Service bulletins for the 2009 Toyota Sequoia
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
197 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| T-TT-0058-10 Rev | 2018-04-23. Service bulletin. POWER TRAIN:TRANSFER CASE (4-WHEEL DRIVE). 4WD System Inoperative |
|---|---|
| T-SB-0229-12_Rev | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM. TSB: REVISION NOTICE November 22, 2017 Rev1: ? Applicability has been updated to include 2014 ? 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. In the event that a Toyota vehicle becomes submerged in water, many components may be physically damaged. Electrical and electronic components, including wiring harnesses, are particularly susceptible to corrosion and subsequent malfunction. Although any flooding can be damaging, salt water flooding elevates the potential for abnormal conditions and may increase risks due to its highly corrosive and conductive nature. Salt residue also continues to corrode and remain conductive even after a vehicle dries. This bulletin is intended to assist with safe handling and inspection of flood damaged vehicles and to provide basic guidance on likely needed repairs. |
| T-SB-0144-08_Obs | 2018-04-23. Service bulletin. EQUIPMENT. TSB: OBSOLETE NOTICE November 21, 2017: This bulletin is now obsolete. Please see T-SB-0304-17. |
| T-SB-0012-13 Rev | 2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: OBSOLETE NOTICE: September 14, 2016: This bulletin is now obsolete. Please see T-SB-0134-16. |
| T-SB-0142-13 Rev | 2018-04-02. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. TSB: REVISION NOTICE November 10, 2016 Rev2: ? Applicability has been updated to include 2016 ? 2017 model year Toyota vehicles. ? Parts Information section has been updated. Some 2004 ? 2017 model year Toyota vehicles may exhibit odors naturally occurring from the HVAC system and/or related environmental factors. Although there is no way to eliminate these odors, follow the General Procedure in this bulletin to minimize the odors experienced. |
| T-SB-0161-16 | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR. TSB: Some 2008 ? 2016 Sequoia and 2007 ? 2017 model year Tundra vehicles may exhibit a loud popping noise when operating the front doors. Noise is due to a fracture/crack in the plastic over mold of the door check arm by the pivot area. Follow the Repair Procedure in this bulletin to address this condition. NOTE If the vehicle is being repaired due to damage resulting from an accident, this Service Bulletin and part numbers listed do NOT apply. Follow normal parts order and Repair Procedures. |
| T-TT-0010-10 Rev | 2018-04-02. Service bulletin. BACK OVER PREVENTION; ENGINE. Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 (Crankshaft Position Sensor Circuit) and/or P0340 (Camshaft Position Sensor Circuit) due to inconsistent rotational speed of the engine's crankshaft. |
| T-SB-0012-13 Rev | 2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information. |
| T-TT-0246-13 Rev | 2018-04-02. Service bulletin. VISIBILITY; ELECTRICAL SYSTEM. Tech Tip: Tips for writing a DPR (Dealer Product Report) on manufacturing issues for windows and windshields. |
| T-SB-003-01 - OB | 2018-04-02. Service bulletin. UNKNOWN OR OTHER. TSB: OBSOLETE NOTICE: July 7, 2014: This bulletin is now obsolete. |
| T-SB-0043-14 Rev | 2018-04-02. Service bulletin. EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES. TSB: The Immobilizer and Smart Key Reset is a feature that allows the registration of new keys when all master keys are lost. Once the system is reset, all previously registered keys will be erased. |
| T-SB-0043-14 | 2018-04-02. Service bulletin. EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES. TSB: The Immobilizer and Smart Key Reset is a feature that allows the registration of new keys when all master keys are lost. Once the system is reset, all previously registered keys will be erased. |
| T-SB-0202-17_Rev | 2018-04-02. Service bulletin. LATCHES/LOCKS/LINKAGES:DOORS:LATCH. TSB: REVISION NOTICE October 6, 2017 Rev1: ? The Parts Information and Repair Procedure sections have been updated. Some 2007 ? 2015 model year Tundra and 2008 ? 2015 model year Sequoia vehicles may exhibit an abnormal feeling, dragging, or sticking when using the outside door handle. |
| ZH3_Toyota POL17 | 2018-04-02. Service bulletin. VEHICLE SPEED CONTROL; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. Warranty Policy Bulletin: Toyota has received a number of reports regarding the outside door handles on certain 2008-2015 model year Sequoia vehicles and on certain 2007-2015 model year Tundra vehicles. In these reports, customers have indicated that one or more of the outside door handles exhibited an abnormal feeling, dragging, or sticking when used. |
| T-TT-0086-11 | 2018-04-02. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY; ENGINE. TechTip: Condition - The vehicle may be difficult to start or have an abnormally low or rough idle after the battery has been disconnected or power to the Engine ECM has been interrupted. |
| T-SB-0218-17_Rev | 2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; AIR BAGS. TSB: REVISION NOTICE July 20, 2017 Rev1: Applicability has been updated to exclude 2007 ? 2017 model year Avanza vehicles. Some hazardous material treatment and handling regulations at the state and local level define the pre-disposal deployment of airbag and pre-tensioner assemblies as hazardous material treatment. Hazardous material treatment may require special training, certification or licensing in certain areas. TMS recommends that dealership personnel carefully review and follow ALL local and state regulations, and where necessary, contract with Environmental Protection Agency (EPA) Licensed Hazardous Waste Transportation and Disposal facilities. |
| T-TT-0092-11 Rev | 2018-04-02. Service bulletin. SEATS; ELECTRICAL SYSTEM. Some customers may complain that the Rear Seat Entertainment (RSE) system is inoperative if they have misplaced the parental passcode for the system. |
| T-PG006-00 Obsol | 2018-04-02. Service bulletin. EQUIPMENT:OTHER:LABELS. This bulletin is now obsolete. Please see T-SB-0054-13. |
| T-SB-0054-13 | 2018-04-02. Service bulletin. EQUIPMENT. California (CA), Federal (FED), and 50 State Certified emission control underhood labels (emission labels) may be obtained through your dealership?s Parts Department utilizing standard replacement parts ordering procedures. Follow the guidelines outlined in this bulletin to ensure proper label application. |
| T-SB-0141-10 Rev | 2018-04-02. Service bulletin. STRUCTURE:EMERGENCY:ESCAPE/EGRESS/EXIT; BACK OVER PREVENTION. If a creak, tick, or rattle noise is heard at the top or bottom of the windshield, or at the top of the rear glass, the source of the noise may be the two stoppers bonded to the top of the windshield/rear glass, or the windshield retainers bonded to the lower edge of the windshield. This bulletin provides the recommended repair procedure to eliminate these types of noises from the windshield/rear glass area. |
| Class Action Set | 2018-04-02. Service bulletin. VEHICLE SPEED CONTROL. As communicated in mid-June 2013, the Federal Court in Orange County, California continued the Fairness Hearing regarding the proposed settlement of the consolidated Economic Loss Class Actions related to claims of unintended acceleration until July 19, 2013. |
| T-TT-0246-13 | 2018-04-02. Service bulletin. VISIBILITY. Tips for writing a DPR (Dealer Product Report) on manufacturing issues for windows and windshields. |
| T-TT-0051-10 Rev | 2018-04-02. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. If a customer states there is an unpleasant odor in the vehicle from the HVAC system, there are various factors that may be involved. |
| T-TT-0269-13 | 2018-04-02. Service bulletin. VISIBILITY:GLASS, SIDE/REAR. The appearance of spots in tempered glass (when viewed at certain angles) is the result of the heat treating and quick quenching process during manufacturing. |
| T-TT-0268-13 | 2018-04-02. Service bulletin. EQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM. These concerns can be caused by changes made on the customer?s phone. Make sure to inquire with the customer if the connectivity concerns occurred after receiving an operating system update on their phone or they have restored their phone data/settings recently. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.