# P17F0 on the 2018 Nissan Sentra

The bulletins listed name this code in NHTSA's summary, or are about the same components. A bulletin or a recall listed here may apply to the model year. None of it is a diagnosis.

This code is specific to a manufacturer and is not described here.

## Bulletins for this model year that name P17F0

- [10176250](https://open.wenmarpro.com/bulletins/10176250), 2020-06-10: 2018\-2019 SENTRA, VERSA SEDAN, AND VERSA NOTE; ENHANCED DIAGNOSTIC LOGIC FOR CVT IF YOU CONFIRM The customer reports a transmission judder \(shake, shudder, single or multiple bumps or vibration\), hesitation on acceleration, lack of power, or RPM flare. NOTE: • A new diagnostic logic has been established to enhance the diagnostic process by storing a diagnostic trouble code \(DTC\) on Applied Vehicles. • New DTCs: P17F0, P17F1, P17F2, P17F3, P17F4 will not turn the MIL ON. • New DTC P0868 will turn the MIL ON. • This new diagnostic logic will monitor conditions in the CVT while the customer is operating their vehicle in their usual daily drive patterns. • If any of the above DTCs are stored, refer to NTB20\-035 \(Sentra\) or NTB20\-036 \(Versa Sedan and Versa Note\) for repair information. ACTION 1. Confirm the current TCM part number. 2. Reprogram the TCM, if applicable
- [10152521](https://open.wenmarpro.com/bulletins/10152521), 2019-01-07: MIL ON WITH DTC P0776, P1715 AND MAY HAVE HESITATION AND/OR LACK OF POWER This bulletin applies only to vehicles equipped with a CVT \(Continuously Variable Transmission\). IF YOU CONFIRM The MIL is ON with DTC P0776 \(PC SOLENOID B ? Pressure Control Solenoid ?B? Performance/Stuck OFF\) stored. NOTE: \- If P0744, P0746, P0841, P0965, P2813, or P17F0 are stored this bulletin does not apply. Refer to ASIST for diagnostic assistance. \- With this incident, if it should occur, P1715 \(INPUT SPEED SENSOR\) may be stored with DTC P0776. The vehicle may also hesitate and/or have reduced power. ACTION 1. Refer to the Repair Flow Chart on page 2 for mechanical CVT repair. 2. If needed, reprogram the TCM. \- Refer to step 30 in the TCM Reprogram section \(page 21\) of the SERVICE PROCEDURE to confirm if reprogramming is needed. 3. Perform Additional Service \(page 19\).