WenmarOpen by Wenmar Pro

Service bulletins for the 2014 Toyota Highlander

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

438 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
T-TT-0322-15 Rev2018-04-23. Service bulletin. VISIBILITY:SUN/MOON ROOF ASSEMBLY. Tech Tip: Some vehicles may experience a condition in which the drain hoses for the sunroof/moonroof assembly become kinked, or pinched. This may cause water leaks into the cabin from the housing assembly drip trays, or the customer may note water stains on the headliner assembly.
TSB-0012-13 Rev22018-04-23. Service bulletin. ENGINE; ELECTRICAL SYSTEM:SOFTWARE. TSB: Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information.
T-TT-0400-162018-04-23. Service bulletin. EQUIPMENT:MECHANICAL. TT: POST TSB Rear Trailing Arm Noise.
T-TT-0399-162018-04-23. Service bulletin. ELECTRICAL SYSTEM. TT: Multimedia systems reset procedure should be performed when the multimedia system no longer responds or reboots itself.
T-SB-0160-14 Obs2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: OBSOLETE NOTICE: This bulletin is now obsolete. Please see T-SB-0035-16.
T-TT-0118-11 Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. technicians should confirm the following key points to minimize the potential for future MIL "ON" concerns after HV Battery Replacement.
T-TT-0213-132018-04-23. Service bulletin. AIR BAGS. Toyota vehicles are equipped with SRS, including various airbags and in some models, seat belt pre-tensioners, to help reduce the risk of injury in a collision. If a customer expresses any concerns that the SRS airbags or pretensioner devices did not perform as expected, please follow the steps in the recommendations section below.
T-SB-0012-132018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the TIS and the CUW.
SST Requirements2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SSTs are key elements to provide your customers with swift and accurate repairs resulting in superior customer satisfaction.
T-TT-0226-132018-04-23. Service bulletin. ELECTRICAL SYSTEM. The customer is having difficulty changing the multi-display screen from Day Mode. If the multi-display screen is set to Day Mode when the headlights are on, the setting we be memorized when the engine is turned off.
T-SB-0391-08 Rev2018-04-23. Service bulletin. POWER TRAIN. This bulletin contains general vehicle pulling diagnosis and repair procedures along with specific information to help correct pulling complaints.
T-SB-0026-132018-04-23. Service bulletin. EQUIPMENT:ELECTRICAL. If the hybrid vehicle is put into storage, the state of charge (SOC) of its HV battery and auxiliary battery will gradually decrease. To prevent the auxiliary battery from becoming discharged during storage, proper maintenance is necessary.
T-SB-0025-132018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. The radio antenna pole on some models is designed with a hex-cut base and requires installation using a wrench. When performing PDS or installing the antenna pole for any other reason, inspect the antenna base for a hex-cut to determine if the following procedure is required.
T-SB-0023-132018-04-23. Service bulletin. EQUIPMENT. 2014 model year vehicles are equipped with driver?s side floor mat retaining clips to secure the floor mat in the correct position. In addition, some models may utilize retaining clips for passenger side and rear seat floor mats as well. Follow the appropriate installation procedure to attach the driver?s side, and if applicable, the passenger?s side and rear seat floor mats to the vehicle carpet using the floor mat retaining clips during Pre-Delivery Service (PDS).
T-SB-0022-132018-04-23. Service bulletin. WHEELS. During the manufacturing process tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Please refer to the following procedure to ensure that the original tires stay in the same location on the vehicle.
T-SB-0021-132018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Long-term or off-site storage requires special care to keep vehicles factory fresh and ready for delivery. The following guidelines should be performed to minimize vehicle component/part degradation due to extended vehicle storage conditions. Long-term storage can affect a vehicle?s systems and components. Any problems that are found should be corrected immediately.
T-SB-0020-132018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Some 2014 model year vehicles are equipped with a Smart Key system, which allows the customer to enter and start the vehicle without using a mechanical key. To ensure the system is operating properly, the Smart Key functions (Smart Entry and Smart Start) should be inspected during Pre-Delivery Service (PDS). The following inspection procedure has been developed to confirm the proper operation of the Smart Key system prior to vehicle delivery.
T-TT-0005-102018-04-23. Service bulletin. ENGINE. Starting with 2010 Model Year, Toyota began a gradual transition to the use of synthetic 0W-20 viscosity engine oil. There a re man benefits of this oil.
T-TT-0288-142018-04-23. Service bulletin. ENGINE AND ENGINE COOLING. Prior to installing remanufactured U660 and U760 transaxles, it is necessary to remove the lower oil cooler tube union from the original transaxle case and install it into the reman unit. A NEW O-ring and printed installation instructions are supplied in separate bag with the reman unit. An instruction tag is also affixed to the unit.
T-SB-0017-142018-04-23. Service bulletin. TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS. The purpose of this bulletin is to provide a procedure to adjust tire pressure correctly when outside temperature is significantly colder or warmer than shop temperature. Seasonal temperature change can dramatically alter tire pressure, which can cause the low tire pressure warning light to illuminate.
T-TT-0377-15_Rev2018-04-23. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. TT: Some customers may experience poor outgoing Bluetooth sound quality, this can occur for various reasons. Current multimedia systems are designed with the ability to adjust Bluetooth sound quality to compensate for Echo or excessive background noise.
T-TT-0375-15_Rev2018-04-23. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL. TT: For customer concerns of no or poor outgoing sound from the Bluetooth systems there are diagnostics in the repair manual which can be performed to diagnose the condition.
T-SB-0229-12_Rev2018-04-23. Service bulletin. ELECTRICAL SYSTEM. TSB: REVISION NOTICE November 22, 2017 Rev1: ? Applicability has been updated to include 2014 ? 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. In the event that a Toyota vehicle becomes submerged in water, many components may be physically damaged. Electrical and electronic components, including wiring harnesses, are particularly susceptible to corrosion and subsequent malfunction. Although any flooding can be damaging, salt water flooding elevates the potential for abnormal conditions and may increase risks due to its highly corrosive and conductive nature. Salt residue also continues to corrode and remain conductive even after a vehicle dries. This bulletin is intended to assist with safe handling and inspection of flood damaged vehicles and to provide basic guidance on likely needed repairs.
T-SB-0012-13 Rev2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: OBSOLETE NOTICE: September 14, 2016: This bulletin is now obsolete. Please see T-SB-0134-16.
T-SB-0027-15 OBS2018-04-02. Service bulletin. ELECTRICAL SYSTEM. TSB: OBSOLETE NOTICE: March 25, 2016: This bulletin is now obsolete. Please see T-SB-0023-16.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.