Recalls that may apply to the 2004 Kalmar OTTAWA
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| None found. |
| 2008351 | 2008-09-26. Brakes. On certain vehicles, a "U" series Weatherhead crimp type hose was substituted in place of a "P" series type fitting during the manufacturing process. This combination of a non approved fitting with an approved hose is a noncompliance to Canada Motor Vehicle Safety Standard (CMVSS). The noncompliance air brake hose assembly was only used on rear axle brake chambers in a rear axle position when an axle suspension was installed. If a hose failure occurred it may cause a sudden application of the brakes and could cause a loss of control. Correction: Dealer will replace hoses. |
|---|---|
| 2006234 | 2006-09-22. Brakes. On certain terminal tractors, the electrical wiring to the Anti-Lock Brake System (ABS) modulator valves from the Electronic Control Module (ECM) is incorrect. The wires to the "Exhaust" and "Hold" connections on the ABS modulator valves are reversed. In an anti-lock braking event, this will cause the ABS to malfunction. ABS performance will be degraded, increasing the risk of a crash. Correction: Dealers will install 4 modulator valve jumper harnesses. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.