WenmarOpen by Wenmar Pro

Service bulletins for the 2010 MINI Cooper

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

161 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
M1101122018-11-13. Service bulletin. ENGINE; ELECTRICAL SYSTEM. "N16 and N18 Engine Oil Leak. The customer states that a small engine oil leak can be seen from the underside of the engine. CAUSE The internal sealing of the oil pump volume control solenoid valve is compromised, allowing engine oil to leak from the oil pump volume control solenoid. DIAGNOSTIC Below is the procedure for identifying how far the engine oil has migrated inside the engine electrical harness, when this issue occurs, if at all. The procedure must be followed very carefully so that the proper repair is identified. 1. Disconnect the oil pump volume control solenoid valve electrical connection per Repair Instructions 11 41 519 ""Removing and installing or replacing the solenoid valve (engine oil pump)."" Inspect the electrical connector; if no engine oil is found inside the electrical connector, perform the oil pump volume control valve repair procedure. If engine oil is found inside the electrical connector, proceed to diagnostic procedure step 2. 2. Remove the cover from the DME and remove all three electrical connectors from the DME. Inspect the connectors for traces of engine oil. If no engine oil is found, perform the oil pump volume control valve repair procedure and replace the engine section of the wire harness. Refer to EPC for the additional part number. If engine oil is found in the DME connector, proceed to step 3. 3. If engine oil is found in the DME electrical connector, perform the oil pump volume control valve repair procedure, replace the engine section of the wire harness and replace the DME. Refer to EPC for the additional part numbers. Do not remove the engine oil pan. Do not replace the oil pump volume control valve. Do not replace engine oil pump. OIL PUMP VOLUME CONTROL VALVE REPAIR"
M1108152018-11-13. Service bulletin. ENGINE. Surface Cracks on the Water Pump Drive Pulley. During a repair, service or inspection, the drive pulley on the water pump shows signs of cracking. No part replacement is necessary unless there is another issue found that will be corrected by replacing the drive pulley.
M6402152018-11-13. Service bulletin. VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:FAN/MOTOR; ENGINE AND ENGINE COOLING. The Blower Motor is Faulty. The blower motor does not operate at any fan speed. The blower motor may work intermittently with the blower fan speed operating only on FULL speed. CAUSE The blower motor is faulty and causes the blower resistor to fail.
M1701152018-11-13. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE. "Engine Cranks, No Start and/or Engine Coolant Temperature Faults. 1 The engine either exhibits a crank, no start or a hard start (long crank), usually on a cold engine. No faults are stored in the DME. Proceed to Correction 1 for further diagnosis. 2 NOTE: The engine may also exhibit the same starting behavior as in Situation1. The Service Engine Soon lamp is illuminated, with one or more of the following fault codes stored in the DME: Engine temperature sensor faults ? 2943 Coolant temperature sensor, signal change too fast ? 2937 Coolant temperature sensor, electrical: short circuit to positive ? 2936 Coolant temperature sensor, electrical: short circuit to earth ? 293A Coolant temperature sensor, plausibility, cold start: temperature too high ? 293B Coolant-temperature sensor, plausibility, cold start: Temperature too low ? 2947 Coolant-temperature sensor, signal: Fixed on low ? 2948 Coolant-temperature sensor, signal: Fixed ? 3393 Engine downtime, plausibility: Time too long in correlation with engine coolant cooling down ? 3392 Engine downtime, plausibility: Time too short in correlation with engine coolant cooling downIf any of the above fault codes are stored, proceed to Correction 2. Engine thermostat faults: ? 348E Characteristic map thermostat, actuation: Short circuit to positive ? 348F Characteristic map thermostat, actuation: Short circuit to earth ? 3490 Characteristic map thermostat, actuation: Open circuit If any of the above fault codes are stored then proceed to Correction 2: The above fault codes for the engine temperature sensor and thermostat are the primary fault codes for turning the Service Engine Soon light on. 1. Poor solder contacts in the engine coolant temperature sensor integrated into the engine thermostat housing 2. A faulty external or replaceable engine coolant temperature sensor (see below for identifying production changes in the thermostat and engine temperature sensors) 3. A faulty map-contro
M0107162018-11-13. Service bulletin. ENGINE AND ENGINE COOLING. "N14 ENGINE TIMING CHAIN AND TENSIONER: LIMITED WARRANTY EXTENSION TO 7 YEARS/100,000 MILES. INFORMATION As part of a Class Action Suit Settlement for the vehicles listed above (""Class Vehicles""), MINI USA, a division of BMW of North America, LLC, is extending the limited warranty for the engine timing chain and tensioner to: 7 years/100,000 miles as determined by the vehicle's original in-service date This component-specific limited warranty extension applies to: Defects in materials or workmanship; and this Extended coverage is subject to the same vehicle eligibility requirements, limitations, and exclusions that apply to the MINI New Passenger Car Limited Warranty. For the eligible MINI vehicles, the limited warranty extension applies to the: Timing Chain (1) Timing Chain Tensioner with Seal Ring (4) In conjunction and when necessary, the parts listed below may only be claimed when there replacement is required to ""properly"" perform a covered repair of the timing chain and/or tensioner: Guide Rail (2) Tensioner Rail (3) Timing Chain Tensioner Seal Ring (5) Crankshaft Sprocket (6) Guide Rail (11) Bearing Bolt with Washer (13) Washer (14) Bearing Bolt with O-ring (15) O-ring (16)Note: This bulletin is a notice of a component-specific ""limited warranty extension as part of a Class Action Settlement. This is NOT a notice of a Recall or Service Action. There is no immediate repair required unless the MINI vehicle is currently experiencing a problem with the timing chair and/or tensioner."
M1101122018-11-05. Service bulletin. ENGINE. SI M11 01 12February 2015 EngineTechnical Service This Service Information bulletin supersedes SI M11 01 12 dated March 2014. designates changes to this revision SUBJECT N16 and N18 Engine: Engine Oil Leak. The customer states that a small engine oil leak can be seen from the underside of the engine. CAUSE The internal sealing of the oil pump volume control solenoid valve is compromised, allowing engine oil to leak from the oil pump volume control solenoid. DIAGNOSTIC
M0112162018-11-05. Service bulletin. ENGINE AND ENGINE COOLING. "ENGINE MECHANICAL WATER (COOLANT) PUMP: LIMITED WARRANTY EXTENSION TO 7 YEARS/84,000 MILES. INFORMATION As part of a Class Action Suit Settlement for the vehicles listed above (""Class Vehicles""), MINI USA, a division of BMW of North America, LLC, is extending the limited warranty for the engine mechanical water pump to: z Item #1: This ""component-specific"" limited warranty extension applies to defects in materials or workmanship. z This coverage is subject to the same vehicle eligibility requirements, limitations, and exclusions that apply to the MINI New Passenger Car Limited Warranty. z When it is necessary, the friction wheel is covered only when it is done in conjunction with performing an eligible and covered engine mechanical water pump repair. z This extended coverage does not apply to electric water pump. Note: This bulletin is a notice of a component-specific ""limited warranty extension as part of a Class Action Settlement. This is NOT a notice of a Recall or Service Action. There is no immediate repair required unless the MINI vehicle is currently experiencing a problem with the water pump."
BMWDEC01162018-11-05. Service bulletin. ENGINE AND ENGINE COOLING. "Update MINI Water Pump Class Action Settlement: Herremans v. BMW of North America, LLC. MINI USA, a division of BMW of North America, LLC (""MINI USA"") has entered into a nationwide settlement with the plaintiffs in the above referenced class action and the Court has granted final approval of the settlement. This DCS message provides you with the latest information about this case and the settlement. Class Allegations. The Plaintiff claimed that MINI produced and sold certain MINI Cooper Class Vehicles with defective water pumps. Class Vehicles are MINI R55, R56, R57, R58, R59, and R60 Series vehicles equipped with N12, N14, N16 or N18 engines that were sold or leased to Class Members in the US (including Puerto Rico). The Class Vehicles were produced from October 2006 through November 2012."
M1701152018-10-09. Service bulletin. ENGINE AND ENGINE COOLING. ENGINE CRANKS, NO START AND/OR ENGINE COOLANT TEMPERATURE FAULTS: NOTE: The engine may also exhibit the same starting behavior as in Situation1.
12 09 152016-02-04. Service bulletin. ENGINE; ELECTRICAL SYSTEM. MINI: FAULTY SOFTWARE FOR THE TANK VENTILATION CONTROL DISPLAYS ENGINE THROTTLE REACTION WHEN TEMPERATURE IS HIGH OUTSIDE, AND MORE OBVIOUS IF THE TANK IS ONLY PARTLY FILLED. *MA
12 07 152016-02-04. Service bulletin. ENGINE; ELECTRICAL SYSTEM. MINI: FAULTY SOFTWARE CAUSES THE CHECK CONTROL AND ENGINE POWER REDUCED LIGHT TO APPEAR. *MA
12 06 152016-02-04. Service bulletin. ELECTRICAL SYSTEM; ENGINE. MINI: BECAUSE OF THE DME SOFTWARE, AND A DAMAGED CLUTCH, THE DRIVETRAIN MALFUNCTION CHECK MESSAGE APPEAR. *MA
12 05 152016-02-04. Service bulletin. ELECTRICAL SYSTEM; ENGINE. MINI: DUE TO FAULTY DME SOFTWARE, THE SERVICE ENGINE LIGHTS COMES ON, INCLUDING THE CHECK CONTROL MESSAGE FOR MOTOR FORCE DECREASE. *MA
11 06 152016-02-04. Service bulletin. ENGINE; ELECTRICAL SYSTEM. MINI: DIFFERENT FAULTS ACTIVATES ENGINE MALFUNCTION AND OIL WARNING. *MA
11 02 152016-02-03. Service bulletin. ENGINE. MINI: A MECHANICAL FAILURE AND DME SOFTWARE ERROR OF THE VANOS ACTUATORS CAUSE THE ENGINE TO RUN ROUGH WHICH ACTIVATES THE MALFUNCTION WARNING LIGHT. *MA
SIM-12-04-152015-10-07. Service bulletin. ENGINE. MINI: SOME VEHICLES ARE EXPERIENCING SEVERAL ISSUES AS WHEN IDLING POWER IS LOSS, BEFORE ENGINE STARTS, EXTENDED CRANKING, CLUTCH PEDAL FAILS TO RETURN TO DISENGAGED POSITION, A HIGH PITCHED WHINE NOISE FROM LOWER AREA OF ENGINE. MODEL F55, 56 (COOPER, COOPER S, JCW). NO YEARS LISTED. *PE
SIM-11-10-142015-06-10. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER; ENGINE AND ENGINE COOLING:ENGINE:OTHER FUEL TYPES:TURBO/SUPERCHARGER. MINI: SOME VEHICLES HAVE TURBOCHARGER NOISE AND A LACK OR LOSS OF PERFORMANCE, DUE TO RESTRICTION OF TURBOCHARGER OIL SUPPLY, RESULTING IN OIL STARVATION AND SEIZING OF TURBOCHARGER ASSEMBLY. MODEL ALL. *PE
N-14-05-092015-05-22. Service bulletin. ENGINE. MINI: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. QUESTIONS AND ANSWERS FOR TIMING CHAIN OF VARIOUS MINI. *PE
SIM-12-06-122013-01-16. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING; ENGINE AND ENGINE COOLING:COOLING SYSTEM. MINI: ENGINE COOLANT TEMPERATURE SENSOR, NOW AN INDIVIDUAL COMPONENT DUE TO CHANGE IN WIRING HARNESS AND REPLACEMENT OF HARNESS HAS TWO SEPARATE TWO PIN CONNECTORS, WHERE ONE FOR COOLANT TEMPERATURE SENSOR AND OTHER COOLANT THERMOSTAT. ALL MODELS BUILT UP TO 3/2012. *PE
SIM-17-07-122012-11-02. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE. MINI: WHEN A FALSE READING LEADS TO DIFFICULTY IN STARTING ENGINE AND CAUSES SERVICE ENGINE SOON LAMP TO ILLUMINATE, INTERNAL CORROSION IS FORMING IN ENGINE COOLANT TEMPERATURE SENSOR, CAUSING INACCURATE ENGINE TEMPERATURE READING DUE TO BRIDGING OF CONTACTS. MODELS 2010-2012 R55, R56, R57, R58. *PE UPDATED ON 4/19/2013. *KB
SIM-17-09-122012-11-02. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE. MINI: INACCURATE ENGINE TEMPERATURE READING DUE TO POSSIBLE CORROSION FORMING IN ENGINE COOLANT SENSORS WHICH LEADS TO BRIDGING OF CONTACTS CAUSING DIFFICULT IN STARTING ENGINE OR ILLUMINATION SERVICE ENGINE SOON LAMP. MODELS R55, R56, R57, R58. NO MODEL YEARS LISTED. *PE UPDATED ON 4/19/2013. *KB
SIM-17-08-122012-11-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. MINI: INTERNAL BRIDGING OF CONTACTS BY INTERNAL CORROSION FORMING ON ENGINE COOLANT TEMPERATURE SENSOR, COULD GIVE INACCURATE ENGINE TEMPERATURE READING LEADING TO DIFFICULTY IN STARTING AND/OR SERVICE ENGINE SOON BEING ILLUMINATED. MODELS 2010-2012 R55, R56, R57, R58. *PE UPDATED ON 4/19/2013. *KB
SIM-17-06-122012-10-24. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING; ENGINE AND ENGINE COOLING:ENGINE. MINI: ON ENGINE COOLANT TEMPERATURE SENSOR, INTERNAL CORROSION MIGHT BE FORMING, CAUSING A FALSE, INACCURATE ENGINE TEMPERATURE READING, LEADING TO DIFFICULTY IN STARTING ENGINE AND/OR A SERVICE ENGINE SOON ILLUMINATION. MODELS 2010-2012 R55, R56, R57, R58 (COOPER, COOPER S-CONVERTIBLE, CLUBMAN, HARDTOP, COUPE). *PE UPDATED 1/18/13. *PE UPDATED 3/11/2013 *JS
SIM-11-05-122012-10-24. Service bulletin. ENGINE. MINI: THE TIMING CHAIN TENSIONER DEVELOPED AN OIL LEAK AT MOUNTING LOCATION, WHICH WAS CAUSED BY THE SEAL RING MATERIAL BEING TOO SOFT, RESULTING IN TENSION LOST DURING TIGHTENING SEQUENCE OF TIMING CHAIN TENSIONER. MODEL 2010-2011 R55, R56, R57, R60 (COOPER S CLUBMAN, CONVERTIBLE, COUNTRYMAN AND HARDTOP). *PE
SIM-17-05-122012-08-28. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM. MINI: DUE TO INTERNAL BRIDGING OF CONTACTS, INTERNAL CORROSION HAS FORM ON ENGINE COOLANT TEMPERATURE SENSORS GIVING INACCURATE OR FALSE TEMPERATURE READINGS FOR ENGINE. *PE UPDATED 10/17/12. *PE UPDATED 03/11/2013 *JS

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.