WenmarOpen by Wenmar Pro

Service bulletins for the 2014 Mazda Mazda6

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

757 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Body and frame are shown. Show all

Bulletins, newest first
09-001-17-3296b2017-10-04. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS; STRUCTURE; ELECTRICAL SYSTEM. When dealing with customer complaints of excessive condensation and/or water within the headlamp unit, first determine if all the bulb sockets (including O-ring), seals and covers are present and correctly installed. In most cases you will find that the Bulb Seal No. 1 (A) or HID Bulb Seal No. 1 (B) and Bulb Seal No. 2 (C) socket covers have not been correctly installed or are missing due to improper prior repairs (i.e., customer replacing the headlamp bulbs or body shop not transferring them when replacing the headlamp unit(s) due to a collision). Any damage caused by missing socket covers, HID module seal (D), or missing bumper brackets (E) is not covered by warranty policy.
09-012-17-3334a2017-10-04. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; STRUCTURE. Some vehicles may experience unusual noise coming from inside the front door panel when playing the audio system. This is caused by the damper coming off the speaker frame due to corrosion on the speaker back frame. To correct the issue, a plating process was added at the supplier beginning on November 13, 2015.
SSPA52017-09-14. Service bulletin. STRUCTURE:BODY:DOOR. Mazda Motor Corporation has decided to conduct a Special Service Program (SSP) on certain 2014-2016 Mazda6 vehicles produced from October 25, 2012 through January 30, 2015. On the subject vehicles, the metal part of the front and rear door sash molding(s) may be exposed and could harm vehicle occupants upon contact. Dealers are to inspect the door sash on all vehicle doors and repair as instructed in this SSP. If the protector is damaged, replace the door sash with new, improved parts. This repair must be performed at no charge to the vehicle owner.
09-029-13-28352017-08-10. Service bulletin. EQUIPMENT; STRUCTURE:BODY:DOOR. Some customers may have a concern with the top edge of the rear door weatherstrip (A) detached from fas-tener (B).
09-046-15-31112017-06-08. Service bulletin. STRUCTURE:BODY:DOOR. SOME CUSTOMERS MAY COMPLAIN ABOUT A WHITE DOOR ARMREST(S) PINK DISCOLORATION. THE DISCOLORED ARMREST DOES NOT MATCH THE OTHER WHITE PARTS OF THE DOOR PANEL. REPLACE ALL 4 DOOR PANELS.
09-016-15-30412017-06-07. Service bulletin. STRUCTURE:BODY:DOOR. SOME VEHICLES MAY EXPERIENCE A RATTLE NOISE FROM THE FRONT DOOR GLASS WHEN DRIVING WITH THE WINDOW OPEN APPROX. 1/2 TO 4 INCHES (1 - 10 CM). THE RATTLE NOISE MAY BE CAUSED BY INSUFFICIENT HOLDING FORCE OF THE GLASS RUN CHANNEL. TO INCREASE THE HOLDING FORCE, THE SHAPE OF GLASS RUN CHANNEL HAS BEEN CHANGED AND NON-WOVEN PADS HAVE BEEN ATTACHED TO THE GLASS RUN CHANNEL.
09-021-15-30382017-06-07. Service bulletin. STRUCTURE:BODY:TRUNK LID. SOME VEHICLES MAY EXHIBIT A CONDITION THAT WATER ENTERS INTO THE TRUNK LID LIGHT WHILE WASHING THE VEHICLE WITH HIGH PRESSURE. WATER MAY ENTER THROUGH THE TRUNK LID LIGHT GASKET AND THE BODY PANEL.
02-010-16-31702017-05-30. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE:FRAME AND MEMBERS; SUSPENSION:FRONT:SHOCK ABSORBER. SOME VEHICLES MAY EXHIBIT A KNOCKING / SQUEAKING NOISE FROM THE FRONT SHOCK ABSORBER WHEN DRIVING ON ROUGH ROADS AND/OR WHEN TURNING THE STEERING WHEEL WHILE THE VEHICLE IS STOPPED. THE NOISE MAY BE DUE TO:•UPPER FRONT STRUT BEARING (A) DAMAGE. (CX-5 AND MAZDA6)•STICK/SLIP BETWEEN THE FRONT STRUT BEARING AND COIL SPRING. (CX-3, CX-5 AND MAZDA6)•THE BUMP STOPPER (C) MAY BE CONTACTING THE STRUT BEARING WHEN THE FRONT SHOCK ABSORBER IS COMPRESSED, CAUSING A POPPING NOISE. (MAZDA6 ONLY)•THE FRONT LOWER ARM BUSHING (D) IS MAKING A STICK-SLIP NOISE IN WET ROAD CONDITIONS. (CX-5 AND MAZDA6)TO ELIMINATE THE NOISE, THE FOLLOWING MASS-PRODUCTION CHANGES HAVE BEEN MADE:1. THE MATERIAL AND PRODUCTION METHOD OF THE FRONT STRUT BEARING (A) HAS BEEN CHANGED. (CX-5 AND MAZDA6)2. A PROTECTOR HAS BEEN INSTALLED ONTO THE COIL SPRING. (CX-5 AND MAZDA6)3. THE SHAPE OF THE BUMP STOPPER (C) WILL BE MODIFIED IN THE FUTURE. (MAZDA6 ONLY)4. THE SHAPE OF THE COIL SPRING HAS BEEN CHANGED. (CX-3 ONLY)5. FRICTION OF THE LOWER ARM BUSHING HAS BEEN REDUCED BY ADDING A DRY COATING. (CX-5 AND MAZDA6)NOTE:THE PISTON ROD NUT (B) REQUIRES REPLACEMENT.
02-001-15-29982017-05-25. Service bulletin. STRUCTURE:FRAME AND MEMBERS. SOME VEHICLES MAY EXHIBIT A CREAKING NOISE FROM UNDER THE FRONT OF THE VEHICLE WHEN DRIVING OVER BUMPS. THE NOISE OCCURS AT APPROX. 12 - 25 MPH (20 - 40 KM/H) WHEN THE ROAD SURFACE IS WET OR AFTER A CAR WASH. THE NOISE BECOMES MORE NOTICEABLE WHEN DRIVING OVER HIGHER BUMPS. THE CREAKING NOISE IS CAUSED WHEN THE FRONT LOWER CONTROL ARM BUSHING(S) (A) BECOME WET.
09-041-14-29582017-05-08. Service bulletin. STRUCTURE:BODY:DOOR. SOME CUSTOMERS MAY HAVE A CONCERN WITH THE TOP EDGE OF THE REAR DOOR WEATHERSTRIP (A) DETACHED (COMING OFF / FALLING OFF) FROM FASTENER (B).
09-036-14-29452017-05-05. Service bulletin. VISIBILITY:GLASS, SIDE/REAR; STRUCTURE:BODY:DOOR. SOME VEHICLES MAY EXHIBIT A WIND NOISE FROM THE DOOR WINDOW EDGE(S), WHILE DRIVING. THE WIND NOISE IS MOST PRONOUNCED AT APPROXIMATELY 50 MPH (81 KM/H) ON A SMOOTH ROAD. THE WIND NOISE MAY BE CAUSED BY AIR PASS-ING THROUGH GAPS BETWEEN THE DOOR EDGE AND THE CORRESPONDING BODY PANEL.
09-033-16-32062017-03-01. Service bulletin. STRUCTURE:BODY:TRUNK LID. SOME VEHICLES MAY EXHIBIT A CONDITION THAT WATER ENTERS INTO THE TRUNK LID LIGHT WHILE WASHING THE VEHICLE WITH HIGH PRESSURE. WATER MAY ENTER THROUGH THE TRUNK LID LIGHT GASKET AND THE BODY PANEL.
09-038-16-32132017-02-23. Service bulletin. STRUCTURE. SOME VEHICLES MAY EXPERIENCE A RATTLE NOISE FROM THE FRONT DOOR GLASS WHEN DRIVING WITH THE WINDOW OPEN APPROX. 1/2 TO 4 INCHES (1 - 10 CM). THE RATTLE NOISE MAY BE CAUSED BY INSUFFICIENT HOLDING FORCE OF THE GLASS RUN CHANNEL. TO INCREASE THE HOLDING FORCE, THE SHAPE OF GLASS RUN CHANNEL HAS BEEN CHANGED AND NON-WOVEN PADS HAVE BEEN ATTACHED TO THE GLASS RUN CHANNEL.
09-038-16-32132017-02-16. Service bulletin. STRUCTURE. SOME VEHICLES MAY EXPERIENCE A RATTLE NOISE FROM THE FRONT DOOR GLASS WHEN DRIVING WITH THE WINDOW OPEN APPROX. 1/2 TO 4 INCHES (1 - 10 CM). THE RATTLE NOISE MAY BE CAUSED BY INSUFFICIENT HOLDING FORCE OF THE GLASS RUN CHANNEL. TO INCREASE THE HOLDING FORCE, THE SHAPE OF GLASS RUN CHANNEL HAS BEEN CHANGED AND NON-WOVEN PADS HAVE BEEN ATTACHED TO THE GLASS RUN CHANNEL.
1098M2017-02-14. Service bulletin. STRUCTURE. WHEN REMOVING PARTS FROM A VEHICLE, TAKE CAUTION OF THIS SYMBOL "R". FAILING TO REPLACE THE NON-REUSABLE PART MAY CAUSE A SYSTEM FAILURE.
1098M2017-02-07. Service bulletin. STRUCTURE. WHEN REMOVING PARTS FROM A VEHICLE, TAKE CAUTION OF THIS SYMBOL "R". FAILING TO REPLACE THE NON-REUSABLE PART MAY CAUSE A SYSTEM FAILURE.
09-046/152016-07-14. Service bulletin. STRUCTURE; STRUCTURE:BODY:DOOR. WHITE DOOR ARMREST(S) PINK DISCOLORATION. SOME CUSTOMERS MAY COMPLAIN ABOUT A WHITE DOOR ARMREST(S) PINK DISCOLORATION. THE DISCOLORED ARMREST DOES NOT MATCH THE OTHER WHITE PARTS OF THE DOOR PANEL.
09-011/162016-07-14. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE. CORROSION AROUND SPOT WELDS IN TRUNK OPENING. SOME VEHICLES MAY EXHIBIT CORROSION AROUND THE SPOT WELDS IN TRUNK OPENING UNDER THE REAR WINDOW. THIS IS CAUSED BY INSUFFICIENT PAINT THICKNESS AT THE SPOT WELDS. TO CORRECT THE PROBLEM, THE PAINT THICKNESS HAS BEEN IMPROVED.
09-010/162016-07-14. Service bulletin. STRUCTURE. STAINS FOUND ON PAINT DURING PDI SOME VEHICLES MAY EXPERIENCE STAINS APPEARING ON THE HOOD, ROOF AND/OR TRUNK OF VEHICLE. THIS CONCERN IS MOST LIKELY TO BE FOUND IN COLD WEATHER AREAS JUST AFTER THE RAPGARD IS REMOVED AT PDI. THIS MAY BE CAUSED BY MOISTURE WHICH HAS BEEN TRAPPED AND CONDENSED BETWEN PAINT AND THE RAPGARD. THESE TYPES OF STAINS CAN BE REMOVED WITH HEAT GUN OR AN INFRARED DRIER. IF YOU ENCOUNTER THIS CONCERN DURING PDI, USE HEAT GUN OR AN INFRARED DRIER TO APPLY HEAT TO THE AFFECTED ARE TO REMOVE STAIN(S).
RF-14-022016-04-12. Service bulletin. STRUCTURE:BODY:ROOF AND PILLARS. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
09-041-142016-03-31. Service bulletin. STRUCTURE:BODY:DOOR. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
09-036-142016-03-31. Service bulletin. STRUCTURE:BODY:DOOR. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
09-029-132016-03-31. Service bulletin. STRUCTURE:BODY:DOOR. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
09-023-132016-03-31. Service bulletin. STRUCTURE:BODY:DOOR. SUMMARY TO BE PROVIDED ON A FUTURE DATE.
09-015-142016-03-31. Service bulletin. STRUCTURE:BODY:HOOD. SUMMARY TO BE PROVIDED ON A FUTURE DATE.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.