Transport Canada recall 2005194
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2005194 |
| Manufacturer's number | C1000010 |
| Reported | 2005-06-29 |
| Component | Powertrain |
| Notification type | Safety Mfr |
| Units potentially affected | 346 |
What is wrong
On certain vehicles, rust build-up on the automatic transmission shift linkage, due to an insufficient corrosion inhibiting ability, may cause the linkage the bind. As a result, the effort required to operate the shift control lever may increase. In the worst case, the shift control lever may become inoperative, or the transmission gear position indicated on the shift lever housing may not match the actual gear selection at the transmission. Correction: Dealers will install a modified shift control lever assembly. Note: This recall is superseded by recall 2008172.
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 20-002 | 2020-06-12. Service bulletin. SUBJECT: AISIN Transmission Repeat Failure Diagnosis Process MODELS: FE639, FE640, FE649, FG639, FH210, FE83D, FE84D, and FE85D DESCRIPTION: This process must be followed for any AISIN transmission assembly that fails during the 12 month/unlimited mileage Parts Warranty. This will help the dealer; MFTA and AWTEC ensure that all installation procedures were followed and that the recently installed transmission is properly diagnosed before another transmission assembly is installed. If an AISIN transmission has a perceived failure after installation, the dealer technician must do the following: 1.Open a Technical Assistance Request (TAR) with the Technical Support Center (TSC) to begin diagnostic support. 2.Attach all documentation, including DTCs, AISIN Transmission Diagnostic Information Form (ATDI0101) and photos/videos as needed. 3.The TSC and AWTEC will review the documentation and if additional diagnostic support is needed, MFTA will dispatch a Product Support Manager to assist with the repair onsite. 4.After thorough diagnosis, and agreement between the dealer, MFTA and AWTEC that the transmission has an internal defect, the TSC will authorize installation of another AISIN transmission assembly. |
|---|---|
| TT194 | 2020-01-24. Service bulletin. This is a service newsletter (Tech Talk) that was sent out to dealers. |
| TT195 | 2020-01-24. Service bulletin. This is a service newsletter (Tech Talk) that was sent out to dealers. |
| TT191 | 2020-01-24. Service bulletin. This is a service newsletter (Tech Talk) that was sent out to dealers. |
| TT218 | 2020-01-24. Service bulletin. This is a service newsletter (Tech Talk) that was sent out to dealers. |
| TT217 | 2020-01-24. Service bulletin. This is a service newsletter (Tech Talk) that was sent out to dealers. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.