WenmarOpen by Wenmar Pro

NHTSA recall 26V418000

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byNHTSA (United States)
Campaign number26V418000
Manufacturer's number26C32
ManufacturerFord Motor Company
Reported2026-06-30
Owners notified2026-08-11
ComponentVISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR
Units potentially affected67842
Part numbersFR3B-17504-A*

What is wrong

Ford Motor Company (Ford) is recalling certain 2024-2026 Mustang and 2025-2026 Mustang GTD vehicles. During certain cold temperature conditions, the windshield wipers may function only at their high-speed setting and the washing system may fail to function properly.

What can happen

Windshield wipers or a washing system that fails to function as intended can reduce visibility, increasing the risk of a crash.

The remedy

Dealers will inspect and replace the wiper motor as necessary, free of charge. Owner notification letters were mailed August 11, 2026. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 26C32. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on July 2, 2026.

Vehicles this campaign lists
2024 FORD MUSTANGBuilt from 2024-09-18.
2025 FORD MUSTANG
2026 FORD MUSTANGBuilt to 2026-02-02.
2025 FORD MUSTANG GTD
2026 FORD MUSTANG GTD

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
SSM 550612026-08-04. Service bulletin. Some 2024-2026 Mustang vehicles built on or before 23-Apr-2026 may exhibit a sagging headliner appearance at the door openings which show the raw headliner edge untucked from the door glass run. An updated door glass run has been released for service (Left Side:PR3Z-6321597-B, Right side:PR3Z-6321596-B). Refer to Workshop Manual, Section 501-05.
SSM 550082026-07-20. Service bulletin. Some 2021-2026 Ford vehicles may exhibit inoperative heated/cooled seats, heated steering wheel and/or front/rear defrost features after a remote start is performed through the Ford mobile application or with the key fob. Customers may also experience heated/cooled seats, heated steering wheel and/or front/rear defrost features turning on in unexpected conditions such as during warmer weather. These features will operate normally when commanded in the center display screen. This may be due to the customer not setting up their "Climate Settings" through the Ford mobile application. To correct this condition, inform the customer they should perform a remote start from the Ford mobile application and then adjust the "Climate Settings" in the Ford mobile application as desired. These settings only need to be set once and will persist through subsequent remote starts. Heated and cooled seats will be set to Level 2 when turned ON via "Climate Settings" in the Ford mobile application during a remote start event. This is normal operating characteristic. This condition does not affect vehicle durability and no a
TSB 25-23862025-09-03. Service bulletin. Some of the vehicles listed in the Model Statement above may exhibit a quarter glass rubber moulding that is rolled over or folded in. This may be due to the installation of the quarter glass assembly.
SSM 540672025-07-30. Service bulletin. For 2018-2024 Edge and 2018-2025 Mustang vehicles, if diagnostics lead to the sun visor as the causal part, a new lower level part is available (DS7Z-9904132-A). It is not necessary to replace the sun visor assembly if only the clip is damaged.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially