Service bulletins for the 2018 Jeep Wrangler
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
716 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Engine are shown. Show all
| 9003704 | 2023-01-09. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair. |
|---|---|
| 0700122 | 2023-01-09. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fastenersto possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low. |
| S2208000073 | 2023-01-09. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM). No Start, After Flash And Or PCM Replace, DTC P0513 Invalid Skim Key Setting |
| 0700122 | 2022-12-19. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fasteners to possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low. |
| S2209000004 | 2022-12-19. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. If a Mopar oil filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils. |
| 0901222 | 2022-12-12. Service bulletin. ENGINE AND ENGINE COOLING. Spark Knock/Engine Symptoms This bulletin involves cleaning the piston heads and cylinder head combustion chambersto resolve a spark knock condition being caused by oil intrusion through the PCV system. The customer may describe a knocking or pinging noise coming from the engine upon acceleration. |
| 9004219 | 2022-11-07. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL; ENGINE AND ENGINE COOLING. PUMP, Water (Water Pump Inlet Tube) For concern of leak at water pump, please check and re-torque water pump inlet tube fasteners as described in Service Bulletin 07-001-20 before replacing the water pump. Please also check the gasket from the block to the water pump. This gasket can be serviced separately. |
| S2207000002 | 2022-10-31. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM. Coolant leak |
| S2207000002 | 2022-10-31. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM. Coolant leak |
| 0700120 | 2022-10-17. Service bulletin. ENGINE AND ENGINE COOLING. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fasteners to possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low. |
| S1809000007 | 2022-10-17. Service bulletin. ENGINE AND ENGINE COOLING. Customer Complaint May Include Engine Oil Leak Or Consumption |
| S1809000007 | 2022-10-17. Service bulletin. ENGINE. Customer Complaint May Include Engine Oil Leak Or Consumption |
| 0700122 | 2022-10-17. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fastenersto possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low. |
| 700122 | 2022-10-17. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fasteners to possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low. |
| 9003704 | 2022-09-26. Service bulletin. SEATS; FUEL SYSTEM, GASOLINE; AIR BAGS; POWER TRAIN; BACK OVER PREVENTION; ENGINE AND ENGINE COOLING. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair. |
| S2109000004 | 2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Issue involves overheating, running hot, coolant leaks and related symptoms after a Mopar replacement engine has been installed in the vehicle. |
| S1918000008RevB | 2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Customer?s complaint may include a MIL-on with one or more of the following DTCs (Active, Pending, or Stored) in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 (Bank 1 downstream) O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above. |
| S2108000146 | 2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Check Engine Lamp Comes On, CAN C Loss Communication DTC?s Setting Stored Or Active Intermittently |
| S1809000007RevC | 2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. Customer Complaint May Include Engine Oil Leak Or Consumption |
| S2123000020 | 2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING. A Buzz, Squeak, Rattle (BSR), Clicking Noise Heard From Left Side Of The Freedom Top. |
| 9004307A | 2022-09-26. Service bulletin. EQUIPMENT; ENGINE. TRANSMITTER, Integrated Key FOB Due to a global semiconductor shortage, service availability of this part is limited. To maintain production and service requirements, FOBIKs affected by the shortage will be available on an ?as required basis?. This FOBIK should only be ordered in the event the vehicle is inoperable, and there are no other FOBIKs available. It is requested the customer uses their spare FOBIK until supply is once again available. |
| 0700122 | 2022-09-26. Service bulletin. ENGINE AND ENGINE COOLING; FUEL SYSTEM, GASOLINE. Water Pump Inlet Tube Fastener Torque This bulletin involves checking the torque on the water pump inlet tube fastenersto possibly eliminate coolant leak at this location. The customer may describe either a coolant leak or the coolant level is low. |
| 1808919 | 2022-09-15. Service bulletin. ENGINE AND ENGINE COOLING. wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK |
| 04-001-21 | 2022-08-22. Service bulletin. ENGINE AND ENGINE COOLING. Pentastar Upgrade Oil Fill Level after an Oil Change This bulletin involves rechecking the oil fill level after filling the engine to the correct specifications. The customer may describe that after an oil change they check their oil fill level and it is showing overfilled on the oil dipstick. |
| S1918000008 | 2022-08-22. Service bulletin. ENGINE AND ENGINE COOLING. Customer?s complaint may include a MIL-on with one or more of the following DTCs (Active, Pending, or Stored) in the PCM: P0133, P0137, P0171, P0300, P2096. The root cause could be due to oil leaking from Bank 1 valve cover seal on to the 1/2 (Bank 1 downstream) O2 sensor. This can adversely affect the 1/2 O2 sensor signal reading and lead to listed DTCs. Before performing normal diagnostic routines for the above codes, check for the condition listed above. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.