# Recalls that may apply to the 2016 Toyota Highlander A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups. ## United States (NHTSA), as of 2026-10-19 - [16V775000](/recalls/nhtsa/16V775000.md), 2016-10-24: ELECTRICAL SYSTEM:WIRING; SERVICE BRAKES, HYDRAULIC:FLUID. Toyota Motor Engineering \& Manufacturing \(Toyota\) is recalling certain model year 2016 Highlander vehicles manufactured May 26, 2016, to September 16, 2016. The brake fluid level sensor may not be connected to the wire harness, preventing the sensor from detecting the brake fluid level. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard \(FMVSS\) No. 135, "Light Vehicle Brake Systems." Built 2016\-05\-26 to 2016\-09\-16. - [16V420000](/recalls/nhtsa/16V420000.md), 2016-06-09: EQUIPMENT:OTHER:LABELS. Southeast Toyota Distributors, LLC \(SET\) is recalling certain model year 2016 Toyota Camry and Highlander, 2015\-2016 Toyota Tundra, Scion FR\-S, and tC vehicles. The Load Carrying Capacity Modification Label may not reflect the correct added weight of the installed accessories. As a result, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims for Passenger Cars." Built 2014\-05\-06 to 2016\-05\-13. ## Canada (Transport Canada), as of 2026-10-19 - [2021723](/recalls/tc/2021723.md), 2021-11-24: Electrical. Issue: This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: Engine block heater wiring that overheats or melts could create the risk of a fire. Corrective Actions: Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater. - [2019428](/recalls/tc/2019428.md), 2019-08-23: Accessories. Issue: On certain vehicles, the hook and loop material used to attach the carpet to its underpadding may not be flame resistant. As a result, when it is tested alone, the loop fasteners do not meet the requirements of Canadian regulations. Safety Risk: As the carpet is always assembled, and the loop fasteners are very small, this problem does not create a safety risk. Corrective Action: This is not a recall. The company has made production changes to ensure that all new vehicles meet the requirements of Canadian regulations. - [2017363](/recalls/tc/2017363.md), 2017-07-20: Electrical. On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation. - [2016518](/recalls/tc/2016518.md), 2016-10-21: Brakes. Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard \(CMVSS\) 135 – Light Vehicle Brake Systems. The brake fluid level sensor may not have been connected during the manufacturing process. In the event that the brake fluid level sensor wire harness is not connected and the brake fluid were to fall below the specified level without illuminating the warning indicator, the vehicle braking performance could be affected, which would increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and connect the brake level fluid sensor as necessary. ## Check a VIN - [NHTSA recall lookup by VIN, United States](https://www.nhtsa.gov/recalls) - [Transport Canada recall search, Canada](https://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/menu.aspx?lang=eng) Contains information licensed under the Open Government Licence – Canada. JSON: [/v1/vehicles/2016_toyota_highlander/recalls](/v1/vehicles/2016_toyota_highlander/recalls) [Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%202016%20Toyota%20Highlander&page=https%3A%2F%2Fopen.wenmarpro.com%2Fmakes%2Ftoyota%2Fhighlander%2F2016%2Frecalls&vehicle=2016%20Toyota%20Highlander)