U1424 on the 2017 Jeep Cherokee
The bulletins listed name this code in NHTSA's summary, or are about the same components. A bulletin or a recall listed here may apply to the model year. None of it is a diagnosis.
This code is specific to a manufacturer and is not described here. Its meaning is in the manufacturer's service information.
| 21-006-17 REV. A | 2022-09-15. Service bulletin. Flash: Transmission Diagnostic and Shift Enhancements This bulletin involves reprogramming the Transmission Control Module (TCM) with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following DTCs have been set:P0810-00 - Clutch Position Control Error - (Sales Codes EHK). P0887-00 - TCM Power Control Circuit High. U1424-00 - Implausible Engine Torque Signal Received. P1DCD-00 - TCM Monitoring Processor Performance Multiple Clutches Locked Up. Some customers may experience the following conditions:During a limp mode condition, the transmission remains in a fixed gear. 5-4 downshift hesitation. A longer than normal delay during a shift from reverse to drive selection. In addition the following enhancements are included:Calibration update for Engine Stop Start (ESS) to allow the engine to remain running during a brief stop. 2-1 and 3-2 coast down tip-in. |
|---|---|
| 18-110-20 | 2021-03-01. Service bulletin. Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the Powertrain Control Module (PCM) with thelatest available software. The customer may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more ofthe following Diagnostic Trouble Codes (DTCs): U1504 - Implausible Message Data Length Received From Steering Angle Sensor. P1185 - General Pressure Sensor Correlation. U1424-00 - Implausible Engine Torque Signal Received. P0101 - Mass Air Flow Sensor "A" Circuit Performance. P0128 - Thermostat Rationality. P0300 - Multiple Cylinder Misfire. P0301 - Cylinder 1 Misfire. P0302 - Cylinder 2 Misfire. P0303 - Cylinder 3 Misfire. P0304 - Cylinder 4 Misfire. Some customers may also experience the following condition: Extended engine crank times or possibly a no start condition(South Korea only). During an engine limp mode condition, the transmission remains in a fixedgear. |
| 21-006-17 REV. A | 2018-06-04. Service bulletin. Flash: Transmission Diagnostic and Shift Enhancements This bulletin involves reprogramming the Transmission Control Module (TCM) with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following DTCs have been set:P0810-00 - Clutch Position Control Error - (Sales Codes EHK). P0887-00 - TCM Power Control Circuit High. U1424-00 - Implausible Engine Torque Signal Received. P1DCD-00 - TCM Monitoring Processor Performance Multiple Clutches Locked Up. Some customers may experience the following conditions:During a limp mode condition, the transmission remains in a fixed gear. 5-4 downshift hesitation. A longer than normal delay during a shift from reverse to drive selection. In addition the following enhancements are included:Calibration update for Engine Stop Start (ESS) to allow the engine to remain running during a brief stop. 2-1 and 3-2 coast down tip-in. |
3 on file from NHTSA, as of 2026-10-19. See them in the bulletin list. A bulletin lists model years: read the document for which vehicles it concerns.