WenmarOpen by Wenmar Pro

Service bulletins for the 2013 Toyota Prius C

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

379 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
T-SB-0015-12 Rev2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Some 2013 model year vehicles are equipped with a Smart Key system, which allows the customer to enter and start the vehicle without using a mechanical key. To ensure the system is operating properly, the Smart Key functions (Smart Entry and Smart Start) should be inspected during Pre-Delivery Service (PDS). The following inspection procedure has been developed to confirm the proper operation of the Smart Key system prior to vehicle delivery.
T-SB-0024-12 Rev2018-04-23. Service bulletin. EQUIPMENT. 2013 model year vehicles are equipped with driver?s side floor mat retaining clips to secure the floor mat in the correct position. In addition, some models may utilize retaining clips for passenger side and rear seat floor mats as well. Follow the appropriate installation procedure to attach the driver?s side, and if applicable, the passenger?s side and rear seat floor mats to the vehicle carpet using the floor mat retaining clips during Pre-Delivery Service (PDS).
T-SB-0020-12 Rev2018-04-23. Service bulletin. TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS. The purpose of this bulletin is to provide a procedure to adjust tire pressure correctly when outside temperature is significantly colder or warmer than shop temperature. Seasonal temperature change can dramatically alter tire pressure, which can cause the tire pressure warning lamp to illuminate.
T-SB-0005-132018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Toyota models equipped with the display Audio HDD Navigation System Require a Special Service Tool (SST) USB drive to update the map, points of interest, Gracenote, and system software. The SST is used with all vehicles to deliver the update, however a unique Activation Number is required for each vehicle. Activation numbers are provided in an ACN pamphlet available through the normal parts ordering system.
T-SB-0064-10 Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information.
T-TT-0226-132018-04-23. Service bulletin. ELECTRICAL SYSTEM. The customer is having difficulty changing the multi-display screen from Day Mode. If the multi-display screen is set to Day Mode when the headlights are on, the setting we be memorized when the engine is turned off.
T-TT-0222-132018-04-23. Service bulletin. STEERING: STEERING WHEEL/HANDLE BAR. The vehicle will not start or ready-on and the steering wheel lock is engaged so that the steering wheel may only be turned very little from side-to-side.
T-SB-0033-132018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Some customers may inquire about the frequency and power output of the Smart Key/Smart Entry systems used on various models. The Smart Key/Smart Entry systems conform to all applicable FCC rules. This bulletin details the applicable specifications for these systems.
T-TT-0005-102018-04-23. Service bulletin. ENGINE. Starting with 2010 Model Year, Toyota began a gradual transition to the use of synthetic 0W-20 viscosity engine oil. There a re man benefits of this oil.
T-SB-0030-12 Rev2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This bulletin is now obsolete. Please see T-SB-0051-13.
T-SB-0051-132018-04-23. Service bulletin. EQUIPMENT:ELECTRICAL. 2012-2013 model year vehicles equipped with a Display Audio Navigation System and Entune (version less than 2.2.0) may exhibit one or more of the following conditions.
T-SB-0079-132018-04-23. Service bulletin. VISIBILITY:WINDSHIELD; EQUIPMENT; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. Some 2012 ? 2013 model year Prius C vehicles may exhibit a condition where a piece of foam that fits between the instrument panel and the windshield may come loose. Parts have been revised to address this condition.
T-SB-0229-12_Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM. TSB: REVISION NOTICE November 22, 2017 Rev1: ? Applicability has been updated to include 2014 ? 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. In the event that a Toyota vehicle becomes submerged in water, many components may be physically damaged. Electrical and electronic components, including wiring harnesses, are particularly susceptible to corrosion and subsequent malfunction. Although any flooding can be damaging, salt water flooding elevates the potential for abnormal conditions and may increase risks due to its highly corrosive and conductive nature. Salt residue also continues to corrode and remain conductive even after a vehicle dries. This bulletin is intended to assist with safe handling and inspection of flood damaged vehicles and to provide basic guidance on likely needed repairs.
T-SB-0012-13 Rev2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: OBSOLETE NOTICE: September 14, 2016: This bulletin is now obsolete. Please see T-SB-0134-16.
T-SB-0142-13 Rev2018-04-02. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. TSB: REVISION NOTICE November 10, 2016 Rev2: ? Applicability has been updated to include 2016 ? 2017 model year Toyota vehicles. ? Parts Information section has been updated. Some 2004 ? 2017 model year Toyota vehicles may exhibit odors naturally occurring from the HVAC system and/or related environmental factors. Although there is no way to eliminate these odors, follow the General Procedure in this bulletin to minimize the odors experienced.
T-TT-0424-162018-04-02. Service bulletin. WHEELS:LUGS/NUTS/BOLTS/STUDS. TT: Front Brake Vibration Key Points: * Issue can occur at any time if improper torque is applied on lug nuts * Over time, even one lug nut over or under torqued, can cause a vibration issue * When lug nuts are over torqued, this causes the rotor to have a runout out condition which can lead to brake vibration concerns * Brake vibration issues can occur at parking lot to highway speeds * Brake vibration issues can occur at light to moderate braking * Tightening lug nuts in a star pattern method during the torqueing process will assure that even/equal pressure is applied across the rotor hub surface * Torque sticks/wrenches should be used to apply accurate torque values when tightening * Do Not use impact guns/ratchets to completely run lug nuts up to the wheel surface
ZE7_Warranty Pol2018-04-02. Service bulletin. ENGINE. Warranty Policy Bulletin: Toyota has received some reports where vehicles may exhibit excessive engine oil consumption. Toyota is now announcing the part replacement phase of Warranty Enhancement Program ZE7 for vehicles exhibiting excessive engine oil consumption.
T-TT-0294-142018-04-02. Service bulletin. FUEL SYSTEM, GASOLINE; EQUIPMENT:APPLIANCE:AIR CONDITIONER. Tech Tip: Greenhouse Gas Logic (GHG) has been implemented on Toyota A/C Systems to reduce tailpipe emissions. The Federal government issues CAFÉ (Corporate Average Fuel Economy) credits to vehicle manufacturers that implement new technologies that reduce the carbon footprint of the vehicles they produce. GHG Logic technology works by automatically operating the HVAC system in REC mode when certain conditions are met, improving the A/C system cooling efficiency and reducing the vehicle's CO2 tailpipe emissions.
T-TT-0010-10 Rev2018-04-02. Service bulletin. BACK OVER PREVENTION; ENGINE. Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 (Crankshaft Position Sensor Circuit) and/or P0340 (Camshaft Position Sensor Circuit) due to inconsistent rotational speed of the engine's crankshaft.
T-SB-0012-13 Rev2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information.
T-TT-0246-13 Rev2018-04-02. Service bulletin. VISIBILITY; ELECTRICAL SYSTEM. Tech Tip: Tips for writing a DPR (Dealer Product Report) on manufacturing issues for windows and windshields.
T-TT-0262-13 Rev2018-04-02. Service bulletin. ENGINE. Tech Tip: Starting with the 2010 Model Year, Toyota began a gradual transition to the use of synthetic 0w20 viscosity engine oil. There are multiple benefits of this oil including: Reduced friction and wear on engine surfaces, Improved fuel economy, Reduction in waste oil stream (in vehicles approved for 10,000 mile oil change intervals), Reduced maintenance cost (in vehicles approved for 10,000 mile oil change intervals). Due to the improved performance and durability of 0w20 synthetic oil, Toyota has extended the oil change intervals to 10,000 mile for most vehicles that require this oil. With this change, the following should be noted: The 2TR-FE (4Runner/Tacoma) and the 3UR-FBE (Flex Fuel Tundra/Sequoia) are the exceptions to this new change interval program; these engines have not been approved for the 10,000 mile interval at this time. A 5,000 mile oil change interval is still required for these vehicles. Also, the Flex Fuel 3UR-FBE requires a 2,500 mile interval when operated on E85 50% of the time or more. Only Toyota vehicles in which 0w20 oil is mandatory (except for the 2TR-FE & 3UR-FBE Engines) have been approved for extended oil change intervals. Vehicles in which 0w-20 is an option to 5w20 (or 5w30) will continue to require 5,000 mile change intervals, even if 0w20 oil is used. In case of vehicles with 10,000 mile oil change intervals, the 5,000 mile service interval has not been eliminated. The traditional 5,000 mile maintenance procedures (such as tire rotation) will continue to be required, and the fluid levels (including engine oil) will need to be checked and adjusted at this time. If the vehicle operation meets the standard criteria for "Special Operating Conditions" such as: driving off-road, on dirt roads, towing a trailer, making repeated short trips under 32 degrees F, or extensive idling, the engine oil must be replaced at 5,000 mile intervals, regardless of oil used.
T-SB-0043-14 Rev2018-04-02. Service bulletin. EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES. TSB: The Immobilizer and Smart Key Reset is a feature that allows the registration of new keys when all master keys are lost. Once the system is reset, all previously registered keys will be erased.
T-SB-0043-142018-04-02. Service bulletin. EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES. TSB: The Immobilizer and Smart Key Reset is a feature that allows the registration of new keys when all master keys are lost. Once the system is reset, all previously registered keys will be erased.
T-SB-0294-172018-04-02. Service bulletin. EQUIPMENT. TSB: SUPERSESSION NOTICE The information contained in this bulletin supersedes SB No. T-SB-0133-14. ? The Parts Information, Required Tools & Equipment, and On-Vehicle Navigation Update sections have been updated. Toyota models equipped with the Premium HDD Navigation (AVN/AW-EMV) system require a Special Service Tool (SST) USB drive to update the map, points of interest, Gracenote®, and system software. The SST is used with all vehicles to deliver the update; however, a unique activation number is required for each vehicle. Activation numbers are provided in an Activation Card Number pamphlet available through the normal parts ordering system.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.