Recalls that may apply to the 2000 International 3800
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| None found. |
| 2004171 | 2004-05-20. Brakes. On certain vehicles, the TRW Model 410M Electronic Control Unit (ECU) can misinterpret particular false wheel speed signals generated from any of the following conditions: An incorrect gap between the sensor and tone ring, a chaffed sensor wire, connector corrosion, sensor vibration or quality of harness and pin-outs. If one of these conditions occurs, the ECU could not distinguish between an actual low friction event on road surface and a low amplitude sensor signal and would activate the ABS brakes, instead of deactivating the ABS in response to a false signal. The driver would experience a hard brake pedal during the middle to end of a braking event and a decrease in deceleration at the end of the stop. The driver may experience an unexpected extended stopping distance, which could result in a collision. The ABS warning indicator light may not come on to warn the driver of a system malfunction. Correction: Dealers will replace the ABS ECU. Note: This Recall supersedes Recall 2002165. |
|---|---|
| 2003053 | 2003-02-28. Brakes. On certain vehicles, the Bosch Zero Offset Pin Slide (ZOPS) hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one or more of the brakes. In bus applications, the combination of the following factors may collectively result in an unreasonable risk to motor vehicle safety: potential fire at a wheel end, high incident rates of stuck calipers, and evacuation and containment concerns relating to multiple passengers. Correction: Dealer will affect repairs. |
| 2002165 | 2002-09-18. Brakes. On certain vehicles, the TRW Model 410M ECU (Electronic Control Unit) can misinterpret particular false wheel speed signals generated from any of the following conditions: An incorrect gap between the sensor and tone ring, a chaffed sensor wire, connector corrosion, sensor vibration or quality of harness and pin-outs. If one of these conditions occurs, the ECU could not distinguish between an actual low friction event on road surface and a low amplitude sensor signal and would activate the ABS brakes, instead of deactivating the ABS in response to a false signal. The driver would experience a hard brake pedal during the middle to end of a braking event and a decrease in deceleration at the end of the stop. The driver may experience an unexpected extended stopping distance, which could result in a collision. The ABS warning indicator light may not come on to warn the driver of a system malfunction. Correction: Dealer will affect repairs. Note: recall superseded by 2004171 and 2004172. |
| 2000131 | 2000-06-16. Brakes. On certain vehicles, the steering pump castings may have a thin wall in the pump casting or a complete connection of two passages that are supposed to be separated to control fluid flow. The power steering pump is used to provide power assist to both the steering system and the hydraulic brake system. A defective pump may reduce the fluid flow to less than the minimum required flow rate to provide full power assist to the brake system with low engine speed. Correction: Vehicles will be inspected for pump casting numbers and defective power steering pumps will be replaced. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.