Transport Canada recall 2003088
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2003088 |
| Manufacturer's number | RE03/02 |
| Reported | 2003-03-31 |
| Component | Brakes |
| Notification type | Safety Mfr |
| Units potentially affected | 3 |
What is wrong
On certain vehicles, the flexible hose carrying central hydraulic system (CHS) fluid between the regulator and the accumulator could leak. Leaking CHS fluid could deplete the reservoir and in an extreme case, cause a loss of power assist to the steering and brake systems. Correction: Dealer will replace the CHS fluid hose.
| 2003 BENTLEY ARNAGE R | Listed as a series or trim of this model. |
|---|---|
| 2003 BENTLEY ARNAGE RL | Listed as a series or trim of this model. |
| 2003 BENTLEY ARNAGE T | Listed as a series or trim of this model. |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 2052785/4 | 2020-01-09. Service bulletin. Condition: Customer statement: Noise complaint from the braking system. Workshop findings: The noise can be reproduced and clearly assigned to the braking system. Technical Background Brake noises can be attributed to many causes. Eight of the most common causes are: 1. Brake discs or pads are close to their wear limit. 2. New brake pads and/or discs have not been properly bedded in after installation. 3. Aftermarket pads or discs are installed. 4. There is debris such as small stones, grit, road salt or sand between the brake disc and pad. 5. Discs are covered in rust. Rust can form when the vehicle has been stationary for long periods of time (Figure 1). 6. Discs have a groove in them (Figure 2) 7. There is chemical contamination on the braking surface of the disc due to a wheel or tyre cleaner being sprayed directly onto the disc (Figure 3). 8. There are pad marks on the brake disc as a result of the brake pad material transferring to the discs. This can occur when a vehicle has been stood for long periods of time in a wet or snowy environment (Figure 4). |
|---|---|
| 2052785.3 | 2019-07-01. Service bulletin. Brake noise identification |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.