Transport Canada recall 2000113
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2000113 |
| Manufacturer's number | R24 |
| Reported | 2000-04-28 |
| Component | Visual System |
| Notification type | Safety Mfr |
| Units potentially affected | 4830 |
What is wrong
Certain vehicles have an insufficient amount of lubrication between the windshield wiper motor drive arm pivot and the wiper linkage dust cover that may bind and cause the wiper linkage to separate from the windshield wiper motor. If this occurs the windshield wiper motor will still operate but the windshield wipers will not function. This condition can result in reduced driver visibility during inclement weather and a possible crash. Correction: Dealers will replace the rubber boot (dust cover) which covers the ball joint connection and lubricate the new boot where it contacts the wiper arm.
| 2000 HYUNDAI ACCENT |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 24-BD-001H | 2024-03-05. Service bulletin. This bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models. If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades. |
|---|---|
| 23-BD-002H | 2023-02-02. Service bulletin. This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.