NHTSA recall 11V151000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 11V151000 |
| Manufacturer's number | 28G1/U8 |
| Manufacturer | VOLKSWAGEN OF AMERICA, INC |
| Reported | 2011-03-01 |
| Owners notified | 2011-06-15 |
| Component | ELECTRICAL SYSTEM:IGNITION:SWITCH |
| Units potentially affected | 12612 |
What is wrong
VOLKSWAGEN IS RECALLING CERTAIN MODEL YEAR 2010 ROUTAN VEHICLES MANUFACTURED FROM OCTOBER 2009 THROUGH JUNE 2010. SOME VEHICLES MAY EXPERIENCE INADVERTENT IGNITION KEY DISPLACEMENT FROM THE RUN TO ACCESSORY POSITION WHILE DRIVING CAUSING THE ENGINE TO SHUT OFF.
What can happen
AN ENGINE SHUTTING OFF SUDDENLY WHILE DRIVING COULD INCREASE THE RISK OF A CRASH.
The remedy
DEALERS WILL REPLACE THE WIN MODULE FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN DURING JUNE 2011. OWNERS MAY CONTACT VOLKSWAGEN AT 1-800-822-8987.
Notes
VOLKSWAGEN SAFETY RECALL NO. 28G1/U8.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO <A HREF=HTTP://WWW.SAFERCAR.GOV>HTTP://WWW.SAFERCAR.GOV</A> .
| 2010 VOLKSWAGEN ROUTAN | Built 2009-10-01 to 2010-06-30. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| TT961402 | 2024-04-08. Service bulletin. Vehicles equipped with Immobilizer 4 (Download) ? Adapting Keys after Vehicle Lock Set Replacement |
|---|---|
| TT641402 | 2023-07-31. Service bulletin. To detect which line(s) is inoperative, utilize a volt meter to check for 0 V, which will be present after the open in the grid line. The check must be performed with the engine running and heated rear window switched on. Switch OFF the ignition and visually locate the damage. Proceed with checking any other lines as necessary. Once the damaged line is identified, repair utilizing the Repair kit by Permatex® ITEM 09117. |
| TT571302 | 2023-07-17. Service bulletin. If key blade is found to stick or bind when opening or closing, check position of roll pin that secures key blade to mechanism. If roll pin is sticking out on either side (as shown below), do not replace key. Instead, use appropriate sized punch and hammer to drive in the roll pin so that it is flush with edge of mechanism. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.