Service bulletins for the 2019 Hyundai Veloster
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
140 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| 20-ST-001H | 2020-02-03. Service bulletin. STEERING. This bulletin provides information regarding replacement of the column-mounted Motor Driven Power Steering (MDPS) system as separate components. |
|---|---|
| 20-BE-001H | 2020-02-03. Service bulletin. ELECTRICAL SYSTEM. This bulletin provides guidelines to inspect the USB, head unit, and multi-box for common connection conditions. 2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port. |
| 19-01-042H | 2020-01-21. Service bulletin. EQUIPMENT. This bulletin provides information and procedures for collecting OBD ?In Use Monitor Performance Ratio? (IUMPR) data on certain 2019-2020MY vehicles at California dealers. This reporting is mandated by CARB (California Air Resources Board). Data is no longer submitted to Hyundai by datasheet and dealer email. Data is sent electronically by GDS when the procedure of this bulletin is followed. |
| 19-AT-021H-1 | 2020-01-21. Service bulletin. POWER TRAIN; EQUIPMENT. If you are servicing a vehicle with a transmission slipping concern, follow the Service Procedure shown below and perform a stall test. This TSB provides a procedure to test each clutch in the transmission. If the vehicle fails the stall test, replace the transmission. ? PASS: Stall speed is between 1700~2900 rpm (See shop manual for stall speed). ? FAIL: Engine revs to redline limit (6,000~6,500 rpm). If so, replace the transmission. |
| 19-AT-024H | 2019-12-16. Service bulletin. ELECTRICAL SYSTEM. If you are servicing a vehicle with the DTC or symptoms listed below, refer to the Service Procedure to diagnose the condition. ? Diagnostic trouble codes: ?P0705 - Range switch sensor circuit ?P0706 - Range switch range/performance ?P0707 - Range switch - open circuit ?P0708 - Range switch - short circuit or multiple inputs ? Symptoms: ?Malfunction Indicator Light (MIL) illuminated ?4th gear fail-safe ?No gear indication in cluster ?Intermittent no engine crank/no start in ?P? or ?N? with or without MIL or DTC. |
| 19-01-016H-1 | 2019-12-16. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING. This bulletin provides information related to an ECM (Engine Control Module) software update for DTC P0128: Coolant Thermostat (Coolant Temp below Thermostat Regulating Temperature) logic revision. There are no drivability symptoms associated with DTC P0128. |
| Campaign T3T Dea | 2019-12-16. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM:SOFTWARE. Hyundai has launched a Service Campaign to update the ECM (Engine Control Module) software for DTC P0128: Coolant Thermostat (Coolant Temp below Thermostat Regulating Temperature) logic improvement. |
| 19-BE-011H-1 | 2019-12-16. Service bulletin. LANE DEPARTURE; BACK OVER PREVENTION. The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to enter the lane where another vehicle is driving. |
| Campaign T4F Dea | 2019-11-18. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ENGINE; ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Hyundai is conducting a Service Campaign to perform an ECM software update to revise the battery sensor data to optimize SOC (State of Charge) value. The ECM Update also includes an update for misfire due to learning cylinder imbalance. |
| 19-01-005H-1 | 2019-11-18. Service bulletin. ENGINE; EQUIPMENT. The warranty coverage for the engine long block has been extended to 10 years or 120,000 miles from the date of original retail delivery or date of first use, whichever occurs first, and is valid for original and subsequent owners. |
| 19-01-006H-4 | 2019-11-18. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; ELECTRICAL SYSTEM:WIRING. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and install a wire harness extension and/or replacement engine based on the inspection results. |
| 19-01-002H-4 | 2019-11-18. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ENGINE. Hyundai is conducting a product improvement campaign to enhance the knock sensor software to detect abnormal engine bearing noise before potentially severe engine damage occurs. If abnormal engine bearing noise is detected, the Malfunction Indicator Lamp (MIL) will blink continuously, a chime will sound on certain vehicles, and the vehicle will be placed in Engine Protection Mode allowing the customer to drive to the nearest Hyundai dealer for diagnosis and repair. In addition, DTC P132600 will be recorded in the ECM. The vehicle can continue to be operated for a limited time in Engine Protection Mode, but it will accelerate slower and have a reduced maximum speed. Engine RPMs will be limited to approximately 1800-2000 RPM. |
| Campaign 953 Dea | 2019-11-18. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM:SOFTWARE; ENGINE; EQUIPMENT. Hyundai has developed a new engine monitoring technology called a Knock Sensor Detection System (KSDS). The technology uses software innovations and leverages existing engine sensors to continuously monitor for symptoms that may precede an engine failure. |
| Campaign T3G Dea | 2019-11-18. Service bulletin. ENGINE; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; ELECTRICAL SYSTEM. Hyundai has launched a Service Campaign for applicable vehicles with 2.0L Turbo and 2.4L GDI engines that may experience the Check Engine warning lamp illuminated with DTC P132600. |
| 19-01-005H-1 | 2019-11-06. Service bulletin. ENGINE AND ENGINE COOLING. The warranty coverage for the engine long block has been extended to 10 years or 120,000 miles from the date of original retail delivery or date of first use, whichever occurs first, and is valid for original and subsequent owners. |
| 19-01-006H-4 | 2019-11-06. Service bulletin. ENGINE AND ENGINE COOLING. Applicable vehicles with 2.0L Turbo and 2.4L GDI engines may experience the Check Engine warning lamp illuminated with DTC P1326. Follow the procedure to inspect the vehicle and install a wire harness extension and/or replacement engine based on the inspection results. |
| 19-01-002H-4 | 2019-11-06. Service bulletin. ENGINE AND ENGINE COOLING. Hyundai is conducting a product improvement campaign to enhance the knock sensor software to detect abnormal engine bearing noise before potentially severe engine damage occurs. If abnormal engine bearing noise is detected, the Malfunction Indicator Lamp (MIL) will blink continuously, a chime will sound on certain vehicles, and the vehicle will be placed in Engine Protection Mode allowing the customer to drive to the nearest Hyundai dealer for diagnosis and repair. In addition, DTC P132600 will be recorded in the ECM. The vehicle can continue to be operated for a limited time in Engine Protection Mode, but it will accelerate slower and have a reduced maximum speed. Engine RPMs will be limited to approximately 1800-2000 RPM. |
| Campaign 953 Dea | 2019-11-06. Service bulletin. ENGINE AND ENGINE COOLING. Hyundai has developed a new engine monitoring technology called a Knock Sensor Detection System (KSDS). The technology uses software innovations and leverages existing engine sensors to continuously monitor for symptoms that may precede an engine failure. |
| Campaign T3G Dea | 2019-11-06. Service bulletin. ENGINE AND ENGINE COOLING. Hyundai has launched a Service Campaign for applicable vehicles with 2.0L Turbo and 2.4L GDI engines that may experience the Check Engine warning lamp illuminated with DTC P132600. |
| 19-GI-006H | 2019-11-06. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This bulletin provides instruction detailing the proper methodology for scanning and uploading captured GDS data files to the Techline Repository. Compliance with this bulletin ensures that the GDS data files are correctly transferred and matched with a Techline Case number. |
| 19-AT-016H | 2019-09-30. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; EQUIPMENT ADAPTIVE/MOBILITY. If you are servicing an applicable vehicle with a ?Check Engine? light on and one or more of the DTC listed below, follow the repair procedure and replace the related solenoid and oil pressure harness. |
| 19-AT-012H | 2019-07-29. Service bulletin. POWER TRAIN. This TSB provides a procedure to diagnose and repair a transaxle for the following Incorrect Ratio DTC (transaxle clutch slipping more than 200 rpm in gear). |
| 19-AT-010H | 2019-07-01. Service bulletin. POWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION. This bulletin provides a procedure to transfer pressure data to the ECU/TCU using GDS Mobile. This procedure is necessary to reduce the TCU learning time and improve the shift quality. |
| Dealer Best Prac | 2019-05-20. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ENGINE AND ENGINE COOLING. Hyundai has launched a Service Campaign to update the ECM (Engine Control Module) software for DTC P0128: Coolant Thermostat (Coolant Temp below Thermostat Regulating Temperature) logic improvement. |
| DCS T3T | 2019-05-20. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Hyundai Motor America is conducting a Service Campaign to update the ECM software on certain 2018 Model Year Elantra GT and 2019 Veloster vehicles equipped with 1.6L turbo engines. Service Campaign T3T provides a procedure to update the ECM software. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.