Transport Canada recall 2005220
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2005220 |
| Manufacturer's number | 3305G |
| Reported | 2005-07-20 |
| Component | Electrical |
| Notification type | Safety Mfr |
| Units potentially affected | 4449 |
What is wrong
On certain vehicles, if while parked the engine is operated at high RPM's for an excessive length of time, some parts around the exhaust system can melt and produce a variety of malfunctions. The problems caused by the excessive heat build-up can range from an inoperative oxygen sensor, neutral switch and back-up lights, problems with the parking brakes, malfunctions of the gas gauge, and in the worst case, possible leaks from the fuel tank. Fuel leakage in the presence of an ignition source could result in a fire. Correction: Dealers will reprogram the Powertrain Control Module, install a heat insulator pad on the fuel tank, and inspect various components for heat damage.
| 2004 MAZDA RX-8 | |
|---|---|
| 2005 MAZDA RX-8 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 09-022-26 | 2026-08-04. Service bulletin. This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted in Red text. 09-042/04 12/10/04 DESCRIPTION Some vehicles may exhibit inoperative electric rear window defroster grid lines, integral antenna concerns causing radio reception issues or terminal tabs pulled from the rear window glass. Follow the diagnostic and repair procedures included in this service information to inspect and service rear defroster grid lines, integral antenna concerns or broken terminal tabs. |
|---|---|
| 09-038-24 | 2024-09-04. Service bulletin. In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer’s responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the “Speedometer Replacement Label”. Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda’s vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO’s services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense. |
| 09-016-23 | 2023-03-03. Service bulletin. Speedometer replacement procedure |
| 09-024-22 | 2022-08-04. Service bulletin. In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. |
| 01-006-22 | 2022-07-06. Service bulletin. This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure. |
| 0900716 | 2022-06-06. Service bulletin. Speedometer replacement procedure |
| 0100516 | 2022-06-06. Service bulletin. Battery test procedure requirements using the GR81291 |
| 01-003/22 | 2022-04-05. Service bulletin. The Mazda DCA-8000 is required for all warranty battery testing. If the Mazda DCA-8000 is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code. |
| 01-006-21-3779b | 2022-01-06. Service bulletin. Battery Maintenance: This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure. |
| 01-006-21-3779a | 2021-09-03. Service bulletin. This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.