Recalls that may apply to the 2004 Kenworth T600
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about ELECTRICAL SYSTEM are shown.
| 04V580000 | 2004-12-10. ELECTRICAL SYSTEM:WIRING. ON CERTAIN TRUCKS, THE POWER FEED HARNESS P92-1993 TERMINALS WERE NOT PROPERLY CRIMPED. Built 2004-08-10 to 2004-10-19. |
|---|---|
| 04V360000 | 2004-07-21. ELECTRICAL SYSTEM:WIRING:FRONT UNDERHOOD. ON CERTAIN TRUCKS EQUIPPED WITH A COMBINATION OF CATERPILLAR C11/C13 ENGINES AND AN OPTIONAL LEECE NEVILLE BRUSHLESS ALTERNATOR, A CHAFFING POINT MAY EXIST BETWEEN A HEAT SHIELD ON THE ENGINE AND THE WIRING FOR THE ALTERNATOR. Built 2003-11-03 to 2004-06-14. |
| 04V174000 | 2004-04-12. ELECTRICAL SYSTEM:WIRING. CERTAIN TRUCKS EQUIPPED WITH EATON FULLER ULTRASONIC TRANSMISSIONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK AND TRANSMISSION BRAKING EFFECT." THE CAB TRANSMISSION HARNESS COULD HAVE BEEN INCORRECTLY WIRED DURING PRODUCTION INSTALLATION. Built 2003-02-05 to 2004-01-13. |
| None found. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.