WenmarOpen by Wenmar Pro

Service bulletins for the 2020 Nissan Rogue

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

122 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Electrical system are shown. Show all

Bulletins, newest first
NTB20-0942021-01-09. Service bulletin. ELECTRICAL SYSTEM:WIRING; FUEL SYSTEM, GASOLINE. 2015-2020 ROGUE; MIL ON WITH DTC P0181 AND/OR P0183 IF YOU CONFIRM The MIL is ON with DTC P0181 (FTT SENSOR) and/or P0183 (FTT SEN/CIRCUIT) stored in the ECM. ACTION 1. Remove the fuel pump assembly. 2. Inspect the fuel pump assembly wiring, and reroute the wiring, if applicable. 3. Reinstall the fuel pump assembly.
NTB20-0752020-11-09. Service bulletin. EQUIPMENT:ELECTRICAL:INFOTAINMENT; ELECTRICAL SYSTEM:SOFTWARE. SOFTWARE UPDATE POP-UP NOTIFICATION SERVICE INFORMATION The infotainment system of the applied vehicle has the ability to update its software through an over-the-air (OTA) link. As software updates become available for new features, and/or patches, the software update screen (pop-up) shown in Figure 1 will automatically be displayed. Much like cell phone and computer updates, this is a normal feature which allows the user to choose when an update is downloaded. • It is recommended that while in dealer inventory and this pop-up appears, that “ Yes” is selected to provide the latest software version to the customer at delivery. NOTE: If the ignition is turned OFF in the middle of a download, it will automatically restart when the ignition is turned back ON. When one of the following is selected: Yes…..The pop-up is hidden and the download starts in the background. Later…The pop-up is hidden and displayed again in the next key cycle (after cold start).
NTB20-0692020-10-08. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM. ROGUE AND ROGUE SPORT; VIBRATION AND/OR NOISE WHEN MAKING LOW SPEED TURNS IF YOU CONFIRM There is a vibration or judder feeling from the rear of the vehicle during the following conditions: • When making turns • On dry roads • At low speeds (under 40 MPH) And • The above vibration does not occur if the electric controlled coupling is electrically disconnected. ACTION 1. Confirm the AWD control unit part number, and replace it, if applicable. 2. Replace the electric controlled coupling for the rear final drive. 3. Perform Unit Characteristics Writing.
NTB20-0502020-08-09. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM; LATCHES/LOCKS/LINKAGES:HATCHBACK/LIFTGATE:LOCK. POWER BACK DOOR WILL NOT OPERATE WITH REQUEST SWITCHES IF YOU CONFIRM On vehicles equipped with a Kick Motion Activated Liftgate, the back door (liftgate) will not open or close when requested to do so using the: • Intelligent Key • Back door request switch, located on the back door • Automatic back door switch, located on the instrument lower panel LH And DTC B2409 is either current or has been stored in the past. ACTION Replace the automatic back door control module. • Refer to the Electronic Service Manual (ESM) section: BODY EXTERIOR, DOORS, ROOF & VEHICLE SECURITY > DOOR & LOCK > WITH INTELLIGENT KEY SYSTEM > REMOVAL AND INSTALLATION > AUTOMATIC BACK DOOR CONTROL MODULE.
NTB20-0472020-08-09. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM:HORN. 2020 ROGUE; HIGH HORN ASSEMBLY AND HORN RELAY SERVICE INFORMATION The high horn assembly and horn relay are no longer installed from the factory. These components have been intentionally decontented, are not missing and should not be installed. • Warranty claims for installing these components will be denied.
NTB15-049u2020-07-10. Service bulletin. ELECTRICAL SYSTEM. TELEMATICS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB15-049t2020-03-07. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. TELEMATICS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0802019-11-08. Service bulletin. UNKNOWN OR OTHER; ELECTRICAL SYSTEM. 2014-2020 ROGUE; NO AIR FLOW FROM VENTS DUE TO SNOW BUILD-UP IF YOU CONFIRM Or the customer states there is no air flow from any of the HVAC vents And There is snow build-up in and around the blower motor air inlet, behind the cowl. ACTION 1. Remove all snow, water, and debris from the blower motor inlet, cowl area, and where the blower motor mounts. 2. Clean or replace the blower motor as needed. 3. If the blower motor does not work on all speed settings, replace the variable blower control (fan resistor). 4. If not already equipped: Install the cowl and wiper pivot filters listed in PARTS INFORMATION on the last page of this bulletin.
NTB19-0712019-10-09. Service bulletin. ELECTRICAL SYSTEM; AIR BAGS. DTC B00A0-00 STORED IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored And OCS zero point reset cannot be performed (continued on the next page) And The following screen displays: ACTION 1. Check the Occupant Classification System (OCS) control unit using the ODS Analysis tool software. • Refer to SERVICE PROCEDURE on page 5. HINT: “OCS” may also be referred to as “ODS”. 2. Perform “75-zero RESET”.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.