NHTSA recall 96V089002
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 96V089002 |
| Manufacturer | NISSAN NORTH AMERICA, INC. |
| Reported | 1996-06-04 |
| Owners notified | 1996-07-10 |
| Component | SEATS |
| Units potentially affected | 2000 |
What is wrong
AN OUT-OF-SPECIFICATION CONDITION IN THE SEAT CABLE ROLLER PULLEY ASSEMBLY CAN ALLOW THE CABLE THAT CONNECTS THE SEAT ADJUST LEVER TO THE LATCH TO BE PINCHED IN THE ROLLER ASSEMBLY.
What can happen
CONSEQUENCE OF NON-COMPLIANCE: THIS CONDITION CAN PREVENT THE LATCH ON THE LEFT SIDE FROM FULLY ENGAGING THE SEAT RAIL. THIS DOES NOT COMPLY WITH THE REQUIREMENT OF FMVSS NO. 207, "SEATING SYSTEMS."
The remedy
DEALERS WILL REPLACE THE PULLER ASSEMBLY IN THE THIRD ROW SLIDING BENCH SEAT LATCH ASSEMBLY.
Notes
SYSTEM: INTERIOR; SEATS; BENCH; FMVSS NO. 207. VEHICLE DESCRIPTION: PASSENGER MINI-VANS EQUIPPED WITH SLIDING THIRD ROW BENCH SEATS. NOTE: OWNER NOTIFICATION IS EXPECTED TO BEGIN DURING JULY 1996. NOTE: OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME, SHOULD CONTACT NISSAN AT 1-800-647-7261. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
| 1995 NISSAN QUEST | Built 1995-07-01 to 1995-08-01. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| NTB95108 | 1996-04-25. Service bulletin. IF AN OWNER OF A 1993 - 1995 QUEST (V40) VEHICLE COMPLAINS OF A RATTLE OR SQUEAK APPEARING TO ORIGINATE FROM THE UNOCCUPIED CENTER BENCH OR BUCKET SEAT AREA WHILE DRIVING THE VEHICLE, REPLACEMENT OF THE GROMMET IN THE REAR FLOOR ANCHOR HOOK AMD MODIFICATION OF THE FRONT LATCH MOUNTING HOLES IS RECOMMENDED. WITH THE HOLES MODIFIED, THE FRONT LATCHES CAN BE ADJUSTED USING THE FOLLOWING DETAILED INSTRUCTIONS. |
|---|
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.