# P2299 on the 2016 Jeep Wrangler

The bulletins listed name this code in NHTSA's summary, or are about the same components. A bulletin or a recall listed here may apply to the model year. None of it is a diagnosis.

Nobody has written a description of this code yet.

## Bulletins for this model year that name P2299

- [10219831](https://open.wenmarpro.com/bulletins/10219831), 2022-09-15: Accelerator Pedal Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. P2122 and P2127 will set if accelerator pedal connector is disconnected during diagnosis. Make sure codes are active before replacing pedal. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.
- [10159998](https://open.wenmarpro.com/bulletins/10159998), 2019-05-20: Part Description: Accelerator Pedal Issue Description: Vehicle has accelerator pedal fault code. Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.
- [10138856](https://open.wenmarpro.com/bulletins/10138856), 2018-06-04: Accelerator Pedal Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. P2122 and P2127 will set if accelerator pedal connector is disconnected during diagnosis. Make sure codes are active before replacing pedal. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.
- [10121706](https://open.wenmarpro.com/bulletins/10121706), 2017-11-03: Flash: Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module \(PCM\) with the latest available software. Customers may experience a Malfunction Indicator Lamp \(MIL\) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes \(DTCs\) set in the PCM memory: · P0441 \- EVAP Purge System Performance. · P0455 \- EVAP System Large Leak. · P2610 \- PCM Internal Engine Off Timer Performance. · P0335 \- Crankshaft Position Sensor Circuit. · P0339 \- Crankshaft Position Sensor Intermittent. · P0122 \- Throttle Position Sensor 1 Circuit Low. · P0123 \- Throttle Position Sensor 1 Circuit High. · P0222 \- Throttle Position Sensor 2 Circuit Low. · P0223 \- Throttle Position Sensor 2 Circuit High. · P2299 \- Brake Pedal Position/Accelerator Pedal Position Incompatible. · U1424 \- Implausible Engine Torque Signal Received. The following software enhancement is also available: · Calibration to prevent engine stall after \-35 °C \(95 °F\) cold start/drive.