Service bulletins for the 2019 GMC Yukon XL
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
707 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| PIP5491A | 2018-11-13. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. This Preliminary information communicates to the technician when diagnosing intermittent circuit concerns to look at the connector for missing weather pack seals that could allow water intrusion into the connector and lead to corrosion on the terminals. |
|---|---|
| PIP5570A | 2018-11-13. Service bulletin. STEERING:GEAR BOX:SHAFT PITMAN; STEERING:GEAR BOX:SHAFT SECTOR. This Preliminary information communicates to the dealer a conditionwhere a tick noise may be present inside a vehicle while driving. This may be the result of a deformed or improperly seated steering shaft seal allowing engine compartment sounds into the vehicle. Dealers are instructed to replace or reinstall the boot as needed and are informed the condition is being reviewed by engineering. |
| PIT5604A | 2018-11-13. Service bulletin. STRUCTURE:BODY:HATCHBACK/LIFTGATE:SUPPORT DEVICE/STRUT; STRUCTURE:BODY:HATCHBACK/LIFTGATE. This Preliminary information communicates if the liftglass will not open using keyless entry to verify Valet Mode is not enabled. |
| PIT4322J | 2018-10-15. Service bulletin. ELECTRONIC STABILITY CONTROL (ESC). This Preliminary Information communication provides information to the technician about vehicles that have an unwanted Stability Activation and/or a Service Stability message on the Driver Information Center. Technician may find a Diagnostic Trouble Code C0710. Technician should inspect for vehicles modifications before any in-depth diagnostics are performed. |
| PIT5361D | 2018-10-15. Service bulletin. SERVICE BRAKES. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have issues were the customer will need increased effort to depress the brake pedal. Technician may find fluid in the brake booster and/or the booster vacuum line. Technician will need to replace Vacuum Pump, Brake Booster, Master Cylinder, Vacuum Pump Belt and the Vacuum Line between the booster and the pump. |
| PIT5448D | 2018-10-15. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication advises the technician with a tip when the vehicle stops running after it has been idling for 2.5 hours. This is normal operation of the vehicle built with regular production code BTM and without Regular Production Option Code AVF. If the vehicle was built with regular production code BTM and AVF only has a 1 hour idle time. |
| PIT5241F | 2018-10-15. Service bulletin. TRAILER HITCHES. This Preliminary Information communication provides information to the technician about customers that may request the factory Integrated Trailer Brake Controller Regular Production Option Code (JL1) be installed on their Full-Size Pickup or SUV when the vehicle was not ordered with the option. Dealer should advise the customer it cannot be added to the vehicle. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.