NHTSA recall 15V568000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 15V568000 |
| Manufacturer's number | 132 |
| Manufacturer | Hyundai Motor America |
| Reported | 2015-09-10 |
| Owners notified | 2016-01-06 |
| Component | ENGINE |
| Units potentially affected | 470000 |
| Report | Quarterly report 6, for 2017 quarter 2 |
|---|---|
| Filed with NHTSA | 2017-07-24 |
| Vehicles in the campaign | 470000 |
| Reported remedied | 360388 (76%) |
| Reported unreachable | 10203 |
| Reported removed | 0 |
These are the manufacturer's totals for the whole campaign at the end of 2017 quarter 2, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.
What is wrong
Hyundai Motor America (Hyundai) is recalling certain model year 2011-2012 Sonata vehicles manufactured December 11, 2009, to April 12, 2012 at Hyundai Motor Manufacturing Alabama and equipped with either a 2.0 liter or 2.4 liter Gasoline Direct injection engine. In the affected vehicles, metallic debris may not have been fully removed during manufacturing of the engine crankshaft. If the debris was not completely removed, oil flow may be restricted through the connecting rod bearings, causing connecting rod damage. A worn connecting rod bearing will produce a metallic, cyclic knocking noise from the engine and possible engine failure.
What can happen
Engine failure would result in a vehicle stall, increasing the risk of a crash.
The remedy
Hyundai will notify owners, and dealers will inspect the vehicles and replace the engine assembly, as necessary, free of charge. Additionally, Hyundai Motor America will increase the warranty for the engine sub-assembly (short block) to 10 years/120,000 miles for both original and subsequent owners of 2011 and 2012 Sonatas manufactured at Hyundai Motor Manufacturing Alabama equipped with 2.0 liter and 2.4 liter Gasoline Direct injection engines. Interim notifications were mailed to owners starting on October 8, 2015. A second notification will be mailed when parts are available. Owners may contact Hyundai customer service at 1-855-671-3059 or by visiting www.HyundaiUSA.com/Campaign132. Hyundai's number for this recall is 132.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
| 2011 HYUNDAI SONATA | Built 2009-12-11 to 2012-04-12. |
|---|---|
| 2012 HYUNDAI SONATA | Built 2009-12-11 to 2012-04-12. |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 26-EM-016H TSB | 2026-10-14. Service bulletin. Some vehicles equipped with internal combustion engines may exhibit higher-than-expected engine oil consumption. This bulletin outlines the combustion chamber cleaning procedure for vehicles diagnosed with this condition. All internal combustion engines consume some engine oil during normal operation, depending on driving conditions and mileage, and this procedure should only be performed when deemed necessary based on inspection and diagnosis of the vehicle as outlined in TSB 26-EM-015H, Engine Oil Consumption – Inspection & Repair Guidelines, or the latest revision. |
|---|---|
| 26-EM-015H TSB | 2026-10-13. Service bulletin. Certain vehicles equipped with internal combustion engines may exhibit higher-than-expected engine oil consumption. This bulletin provides the inspection and repair procedures for vehicles exhibiting this condition. All internal combustion engines consume engine oil as part of normal engine operation. Oil consumption rates may vary based on mileage, operating conditions, driving habits, and maintenance history. Hyundai recommends following the prescribed maintenance schedule and periodically checking the engine oil level using the dipstick to maintain proper engine oil level. |
| 26-01-033H TSB | 2026-03-31. Warranty extension. This TSB references the Op codes to use for claim submission and the Parts required based on the vehicle’s inspection results from TSB 22-01-023H-2 (DTC P1326 – Engine Bearing Inspection/Engine Replacement) or the latest version. |
| 26-01-033H DN | 2026-03-30. Warranty extension. This TSB references the Op codes to use for claim submission and the Parts required based on the vehicle’s inspection results from TSB 22-01-023H (DTC P1326 – Engine Bearing Inspection/Engine Replacement) or the latest version. |
| 24-01-068H | 2024-09-03. Service campaign. Hyundai is conducting a campaign to enhance the knock sensor software to detect abnormal engine bearing noise before potentially severe engine damage occurs. If abnormal engine bearing noise is detected, the Malfunction Indicator Lamp (MIL) will blink continuously, and the vehicle will be placed in Engine Protection Mode allowing the customer to drive to the nearest Hyundai dealer for diagnosis and repair. In addition, DTC P132600 will be recorded in the ECM. The vehicle can continue to be operated for a limited time in Engine Protection Mode, but it will accelerate slower and have a reduced maximum speed. Engine RPMs will be limited to approximately 1800-2000 RPM. |
| 23-EM-005H | 2023-12-15. Service bulletin. This bulletin provides important checkpoint guidelines when performing engine oil and filter change services. |
| 22-01-023H-2 | 2023-08-02. Service bulletin. A class action lawsuit against Hyundai Motor America (“HMA”) alleges that certain Hyundai vehicles (“Class Vehicles”) were manufactured, marketed, sold, and/or leased with an engine defect that can result in sudden engine seizure, stalling, engine failure, and in some circumstances, engine fire, and that some owners and lessees of Class Vehicles have been improperly denied repairs under warranty. Neither HMA nor Hyundai Motor Company have been found liable for any of the claims alleged in the lawsuit. The parties have instead reached a voluntary settlement (the “Settlement”) to avoid lengthy litigation and to provide owners of Class Vehicles certain benefits. |
| 22-01-023H-2 | 2022-12-07. Service bulletin. Certain vehicles may experience the Check Engine warning lamp illuminated with DTC P1326 and/or engine may exhibit abnormal noise, or no crank/no start condition related to connecting rod bearing wear or damage. This Dealer Best Practice outlines the service process to inspect the vehicle and replace the engine or update the engine ECU software based on the inspection results, as well as related warranty coverage for the conditions outlined above. |
| 22-01-023H-2 | 2022-12-07. Service bulletin. Certain vehicles listed below may experience the Check Engine warning lamp illuminated with DTC P1326 and/or an engine concern/noise related to connecting rod bearing wear or damage. Follow the procedure to inspect the vehicle and replace the engine and/or update the engine ECU software (if new ROM is available) based on the inspection results. |
| 22-EM-006H-2 | 2022-12-07. Service bulletin. The warranty coverage for engine repair or replacement regarding engine damage or malfunction from connecting rod bearing wear has been extended to 15 years or 150,000 miles from the date of original retail delivery or date of first use, whichever occurs first, and is valid for original and subsequent owners. Commercial entities and individuals engaged in the buying, selling, leasing, or renting of motor vehicles, as well as salvaged vehicles, are ineligible for the extended warranty. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.