NHTSA recall 11V270000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 11V270000 |
| Manufacturer's number | 11149 |
| Manufacturer | GENERAL MOTORS LLC |
| Reported | 2011-05-06 |
| Owners notified | 2011-05-23 |
| Component | STEERING:GEAR BOX:SHAFT SECTOR |
| Units potentially affected | 128911 |
What is wrong
GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CHEVROLET CRUZE VEHICLES MANUFACTURED FROM OCTOBER 2, 2009, THROUGH APRIL 21, 2011. THE BOLT ATTACHING THE INTERMEDIATE STEERING SHAFT TO THE STEERING GEAR INPUT SHAFT MAY NOT HAVE BEEN PROPERLY INSTALLED.
What can happen
THIS COULD ALLOW THE SHAFTS TO SEPARATE, RESULTING IN THE LOSS OF STEERING. LOSS OF STEERING CONTROL MAY INCREASE THE RISK OF A CRASH.
The remedy
DEALERS WILL INSPECT, AND IF REQUIRED, REPAIR THE INTERMEDIATE SHAFT/STEERING GEAR ASSEMBLY TO ASSURE THE BOLT IS FULLY SEATED AND THE SHAFT PROPERLY ASSEMBLED. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 23, 2011. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, OR WWW.GMOWNERCENTER.COM.
Notes
GM'S SAFETY RECALL NO. 11149.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO <A HREF=HTTP://WWW.SAFERCAR.GOV>HTTP://WWW.SAFERCAR.GOV</A> .
| 2011 CHEVROLET CRUZE | Built 2009-10-02 to 2011-04-21. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| PIT5063D | 2017-08-15. Service bulletin. This Preliminary Information communication provides information to the technician with a diagnostic tip service steering message or service stability message. Technician may find a Diagnostic Trouble Code C056E Sym 42 and a Diagnostic Trouble Code C0569 Sym 3A setting after a new steering gear assembly was installed. If Diagnostic Trouble Code C0710 Sym 71 is set it must be addressed firth before performing a steering gear "set-up" in Service Programming System. Steering Angle Sensor module Diagnostic Trouble Code C056D Sym 00 and it must be address first. Technician should be advised that Diagnostic Trouble Codes DTC C056E Sym 42 or C0569 Sym 3A will set when a steering gear assembly was replaced without Service Programming System programming. |
|---|
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.