NHTSA recall 19V403000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 19V403000 |
| Manufacturer's number | 3419E |
| Manufacturer | Mazda North American Operations |
| Reported | 2019-05-30 |
| Owners notified | 2019-07-26 |
| Component | ELECTRICAL SYSTEM:WIRING |
| Units potentially affected | 7854 |
| Report | Quarterly report 6, for 2020 quarter 4 |
|---|---|
| Filed with NHTSA | 2021-01-24 |
| Vehicles in the campaign | 7854 |
| Reported remedied | 6882 (87%) |
| Reported unreachable | 0 |
| Reported removed | 0 |
These are the manufacturer's totals for the whole campaign at the end of 2020 quarter 4, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.
What is wrong
Mazda North American Operations (Mazda) is recalling certain 2018 CX-9 vehicles. The wiring harness may disrupt electrical communications and disable the passenger frontal air bag, turn signals, and/or engine starting system.
What can happen
The passenger frontal air bag may not deploy, increasing the risk of injury. Inoperable turn signals prevent the driver from signaling to other drivers, increasing the risk of crash.
The remedy
Mazda will notify owners, and dealers will repair the wiring harnesses, free of charge. The recall began July 26, 2019. Owners may contact Mazda customer service at 1-800-222-5500, Option 4. Mazda's number for this recall is 3419E.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
| 2018 MAZDA CX-9 | Built 2017-09-12 to 2017-11-09. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 07-001/22 | 2022-04-05. Service bulletin. Some vehicles may exhibit an unusual noise in the front A/C unit when the recirculate switch is operated. This is caused by a damaged gear in the air intake actuator. Dust and sand adhered to the grease at the air intake link may disturb the movement of the air intake actuator, resulting in the damaged gear. To eliminate this concern, grease application to the air intake link mechanism to the link pin has been reduced. |
|---|---|
| SA-024-20 | 2020-02-27. Service bulletin. If you encounter sputtering, surging or poor driveability with the following DTCs stored, inspect the MAP sensor connection for corroded terminals (as shown below). Recommend replacing the engine wire harness and MAP sensor. Refer to GEPC for applicable part numbers. |
| SA-067-17 | 2017-10-12. Service bulletin. Due to a change in the 2017 Mazda3, Mazda6 and 2018 CX-9 A-pillar wiring harness, the EC Mirror w/compass / EC Mirror w/compass + Homelink installation instructions have been updated. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.