NHTSA recall 22V056000
NHTSA advises: park outside, away from buildings, until the repair is done.
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 22V056000 |
| Manufacturer's number | 218 |
| Manufacturer | Hyundai Motor America |
| Reported | 2022-02-03 |
| Owners notified | 2022-05-31 |
| Component | SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE |
| Units potentially affected | 357348 |
| Part numbers | 58920-4Z300, 58920-B8AC0, 58920-2S820 |
| Report | Annual report 2, for 2025 quarter 2 to 2026 quarter 1 |
|---|---|
| Filed with NHTSA | 2026-04-27 |
| Vehicles in the campaign | 357348 |
| Reported remedied | 254367 (71%) |
| Reported unreachable | 2770 |
| Reported removed | 29255 |
These are the manufacturer's totals for the whole campaign at the end of 2026 quarter 1, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.
What is wrong
Hyundai Motor America (Hyundai) is recalling certain 2016-2018 Santa Fe, 2017-2018 Santa Fe Sport, 2019 Santa Fe XL, and 2014-2015 Tucson vehicles. The Anti-Lock Brake System (ABS) module could malfunction and cause an electrical short, which could result in an engine compartment fire.
What can happen
An engine compartment fire while parked or driving can increase the risk of injury.
The remedy
Owners are advised to park outside and away from structures until the recall repair is complete. Dealers will replace the ABS multi-fuse, as necessary, free of charge. Owner notification letters were mailed May 31, 2022. Owners may contact Hyundai customer service at 1-855-371-9460. Hyundai's number for this recall is 218.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.nhtsa.gov.
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 20-AT-012H | 2020-04-07. Service bulletin. If you are servicing an applicable vehicle with a (Check Engine Light on) and one or more of the DTC listed below, follow the repair procedure and replace the input/output speed sensor and oil pressure harness. |
|---|---|
| 20-AT-011H | 2020-04-07. Service bulletin. If you are servicing an applicable vehicle with a “Check Engine” light on and one or more of the DTC listed below, follow the repair procedure and replace the related solenoid and oil pressure harness. |
| 19-BR-001H-1 | 2019-08-19. Service bulletin. This bulletin provides information on the rear wheel speed sensor for Santa Fe (CM), Santa Fe / XL (NC), Santa Fe Sport (AN), and Veracruz (EN) vehicles equipped with front wheel drive (FWD). The rear wheel speed sensor is available as a separate service part from the rear wheel hub assembly. When appropriate, it is recommended to replace only the rear wheel speed sensor instead of the full assembly. |
| 19-BR-001H(1) | 2019-07-29. Service bulletin. This bulletin provides information on the rear wheel speed sensor for Santa Fe (CM), Santa Fe / XL (NC), Santa Fe Sport (AN), and Veracruz (EN) vehicles equipped with front wheel drive (FWD). The rear wheel speed sensor is available as a separate service part from the rear wheel hub assembly. When appropriate, it is recommended to replace only the rear wheel speed sensor instead of the full assembly. |
| 5NP-L2J7D-04 | 2017-08-10. Service bulletin. If the rear wheel hub in the affected vehicles is submerged in salt water, salt water can enter the rear wheel speed sensor housing and may interrupt the rear wheel speed sensor signal and temporarily illuminate the ABS and/or ESC warning lights in the instrument cluster until the sensor dries. For these cases, replacement of the wheel speed sensor cap is required. If no ABS/ESC warning lamp is illuminated, applying a silicone spray to the sensor is required. This bulletin describes the service procedure for the rear wheel speed sensors. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.