Transport Canada recall 2003133
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2003133 |
| Reported | 2003-05-20 |
| Component | Label |
| Notification type | Compliance Mfr |
| Units potentially affected | 940 |
What is wrong
On certain vehicles, the symbol embossed on the tether anchor cover is 2 millimetres smaller than required under CMVSS 210.1(4). These covers have been embossed with the label with a vertical dimension of 18 mm instead of the required 20 mm. Although the symbol is slightly smaller than is required, it is still large enough that it is easily recognized on the cover. The anchor locations are also clearly identified in the owner's manual. No corrective action required.
| 2003 INFINITI FX35 | |
|---|---|
| 2003 INFINITI FX45 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| Infiniti General | 2020-12-08. Service bulletin. INFINITI Owner Letter |
|---|---|
| ITB18-003 | 2018-02-21. Service bulletin. REDUCED VEHICLE LOAD CAPACITY LABEL (REGULATORY REQUIREMENT) This bulletin applies to vehicles equipped with dealer installed or VPC installed accessories. SERVICE INFORMATION The National Highway Traffic Safety Administration (NHTSA) requires that any automobile dealer that installs accessories on a vehicle prior to first retail sale must install a special label (?reduced capacity label?) on that vehicle if the total weight of all accessories on that vehicle exceeds 1.5 percent of the vehicle?s gross vehicle weight rating (GVWR) or 100 pounds, whichever is less. This includes accessories that the dealer installs (dealer installed factory accessories and dealer installed aftermarket accessories), and accessories installed at the Vehicle Processing Center (VPC) prior to the vehicle being delivered to the dealer. IMPORTANT: Failure to comply with this requirement may result in penalties imposed by NHTSA. Follow the instructions in this bulletin to help meet these requirements. |
| ITB-09-062 | 2010-04-09. Service bulletin. INFINITI: VENT CONTROL VALVE REPLACEMENT. NO APPLIED VEHICLES AFFECTED: ALL MODELS; NO MODEL YEARS LISTED. *PE |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.