NHTSA recall 00V096000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 00V096000 |
| Manufacturer | HYUNDAI MOTOR COMPANY |
| Reported | 2000-03-28 |
| Owners notified | 2000-04-17 |
| Component | VISIBILITY:WINDSHIELD WIPER/WASHER:LINKAGES |
| Units potentially affected | 16264 |
What is wrong
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE PROTECTIVE RUBBER BOOT WHICH COVERS THE BALL JOINT CONNECTION BETWEEN THE WINDSHIELD WIPER MOTOR DRIVE ARM AND THE WINDSHIELD WIPER DRAG LINK CAN STICK TO THE SURFACE OF THE DRIVE ARM. IF THE RUBBER BOOT STICKS AND THE WIPER MOTOR IS TURNED ON, BINDING OF THE INTERFACE BETWEEN THE DRIVE ARM AND DRAG LINK RESULTS, CAUSING THE BALL JOINT CONNECTION TO DISENGAGE.
What can happen
IF THE CONNECTION DISENGAGES, THE WINDSHIELD WIPERS ARE INOPERATIVE. INOPERATIVE WINDSHIELD WIPERS CAN CONTRIBUTE TO REDUCED VISIBILITY DURING INCLEMENT WEATHER.
The remedy
DEALERS WILL REPLACE THE PROTECTIVE RUBBER BOOT AND WILL LUBRICATE THE NEW PROTECTIVE RUBBER BOOT WHERE IT CONTACTS THE DRIVE ARM.
Notes
OWNER NOTIFICATION BEGAN APRIL 17, 2000.OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HYUNDAI AT 1-800-633-5151.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
| 2000 HYUNDAI ACCENT | Built 1999-11-11 to 2000-01-15. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 24-BD-001H | 2024-03-05. Service bulletin. This bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models. If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades. |
|---|
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.