WenmarOpen by Wenmar Pro

Service bulletins for the 2020 Toyota Camry

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

278 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
T-SB-0006-192019-02-19. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. TSB: Hybrid vehicles are equipped with two types of batteries: ? Hybrid Vehicle (HV) battery ? Auxiliary (12V) battery If the hybrid vehicle is put into storage, the State-Of-Charge (SOC) of its HV battery and auxiliary battery will gradually decrease. To prevent the auxiliary battery from becoming discharged during storage, proper maintenance is necessary. Perform the following maintenance service for the HV battery and auxiliary battery. NOTE ? BEFORE disconnecting the auxiliary battery, confirm the shift lever is in the ?P? position and apply the parking brake completely. The shift lever CANNOT be shifted from the ?P? position with the auxiliary battery disconnected. ? If the negative (?) terminal of the auxiliary battery is reconnected, even if the Power button is in the Start mode, the hybrid system may NOT start. In this case, push the Power button and select the Start mode again to start the hybrid system (the Ready light is ON). If the hybrid system still does NOT start (the Ready light is OFF), refer to the Repair Manual.
T-SB-0002-192019-02-19. Service bulletin. TIRES. TSB: During the manufacturing process, tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Refer to the Tire Positioning Procedure in this bulletin to ensure that the original tires stay in the same location on the vehicle.
T-TT-0521-192019-02-19. Service bulletin. ENGINE AND ENGINE COOLING. TT: The current engine active test ?Control the Injection Mode? is not operating as desired when controlling the direct injectors manually on 2GR-FKS engines. When direct injection is started and then stopped using the active test, current ECU logic does not turn off the direct injectors and can cause DTCs P017200, P017500 and P0160300. To avoid this condition, technicians should raise engine RPM when changing back and forth between the Direct Injection and Port Injection active tests. Use the recommended procedure below to avoid this concern while testing injection mode of FKS equipped vehicles. NOTE: If the active test is used multiple times without using this procedure to raise engine RPM, it may be necessary to reset learning values for fuel trim and Air to Fuel ratio before returning vehicle to customer.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.