Service bulletins for the 2014 Toyota Tacoma
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
424 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Body and frame are shown. Show all
| ZKA_Region Email | 2019-10-15. Service bulletin. STRUCTURE. Region Email: Toyota has received a number of reports regarding vehicle frame corrosion perforation on certain 2011-2017 model year Tacoma vehicles. These reports have indicated that these vehicles, when operated in specific cold climate areas (Cold Climate States1) with high road salt usage, or exposed to other environmental factors, may exhibit more-than-normal corrosion to the vehicle?s frame. |
|---|---|
| T-SB-0035-19 | 2019-06-03. Service bulletin. STRUCTURE. TSB: SUPERSESSION NOTICE The information contained in this bulletin supersedes Service Bulletin No. T-SB-0223-17. ? The Parts Information section has been updated. Service Bulletin No. T-SB-0223-17 is obsolete and any printed versions should be discarded. Some 2012 ? 2015 model year Tacoma vehicles may exhibit rust spots on the B-pillar and/or C-pillar (double cab only) area on either or both driver and passenger sides. Repairing/repainting and installation of paint protective films in the affected areas will be required to address this condition. The paint repair may need to be sublet to a body shop. Share this Service Bulletin information with your sublet body shop. |
| T-SB-0223-17_Rev | 2018-12-17. Service bulletin. STRUCTURE. TSB: REVISION NOTICE November 13, 2018 Rev2: ? The Warranty Information section has been updated. September 20, 2017 Rev1: ? The Warranty Information section has been updated. Any previous printed versions of this bulletin should be discarded. Some 2012 ? 2015 model year Tacoma vehicles may exhibit rust spots on the B-pillar and/or C-pillar (double cab only) area on either or both driver and passenger sides. Repairing/repainting and installation of paint protective films in the affected areas will be required to address this condition. The paint repair may need to be sublet to a body shop. Share this Service Bulletin information with your sublet body shop. |
| T-SB-0044-16 | 2018-07-02. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE. TSB: On some vehicles, when Rapgard? is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0040-18 | 2018-06-18. Service bulletin. STRUCTURE:BODY:BUMPERS. TSB: Referencing this Service Bulletin provides best practice procedures when reassembling and installing the front shock absorber with coil spring. Some 2005 - 2015 model year Tacoma vehicles with applicable VDS have a different coil spring diameter. This may lead to a lateral force applied to the support plate upon reassembly of the front shock absorber with coil spring assembly. This may cause the inner rubber sleeve of the support plate to pull out when spring tension is released and the support plate to tilt. NOTE This Service Bulletin ONLY provides best practices for front shock absorber with coil spring assembly. The Repair Manual MUST be referenced with this bulletin when performing front shock absorber with coil spring assembly replacement. |
| T-SB-0044-16 | 2018-06-11. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard? is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0233-17_Rev | 2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; STRUCTURE. TSB: REVISION NOTICE September 20, 2017 Rev1: The Warranty Information section has been updated. Any previous printed versions of this bulletin should be discarded. Some 2012 ? 2015 model year Tacoma vehicles may exhibit rust spots on the B-pillar and/or C-pillar (double cab only) area on either or both driver and passenger side. Repairing/repainting and installation of paint protective films in the affected areas will be required to address this condition. The paint repair may need to be sublet to a body shop. Share this Service Bulletin information with your sublet body shop. |
| T-SB-0223-17 | 2018-04-02. Service bulletin. STRUCTURE. TSB: Some 2012 ? 2015 model year Tacoma vehicles may exhibit rust spots on the B-pillar and/or C-pillar (double cab only) area on either or both driver and passenger side. Repairing/repainting and installation of paint protective films in the affected areas will be required to address this condition. The paint repair may need to be sublet to a body shop. NOTE: If this condition is present in AT LEAST 1 door, ALL doors MUST receive paint protective film. |
| T-SB-0044-16_Rev | 2018-04-02. Service bulletin. STRUCTURE:BODY. TSB: REVISION NOTICE March 07, 2017 Rev1: ? Applicability has been updated to include 2017 model year Toyota vehicles. On some vehicles, when Rapgard? is removed the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is NOT necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0170-16_Rev | 2018-04-02. Service bulletin. STRUCTURE. TSB: REVISION NOTICE January 22, 2018 Rev1: ? Applicability has been updated to include 2016 - 2017 model year Tacoma vehicles. ? The Warranty Information, Parts Information, and Repair Procedure sections have been updated. Any previous printed versions of this bulletin should be discarded. Some 2012 - 2017 model year Tacoma vehicles may exhibit a reed/buzz type wind noise from the LH and/or RH front door when driving in high cross-wind areas. Follow the Repair Procedure in this bulletin to address this condition. |
| T-SB-0304-17 | 2017-11-14. Service bulletin. STRUCTURE:BODY:DOOR. TSB: Vehicle replacement certification labels (the vinyl label installed on the driver door or door post) and VIN plates (the metal plate riveted to dashboard) may be available from Toyota, provided the request meets one of the criteria listed in this Service Bulletin. |
| SET-TSB-15-011 | 2017-08-25. Service bulletin. STRUCTURE:BODY:TAILGATE. Dicusses the Updates to Southeast Toyota Accessory Locking Tailgate handle. |
| T-SB-0044-15 | 2017-08-14. Service bulletin. STRUCTURE:BODY:ROOF AND PILLARS; STRUCTURE:BODY. TSB: Some 2011 - 2014 model year Tacoma vehicles may exhibit a condition where the Roof Side Finish Molding on the right hand and/or left hand side of the vehicle becomes loose. Follow the Repair Procedure in this bulletin to address this condition. |
| T-SB-0040-08 | 2017-08-14. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0040-08 | 2017-08-14. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0044-15 | 2017-08-14. Service bulletin. STRUCTURE:BODY:ROOF AND PILLARS. TSB: Some 2011 - 2014 model year Tacoma vehicles may exhibit a condition where the Roof Side Finish Molding on the right hand and/or left hand side of the vehicle becomes loose. Follow the Repair Procedure in this bulletin to address this condition. |
| ER11_Re-Notifica | 2017-08-01. Service bulletin. SUSPENSION:FRONT:CONTROL ARM:LOWER ARM; EQUIPMENT; STRUCTURE:BODY:DOOR; ELECTRICAL SYSTEM. Region Letter: Safety Recall completion is important not only in satisfying government requirements but also is an integral part of our commitment to meet customer expectations of Toyota products. Toyota will be sending Safety Recall Follow-Up Notices to remind owners whose vehicles have not yet had campaign repairs completed. We request your assistance in completing the applicable campaign repairs as owners receive the Follow-Up Notice and contact your dealership. Please note the follow-up activity may cause an increase in your current campaign owner appointments. Toyota will continue with additional follow-up activities in the months to come. Please take this into consideration when analyzing your manpower requirements. |
| ER11_Re-Notifica | 2017-08-01. Service bulletin. SUSPENSION:FRONT:CONTROL ARM:LOWER ARM; STRUCTURE:BODY:DOOR; EQUIPMENT; ELECTRICAL SYSTEM. Region Letter: Toyota will be sending Safety Recall Follow-Up Notices to remind owners whose vehicles have not yet had campaign repairs completed. Please note the following information for Regional and PD associates. |
| T-TT-0246-13 | 2016-04-12. Service bulletin. STRUCTURE:EMERGENCY:ESCAPE/EGRESS/EXIT. SUMMARY TO BE PROVIDED ON A FUTURE DATE. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.