Service bulletins for the 2014 Porsche Boxster
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
447 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
| 122-X4X7D-09 | 2018-11-19. Service bulletin. ENGINE AND ENGINE COOLING. Cause The noises can occur if there is excessive spring force tolerance in the oil separator Date of introduction The optimized oil separators are used in production from November 25, 2015. Remedial action In the event of a customer complaint, check the part number of the installed oil separator and replace the oil separator if necessary. |
|---|---|
| 122-D2A2M-10 | 2018-10-15. Service bulletin. SUSPENSION:FRONT:CONTROL ARM. Subject: Front axle: Control arms (wishbone) and longitudinal arms Rear axle: Trailing arms (wishbone) and carrier side section Information: If the affected axle parts need to be replaced, an old partmay still be installed on the opposite half of the axle. Different types of axle parts cannot be installed. A different supplier is now used for some components. This change in supplier has resulted in the use of different production methods. |
| 122-U4R6C-08 | 2018-08-20. Service bulletin. SEATS. Concerns: Look of the seat cover Information: Work procedure in the event of complaint "Seat cover wrinkled". |
| 122-P5G7U-07 | 2018-08-06. Service bulletin. ELECTRICAL SYSTEM:WIRING; ENGINE. Oil in the wiring harness. If oil is found in the engine wiring harness during a repair, the wiring harness and all the affected components (including the oil pump control valve) must be replaced. |
| 122-P5G7U-07 | 2018-07-30. Service bulletin. FUEL SYSTEM, GASOLINE. Oil in the wiring harness. If oil is found in the engine wiring harness during a repair, the wiring harness and all the affected components (including the oil pump control valve) must be replaced. |
| 122-B9V4V-06 | 2018-06-25. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Information: The Approval and Support Management system was created to offer assistance to the dealer organization with new and complex technical issues by utilizing the Support Specialists within Porsche R&D. As a result, this process has reduced vehicle downtime and repeat repairs substantially. |
| 122-S7H6V-03 | 2018-03-13. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Concerns: Battery trickle charging with "Charge-o-mat"may time out within a short period of time. The trickle charging will thus end prematurely. Thismay result in a dead battery. Information: The ?Charge-o-mat? device recommended by Porsche can be connected to the plug socket in the above-mentioned vehicles again in accordance with instructions in order to trickle-charge the battery (e.g. in the showroom) if: ? the gateway control unit is re-coded beforehand using the PIWIS Tester with test software version 36.800.030 installed. |
| 122-T7Y5Q-12 | 2017-12-14. Service bulletin. ELECTRICAL SYSTEM. Information: This document updates information previously published in EQ 1105, EQ 1105, and EQ 1401. To provide stable voltage and sufficient current throughout certain service operations, you should connect the vehicle to a battery charger (sometimes referred to as a power supply). However, you may experience ECU programming and coding issues if the chosen battery charger has insufficient power. Many workshop manuals currently advise use of a battery charger with a 40 or 70 A current rating. However, with the increasing current requirements of modern Porsche vehicles, we recommend a battery charger capable of producing a minimum current of 90 A. |
| 122-N9Z4L-07 | 2017-10-27. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Concerns: AGM starter battery (referred to below simply as 'battery') Situation: Support for the care andmaintenance of the AGMstarter battery (at the dealership): From the time the vehicle is delivered to the Porsche Centre until it is handed over to the customer, the battery must be maintained and charged regularly, depending on use. |
| 122-R7W2C-07 | 2017-10-27. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Concerns: AGM starter battery (referred to below simply as ?battery?) Situation: Customer complaints concerning battery-related topics Recurring customer complaints concerning topics relating to battery capacity and quality. |
| 122-W4G8S-10 | 2017-10-15. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY; ELECTRICAL SYSTEM. Technical Concern: By design, the vehicle gateway allows certain vehicle features to time-out, in stages. This allows the vehicle to sleep. One feature that can time-out is the 12 V DC power point (cigarette lighter) in the center console area. One of the recommended methods of using the battery maintainer is to plug the battery maintainer into this power point. If this power point becomes disabled, it will not allow current flow from the battery maintainer to the vehicle, the vehicle battery will not trickle charge, and the battery maintainer will eventually shut off. |
| 122-B7U4T-05 | 2017-10-15. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Customer Concern: Certain vehicle systems have unwanted, unpredictable behavior. Technical Concern: The symptoms are difficult to diagnose. There may be multiple symptoms intermittently affecting multiple systems. Though this is not an exhaustive list, some common failure modes are: ? Start/stop issues ? Power windows not fully returning to the parked position after automatic preopening ? PCM audio stopping during a start/stop cycle Ultimately, the technician determines that low 12-volt battery voltage is the underlying root cause of the unwanted behavior. The technician corrects the battery?s low voltage. Consequently, the unwanted behavior ends. |
| 122-H4U2R-06 | 2017-09-14. Service bulletin. LATCHES/LOCKS/LINKAGES:HOOD:LATCH. Concerns: Upper part of lock on front lid Information: This is to inform you of a Recall Campaign on the above-mentioned vehicles. Due to a temporary manufacturing error, there is a possibility that front lid lock upper parts, on which the catch bar was not riveted to themounting plate according to specifications, were installed on the affected vehicles. The durability of the upper part of the lock cannot be guaranteed over the service life of the affected vehicles and the risk of the lid opening unintentionally cannot be ruled out. |
| 122-G7H3U-06 | 2017-09-14. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. Concerns: Instrument cluster Information: This is to inform you of a voluntary Workshop Campaign on the above-mentioned vehicles. The following fault symptoms can occur on the affected vehicles due to a software error in the instrument cluster: * Failure of the display on the multi-function display: The display on the multi-function display in the instrument cluster can stop working at times under certain conditions. The display starts working again after a certain time. * Implausible service reminder indicator display: The driver is informed that a service (maintenance, intermediate maintenance or oil service) is due although the mileage and date for a required service have not yet been reached. |
| 122-Q2E5G-06 | 2017-09-14. Service bulletin. FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP. Concerns: Switching element for filler flap Information: This is to inform you of a voluntary Workshop Campaign on the above-mentioned vehicles. Defective switching elements for the filler flap may have been installed on the affected vehicles due to a supplier error. This can cause the switching element to become mechanically blocked. If this happens, there is no guarantee that the filler flap will open correctly. |
| 122-M6M5Z-06 | 2017-09-14. Service bulletin. ELECTRICAL SYSTEM:HORN. Concerns: Horn (also referred to as fanfare) Information: Modified assignment of connector contacts due to installation of new type of horn. As a result, if the horn needs to be replaced, an adapter cable must also be installed. |
| 122-W6Q4V-06 | 2017-08-01. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:SOFTWARE. Concerns: PDK control unit Information: This is to inform you of a voluntary Workshop Campaign on the above-mentioned vehicles. A shift rod movement at a shift gate that was not selected can be detected incorrectly on the affected vehicles due to a software error. |
| WF86 | 2016-06-22. Service bulletin. EQUIPMENT. SUMMARY TO BE PROVIDED ON A FUTURE DATE. |
| TI-59-14 | 2014-11-05. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ELECTRICAL SYSTEM. PORSCHE: ACCORDING TO NEW SOFTWARE, (VERSION 2900), FRONT END ELECTRONIC CONTROL UNIT (FRONT BCM) MUST BE FLASHED, IF REAR END ELECTRONICS CONTROL UNIT (REAR BCM) NEEDS REPLACING. MODEL 2013-2014 911 991), BOXSTER (981), CAYMAN (981). *PE |
| TI-2-14 | 2014-06-27. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. PORSCHE: INSTRUMENT CLUSTER SOFTWARE NEEDS REPROGRAMMING DUE TO DISPLAYING INCORRECT INFORMATION AND CAN STOP WORKING OR WILL WORK, AFTER CERTAIN CONDITIONS, ON SOME VEHICLES. MODEL 2012-2014 BOXSTER, CAYMAN, 911. *PE |
| TI-12-11-13 | 2014-01-31. Service bulletin. ELECTRICAL SYSTEM. PORSCHE: INFORMATION CONCERNING THE PROCEDURE FOR REPROGRAMMING THE PDK CONTROL UNIT. BOXSTER (981)/BOXSTER S (981) AND CAYMAN (981)/CAYMAN S (981). MODEL YEARS 2013-2014. *JS |
| TI-78-13 | 2014-01-29. Service bulletin. STRUCTURE:FRAME AND MEMBERS:UNDERBODY SHIELDS. PORSCHE: DUE TO PROGRAMMING ERROR, AT TIME OF PRODUCTION, ON SOME VEHICLES, THE UNDERBODY PROTECTION, IN LEFT REAR WHEEL HOUSING, HAD NOT BEEN APPLIED BASED ON SPECIFICATIONS AND COULD BECOME CORRODED OVER LIFE SERVICE OF VEHICLE. MODEL 2014 BOXSTER, BOXSTER S. *PE |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.