NHTSA recall 03V240000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 03V240000 |
| Manufacturer | BAYERISCHE MOTOREN WERKE |
| Reported | 2003-07-01 |
| Owners notified | 2003-07-08 |
| Component | ENGINE AND ENGINE COOLING |
| Units potentially affected | 5470 |
What is wrong
ON CERTAIN PASSENGER VEHICLES, DUE TO A SOFTWARE ERROR, A DESYNCHRONIZATION OF THE VALVETRONIC MOTORS FOR ENGINE BANKS I AND II MAY OCCUR. IF THIS OCCURS, THE ENGINE COULD STALL.
What can happen
IN THOSE CASES, THE DRIVER MAY NOT BE ABLE TO RESTART THE ENGINE. DEPENDING ON THE LEVEL OF ENGINE ROUGHNESS, OR STALLING, AS WELL AS TRAFFIC CONDITIONS AND THE DRIVER'S REACTIONS, THIS COULD LEAD TO A CRASH.
The remedy
DEALERS WILL REPROGRAM THE DIGITAL ENGINE MANAGEMENT CONTROL UNIT. OWNER NOTIFICATION BEGAN JULY 8, 2003. OWNERS SHOULD CONTACT BMW AT 1-800-831-1117.
Notes
CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
| 2002 BMW 745I | Built 2001-10-24 to 2003-04-09. |
|---|---|
| 2003 BMW 745I | Built 2001-10-24 to 2003-04-09. |
| 2002 BMW 745LI | Built 2001-10-24 to 2003-04-09. |
| 2003 BMW 745LI | Built 2001-10-24 to 2003-04-09. |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| B160623 | 2024-01-03. Service bulletin. Engine will crank but not start. There is no communication with the integrated fuel module (TFE) whendiagnosing with ISTA. The following two fault codes will be stored in the DME: 032B43 - Low fuel pressure system, electric fuel pump: pressure value too low CDA594 - Message (- 0x33E) missing, receiver DME, transmitter TFE |
|---|---|
| B070314 | 2018-12-10. Service bulletin. This Service Information bulletin supersedes SI B07 03 14 dated October 2015. Diagnosing Stored Fault Codes to Help Avoid Repeat Repair Visits. Fault codes stored in vehicles being serviced are not being diagnosed, leading to repeat repair visits (source- Analysis of FASTA data and repeat repair visit reports). INFORMATION Where diagnosis (vehicle or short test) with ISTA has already started, it is important to diagnose the fault code(s) listed below (when they are stored in the vehicle) to find their root cause during the current workshop visit. This will help lead to a reduction in workshop repeat repair visits and higher customer satisfaction. |
| 120815 | 2018-11-13. Service bulletin. "SUBJECT N62TU: ISTA Service Function for DME ""RAM Backup"". The ISTA Service Function test plan should be performed to clear stored values in the DME RAM memory after repairs are completed, in the following situations: z VANOS or engine-related repairs if any of the following faults cannot be cleared: 2A90 - Exhaust camshaft, tooth offset to crankshaft 2A91 - Exhaust camshaft 2, tooth offset to crankshaft 2A8A - Inlet VANOS, adaptation stop 2A8B - Inlet VANOS, adaptation stop 2 2A8C - Exhaust VANOS, adaptation stop 2A8D - Exhaust VANOS, adaptation stop 2 2A8E - Inlet camshaft, tooth offset to crankshaft 2A8F - Inlet camshaft 2, tooth offset to crankshaft z The engine oil level display continues to show as overfilled even after being corrected. This is also described in SI B12 05 07." |
| 110107 | 2007-06-29. Service bulletin. CRANKCASE VENTILATION SYSTEM - COLD CLIMATE CONDITIONS. *KB UPDATED ON 10/17/07. *NJ UPDATED 6/15/09. *PE |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.