WenmarOpen by Wenmar Pro

Service bulletins for the 2013 Toyota Tacoma

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

429 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
T-SB-0026-12 Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Use the following procedures to check and/or update the software version of Entune/Navigation for Non-HDD Type Units.
T-SB-0030-12 Rev2018-04-23. Service bulletin. EQUIPMENT:ELECTRICAL. Vehicles equipped with a Display Audio Navigation System and Entune (version less than 2.1.0) may exhibit one or more of the following conditions.
T-SB-0015-12 Rev2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Some 2013 model year vehicles are equipped with a Smart Key system, which allows the customer to enter and start the vehicle without using a mechanical key. To ensure the system is operating properly, the Smart Key functions (Smart Entry and Smart Start) should be inspected during Pre-Delivery Service (PDS). The following inspection procedure has been developed to confirm the proper operation of the Smart Key system prior to vehicle delivery.
T-SB-0024-12 Rev2018-04-23. Service bulletin. EQUIPMENT. 2013 model year vehicles are equipped with driver?s side floor mat retaining clips to secure the floor mat in the correct position. In addition, some models may utilize retaining clips for passenger side and rear seat floor mats as well. Follow the appropriate installation procedure to attach the driver?s side, and if applicable, the passenger?s side and rear seat floor mats to the vehicle carpet using the floor mat retaining clips during Pre-Delivery Service (PDS).
T-SB-0020-12 Rev2018-04-23. Service bulletin. TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS. The purpose of this bulletin is to provide a procedure to adjust tire pressure correctly when outside temperature is significantly colder or warmer than shop temperature. Seasonal temperature change can dramatically alter tire pressure, which can cause the tire pressure warning lamp to illuminate.
T-SB-0005-132018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Toyota models equipped with the display Audio HDD Navigation System Require a Special Service Tool (SST) USB drive to update the map, points of interest, Gracenote, and system software. The SST is used with all vehicles to deliver the update, however a unique Activation Number is required for each vehicle. Activation numbers are provided in an ACN pamphlet available through the normal parts ordering system.
T-SB-0064-10 Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information.
SST Requirements2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SSTs are key elements to provide your customers with swift and accurate repairs resulting in superior customer satisfaction.
T-TT-0226-132018-04-23. Service bulletin. ELECTRICAL SYSTEM. The customer is having difficulty changing the multi-display screen from Day Mode. If the multi-display screen is set to Day Mode when the headlights are on, the setting we be memorized when the engine is turned off.
T-SB-0391-08 Rev2018-04-23. Service bulletin. POWER TRAIN. This bulletin contains general vehicle pulling diagnosis and repair procedures along with specific information to help correct pulling complaints.
T-TT-0005-102018-04-23. Service bulletin. ENGINE. Starting with 2010 Model Year, Toyota began a gradual transition to the use of synthetic 0W-20 viscosity engine oil. There a re man benefits of this oil.
T-SB-0030-12 Rev2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This bulletin is now obsolete. Please see T-SB-0051-13.
T-SB-0051-132018-04-23. Service bulletin. EQUIPMENT:ELECTRICAL. 2012-2013 model year vehicles equipped with a Display Audio Navigation System and Entune (version less than 2.2.0) may exhibit one or more of the following conditions.
T-SB-0249-12 Rev2018-04-23. Service bulletin. SUSPENSION. Some vehicles may exhibit a vibration felt in the seat, floorboard, and/or steering wheel around 15-25 mph caused by a second order driveline vibration. Use the following procedure to address the condition.
T-SB-0066-11 Rev2018-04-23. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION; POWER TRAIN; POWER TRAIN:CLUTCH ASSEMBLY. Some 2005 ? 2013 model year Tacoma vehicles equipped with a 5-speed manual transmission may exhibit a slipping feeling in all forward gears and reverse. Replacement of the clutch disk, clutch cover, flywheel, and clutch pedal turnover spring is required to repair the vehicle. Follow the repair procedure in this bulletin to address this condition.
T-SB-0229-12_Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM. TSB: REVISION NOTICE November 22, 2017 Rev1: ? Applicability has been updated to include 2014 ? 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. In the event that a Toyota vehicle becomes submerged in water, many components may be physically damaged. Electrical and electronic components, including wiring harnesses, are particularly susceptible to corrosion and subsequent malfunction. Although any flooding can be damaging, salt water flooding elevates the potential for abnormal conditions and may increase risks due to its highly corrosive and conductive nature. Salt residue also continues to corrode and remain conductive even after a vehicle dries. This bulletin is intended to assist with safe handling and inspection of flood damaged vehicles and to provide basic guidance on likely needed repairs.
T-SB-0012-13 Rev2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: OBSOLETE NOTICE: September 14, 2016: This bulletin is now obsolete. Please see T-SB-0134-16.
T-TT-0424-162018-04-02. Service bulletin. WHEELS:LUGS/NUTS/BOLTS/STUDS. TT: Front Brake Vibration Key Points: * Issue can occur at any time if improper torque is applied on lug nuts * Over time, even one lug nut over or under torqued, can cause a vibration issue * When lug nuts are over torqued, this causes the rotor to have a runout out condition which can lead to brake vibration concerns * Brake vibration issues can occur at parking lot to highway speeds * Brake vibration issues can occur at light to moderate braking * Tightening lug nuts in a star pattern method during the torqueing process will assure that even/equal pressure is applied across the rotor hub surface * Torque sticks/wrenches should be used to apply accurate torque values when tightening * Do Not use impact guns/ratchets to completely run lug nuts up to the wheel surface
T-TT-0010-10 Rev2018-04-02. Service bulletin. BACK OVER PREVENTION; ENGINE. Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 (Crankshaft Position Sensor Circuit) and/or P0340 (Camshaft Position Sensor Circuit) due to inconsistent rotational speed of the engine's crankshaft.
T-SB-0012-13 Rev2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information.
T-SB-0021-14 Rev2018-04-02. Service bulletin. POWER TRAIN. TSB: Some 2012 ? 2014 model year Tacoma vehicles equipped with the A340 automatic transmission may exhibit a shudder condition on deceleration at approximately 20 mph after the vehicle has cold soaked. The Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) logic has been modified to reduce the possibility of this condition occurring. Follow the Repair Procedure in this bulletin to address this condition.
T-SB-0037-142018-04-02. Service bulletin. EQUIPMENT. TSB: Some 2005 ? 2014 model year Tacoma vehicles used in severe off-road service conditions may exhibit a cracked Horn Mounting Bracket. Use the procedure in this bulletin to address this condition.
T-SB-0250-12 Rev2018-04-02. Service bulletin. POWER TRAIN; BACK OVER PREVENTION. TSB: Some 2WD 2005 ? 2013 model year Tacoma vehicles equipped with an automatic transmission may exhibit a clunk/thunk noise from the rear of the vehicle or a ?bump-from-behind? sensation just before a stop or when accelerating from a stop. Improvements have been implemented on the rear propeller shaft (driveshaft).
T-SB-0016-13 Rev2018-04-02. Service bulletin. POWER TRAIN; BACK OVER PREVENTION. TSB: Some 4WD 2005 ? 2013 model year Tacoma vehicles equipped with an automatic transmission may exhibit a clunk/thunk noise from the rear of the vehicle or a ?bump-from-behind? sensation just before a stop or when accelerating from a stop. Improvements have been implemented on the rear propeller shaft (driveshaft) to reduce this condition.
T-TT-0246-13 Rev2018-04-02. Service bulletin. VISIBILITY; ELECTRICAL SYSTEM. Tech Tip: Tips for writing a DPR (Dealer Product Report) on manufacturing issues for windows and windshields.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.