WenmarOpen by Wenmar Pro

NHTSA recall 24V538000

NHTSA advises: park outside, away from buildings, until the repair is done.

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byNHTSA (United States)
Campaign number24V538000
Manufacturer's number72B
ManufacturerChrysler (FCA US, LLC)
Reported2024-07-18
Owners notified2025-03-06
ComponentHYBRID PROPULSION SYSTEM
Units potentially affected3606
Part numbersSee attached document referenced above for Chrysler Pacifica PHEV battery pack assembly part numbers
Remedy progress the manufacturer reported
ReportQuarterly report 6, for 2026 quarter 2
Filed with NHTSA2026-07-16
Vehicles in the campaign3606
Reported remedied2632 (72%)
Reported unreachable39
Reported removed199

These are the manufacturer's totals for the whole campaign at the end of 2026 quarter 2, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.

What is wrong

Chrysler (FCA US, LLC) is recalling certain 2019-2021 Pacifica Plug-In Hybrid Electric (PHEV) vehicles. The battery pack may cause a vehicle fire when parked, even with the ignition in the "Off" position.

What can happen

A vehicle fire increases the risk of injury.

The remedy

Owners are advised not to charge their vehicles, and to park outside and away from structures, until they are repaired. Dealers will update the high voltage battery pack control module (BPCM) software. In addition, dealers will inspect and if necessary, replace the battery pack assembly. Repairs will be performed free of charge. Owner notification letters were mailed March 6, 2025. Owners may contact FCA US LLC customer service at 1-800-853-1403. FCA US LLC's number for this recall is 72B. This recall is an expansion of NHTSA recall number 22V-077.

Notes

Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.nhtsa.gov.

Vehicles this campaign lists
2019 CHRYSLER PACIFICA PLUG-IN HYBRIDListed as a series or trim of this model.
2020 CHRYSLER PACIFICA PLUG-IN HYBRIDListed as a series or trim of this model.
2021 CHRYSLER PACIFICA PLUG-IN HYBRIDListed as a series or trim of this model.

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
S20080000312023-10-02. Service bulletin. Low Charging Voltage Displayed On Cluster
Z762023-01-17. Service bulletin. Electric Vehicle Mode Unavailable
S22080000112023-01-09. Service bulletin. Wireless Qi Charger Not Charging
08052222022-10-17. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates This bulletin involves reprogramming the HCP and AHCP or also known as Power InverterModule (PIM) with the latest available software. Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear.As a result, the vehicles are not eligible to be registered in certain states. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technicianmay find one or more of the following DTCs have been set: P0A33 - Drive Motor B Temperature Sensor 1 Circuit High. P0A2D - Sensor Power Supply 1 Circuit High. P215B - Vehicle Speed Output Shaft Speed Correlation. P0C4A - Drive Motor A Inverter Over Temperature. P0E15 - Hybrid-Ev Battery Pack Coolant Heater A Control Performance. P1AFE - MCPB Improper Shut Down. P1AF8 - MCPA Control Module Shutdown Performance. P0513 - Invalid Skim Key. U151A-87 - Hybrid Control Processor Secret Code-Missing Message. Customers may also experience more or more of the following: The scheduled charging does not occur on desired schedule. Vehicle does not start when pushing ignition switch with no MIL for DTCs P1AFE and P1AF8 (pending DTCs). Vehicle does not start when pushing ignition switch with DTCs P0513 and U151-A87 (stored or active). Scheduled charging start/end does not align with displayed time (ex: 12:05 pm end time on radio, but charging ends at 12:06 pm). Scheduled charging does not start following a power outage. Scheduled Cabin Conditioning (SCC) feature will not function properly if they schedule the departure time in between 50 minutes to 480 minutesat extreme cold ambient temps below -24 °C (-11 °F). ?Charge Now? soft button does not always work. The vehicle will get a rough engine spin-down, and then ?Service Charging System? warning and shutdown if the vehicle is quicklyre-cranked after the initial key crank.
S20080001192022-09-26. Service bulletin. Service Hybrid Electrical System Displayed. DTC?s P0CF1, P1B71-00, Or B12B0-00 Set. Water Intrusion Of The XY291A Inline Connector
90045522022-09-26. Service bulletin. Battery Coolant Level Sensor, Battery Coolant Bottle Pacfica Hybrid only - If customer comes into dealership with a "Service Hybrid System" message on cluster AND scan / WiTech report shows evidence of a P2BE0-00 fault code, please contact the following individual prior to servicing the vehicle: P2BE0-00 - HYBRID/EV BATTERY COOLANT LEVEL FCA Redacted Content If possible, please capture a picture of the coolant level on battery bottle before replacing any components in the area (sensor, bottle, etc.). Requesting picture be attached to claim information. If no response within 15 minutes, proceed with repair.
08-129-212022-08-22. Service bulletin. Flash: Battery Pack Control Module (BPCM) Diagnostic and System Updates This bulletin involves updating the BPCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may notice one or more of the following DTCs have been set: P0AA1-00 - Hybrid/EV Battery Positive Contactor ?A? Stuck Closed. P0AA4-00 - Hybrid Battery Negative Contactor Circuit Stuck Closed. P0C78-00 - Hybrid/EV Battery System Precharge Time Too Long. P0B3C-00 - Hybrid/EV Battery Voltage Sense 1 Circuit Performance. P0B41-00 - Hybrid/EV Battery Voltage Sense 2 Circuit Performance. P0B46-00 - Hybrid/EV Battery Voltage Sense 3 Circuit Performance. P0B4B-00 - Hybrid/EV Battery Voltage Sense 4 Circuit Performance. P0B50-00 - Hybrid/EV Battery Voltage Sense 5 Circuit Performance. P0B55-00 - Hybrid/EV Battery Voltage Sense 6 Circuit Performance. P1A16-00 - Hybrid/EV Wakeup Control 3 Output Circuit/Open. P1D7B-00 - Hybrid/EV Wakeup Control 3 Output Circuit Short to Battery. P1D7C-00 - Hybrid/EV Wakeup Control 3 Output Circuit Short to Ground. P1A29-00 - Cell Supervisory Circuit A Failure. P1A2A-00 - Cell Supervisory Circuit B Failure. Customer may also experience one or more of the following:Premature oil change message displayed on the cluster and vehicle may be running in fuel/oil refresh mode. Scheduled charging not functioning properly because the battery pack did not wake up while plugged in.
08-115-222022-06-27. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates This bulletin involves reprogramming the HCP and AHCP or also known as Power Inverter Module (PIM) with the latest available software. Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. Customers may also experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P1AF8-00 - MCPA Control Module Shutdown Performance. P1AFE-00 - MCPB Improper Shut Down.P1AF8-00&P1AFE-00 will now be set as a 1 trip failure instead of a 2 trip failure. P07B5-00 - Park Pawl Position Sensor 1 Circuit Performance. P177C-00 - Park Lock-Pawl Actuator Motor Current Sensor Performance. P0A46-00 - Drive Motor B Position Sensor 1 Circuit Range-Performance. P0A40-00 - Drive Motor A Position Sensor 1 Circuit Range-Performance. This software release includes the following software enhancement:12V battery overcharged prevention. Corrected fuel consumption counter while in charge depleting. Corrections to allow the vehicle to clear the permanent fault codes. Three modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this HCP and AHCP update:Electronic Brake Booster Module (EBBM) Powertrain Control Module (PCM)
08-114-222022-06-27. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates This bulletin involves reprogramming the HCP and AHCP or also known as Power Inverter Module (PIM) with the latest available software. Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. Customers may also experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P1AF8-00 - MCPA Control Module Shutdown Performance. P1AFE-00 - MCPB Improper Shut Down.P1AF8-00&P1AFE-00 will now be set as a 1 trip failure instead of a 2 trip failure. P07B5-00 - Park Pawl Position Sensor 1 Circuit Performance. P177C-00 - Park Lock-Pawl Actuator Motor Current Sensor Performance. P0A46-00 - Drive Motor B Position Sensor 1 Circuit Range-Performance. P0A40-00 - Drive Motor A Position Sensor 1 Circuit Range-Performance. P2797-00 - Auxiliary Transmission Fluid Pump Performance. P0CF3-00 - Control Pilot Circuit Open. P0A44 - Drive Motor A Position Sensor 1 Circuit Overspeed. U0111-00 - Lost Communication With Battery Energy Control Module (BPCM). P1625-00 - Park Pawl System Failure. U0412-00 - Invalid Data Received From Battery Energy Control Module-A. P215B-00 - Vehicle Speed Output Shaft Speed Correlation. P079A-00 - Transmission Friction Element 1 Slip Detected. P079B-00 - Transmission Friction Element 2 Slip Detected. Customers may also comment:Vehicle will not start when temperature is -30° C (-22° F) and below. Heard and/or felt bump when the gas engine turns on while driving. Vehicle will not charge beyond 98%. "Service Charging System" and "Traction Battery Cutoff" warning messages appear during a key cycle event at -7° C (+20°F). Vehicle will force to Park when keyed off in Neutral if the door is open
08-177-212021-12-13. Service bulletin. BEV/Hybrid - Showroom and Display Vehicle Battery Maintenance This information only bulletin discusses procedures that must be followed for BEV/Hybrid vehicles that are on display at dealership showrooms.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially