NHTSA recall 91V204000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 91V204000 |
| Manufacturer | GENERAL MOTORS CORP. |
| Reported | 1991-11-19 |
| Component | SUSPENSION:REAR |
| Units potentially affected | 272 |
What is wrong
THE BOLTS AND NUTS WHICH ATTACH THE BEARING-HUB ASSEMBLY TO THE REAR AXLE FLANGE ARE NOT SUFFICIENTLY TIGHTENED ON SOME VEHICLES.
What can happen
THIS WOULD ALLOW EXCESSIVE MOVEMENT OF THE BEARING-HUBASSEMBLY RELATIVE TO THE REAR AXLE FLANGE AND COULD CAUSE ELONGATION ANDEVENTUAL SEPARATION OF THE ATTACHING BOLTS FROM THE REAR AXLE FLANGE. IF THISWERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, THE AFFECTED TIRE AND WHEEL COULDTRACK ERRATICALLY, EVENTUALLY CAUSING FAILURE OF THE OTHER ATTACHING BOLTS. THETIRE AND WHEEL ASSEMBLY COULD SEPARATE FROM THE VEHICLE WHICH COULD RESULT IN AVEHICLE ACCIDENT.
The remedy
TIGHTEN REAR AXLE BEARING-HUB ASSEMBLY FASTENERS, AND REPLACE ALL THE FASTENERS ON A WHEEL IF TWO OR MORE BOLTS ARE FOUND TO BE LOOSE.
Notes
SYSTEM: REAR AXLE.VEHICLE DESCRIPTION: PASSENGER CARS.NOTE: GENERAL MOTORS REPORTS THAT ALL SUBJECT VEHICLES WERE HELD AND REPAIREDBEFORE ANY OWNER TOOK POSSESSION, SO THERE WILL BE NO OWNER NOTIFICATION.
| 1992 PONTIAC GRAND AM | Built 1991-07-01 to 1991-07-01. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.