICTIONS. ETHANOL MIXTURES IN PROPORTIONS HIGHER THAN 10% CAN HAVE AN ADVERSE EFFECT ON PERFORMANCE AND CAN RESULT IN DAMAGE TO COMPONENTS THAT COME INTO CONTRACT WITH FUEL. NO WARRANTY CLAIMS WHATSOEVER FOR DAMAGE CAUSED IN THIS WAY WILL BE ACCEPTED. NO MODEL YEARS LISTED. *PE |
| 16-001-08 (014) | 2008-10-17. Service bulletin. BMW MOTORCYCLE: CHANGE TO ROUTING OF FUEL TANK BREATHER. IF FUEL TANK BREATHER HOSE OF THE K7A IS TRAPPED B Y NEIGHBORING COMPONENTS, PRESSURE EQUALIZATION INSIDE THE FUEL TANK IS POSSIBLE ONLY TO A LIMITED EXTENT. *PE |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.