WenmarOpen by Wenmar Pro

NHTSA recall 21V861000

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byNHTSA (United States)
Campaign number21V861000
ManufacturerIsuzu Technical Center of America, Inc.
Reported2021-11-05
Owners notified2022-02-28
ComponentSTEERING:CRITICAL FASTENERS; STEERING
Units potentially affected5700
Part numbers8983956790
Remedy progress the manufacturer reported
ReportAnnual report 2, for 2025 quarter 1 to 2025 quarter 4
Filed with NHTSA2026-01-22
Vehicles in the campaign5700
Reported remedied4400 (77%)
Reported unreachable0
Reported removed0

These are the manufacturer's totals for the whole campaign at the end of 2025 quarter 4, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.

What is wrong

Isuzu Technical Center of America, Inc. (Isuzu) is recalling certain 2018-2021 Isuzu FTR and 2018-2021 Chevrolet 6500XD vehicles. A bolt on the left front steering knuckle may come loose, resulting in an increased turning radius and difficulty steering to the left.

What can happen

An unexpected change in turning radius and difficulty steering can increase the risk of a crash.

The remedy

Dealers will replace both right and left side stopper bolt jam nuts and clean or replace the extensions, as necessary, free of charge. Owner notification letters were mailed on February 28, 2022. Owners may contact Isuzu customer service at 1-866-441-9638. This recall is an expansion of recall 19V-467. Vehicles previously repaired will need to have the new remedy performed.

Notes

Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.nhtsa.gov.

Vehicles this campaign lists
2018 CHEVROLET 6500XD
2019 CHEVROLET 6500XD
2020 CHEVROLET 6500XD
2021 CHEVROLET 6500XD
2018 ISUZU FTR
2019 ISUZU FTR
2020 ISUZU FTR
2021 ISUZU FTR

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
CB22-E-001A2022-11-01. Service bulletin. Isuzu Motors Limited has decided that a defect, which relates to motor vehicle safety, exists in 2018, 2019, 2020 and 2021 model year F-Series vehicles. The jam nut for the steering stopper bolt on the left side may loosen and allow the bolt to back away from the steering knuckle. This could result in an increase in the turning radius of the vehicle in left turns, which could make it difficult to make sharp turns. If the vehicle's turning radius is increased, there is an increased risk of a crash. A prior recall (19V-467) was conducted to address this issue, but we have identified this condition on vehicles that were remedied in that campaign as well as those that were produced after a change in production intended to prevent the condition.
16NA1092021-05-03. Service bulletin. This service bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially