WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Ford F-450

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

128 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Electrical system are shown. Show all

Bulletins, newest first
SSM 478242019-04-01. Service bulletin. ELECTRICAL SYSTEM. Some 2015-2017 vehicles may experience a no crank concern due to a security access key table error. When attempting to program keys or perform a parameter reset, the procedure may fail and the Integrated Diagnostic System (IDS) scan tool may display an error 232: Key Table Not Allocated. If this error message is encountered, the Body Control Module (BCM) is internally faulted and requires replacement. For claiming, use causal part 15604 and applicable labor operations in section 10 of the Service Labor Times Standards (SLTS) manual.
SSM 477112019-03-04. Service bulletin. ELECTRICAL SYSTEM. Some 2016-2019 Ford and Lincoln vehicles equipped with SYNC 3 and a 6, 8 or 10 inch screen may show a pop-up message every key cycle that states 'SYNC can check for updates when connected to a WiFi network'. To remove the inconvenience of the pop-up the customer can either connect to a trusted WiFi network to complete the setup process or turn off WiFi in the WiFi settings located under the Settings menu. Adjusting the setting for the customer is not a warrantable defect.
SSM 475972018-11-19. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); EQUIPMENT. Some 2013-2019 F-Super Duty vehicles equipped with a 6.7L engine may exhibit an illuminated MIL with only DTC P2074 stored in the powertrain control module (PCM). This may be due to a dirty air filter, replace the filter if necessary. Do not replace the PCM or mass air flow (MAF) sensor for this concern. Instead perform a MAF parameter reset under: Toolbox > Powertrain > Service Functions > Reset/Clear Specified Function > Reset/Clear Functions > MAF Sensor. Engineering is investigating. Monitor OASIS for updates.
TSB 18-23012018-11-19. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE (PCV). Some 2014-2016 F-Super Duty vehicles built on or before 11-Nov-2015 equipped with a 6.7L engine may exhibit an illuminated MIL with DTCs P04DB, P04E2 and/or P04E3 stored in the powertrain control module (PCM). Follow the Service Procedure steps to correct the condition.
SSM 471672018-05-21. Service bulletin. ELECTRICAL SYSTEM. Various 2016-2017 vehicles with SYNC 3 may experience a touch screen that does not respond to any input. Using the Professional Technician Society (PTS) website > OASIS tab > SYNC version, verify the vehicle SYNC software version. If the vehicle is at version 2.2 please update the module to the latest software level. After the software is updated make sure you shut the vehicle off, open the door for 2 minutes, then turn the key back on before testing the touch screen. If the software is at a later version than 2.2, proceed with normal diagnostics in Workshop Manual (WSM), Section 415-00. For claiming, use causal part 14G371 and applicable labor operations in section 10 of the Service Labor Times Standards (SLTS) manual.
SSM 469002018-01-29. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM. Some vehicles may exhibit a no start condition with an illuminated malfunction indicator lamp (MIL) and a DTC P161A after PCM replacement. This may be due to the parameter reset procedure not being properly completed. To clear this DTC, use the Ford Integrated Diagnostic System (IDS) service tool or Ford J2534 Diagnostic Software, select - Toolbox - Body - Security - PATS Functions - Parameter Reset. Follow the on-screen instructions to complete the procedure. This procedure will transfer the existing Key ID information between the modules without the need of having 2 programmed PATS keys present. There is no need to program keys when the PCM is going to be replaced. Additional information can be found in the Workshop Manual (WSM), Section 419-01. Missing or lost keys are not warrantable.
17-22372018-01-29. Service bulletin. ELECTRICAL SYSTEM; ENGINE; FUEL SYSTEM, DIESEL. Some 2016 F-Super Duty/F-650/750 vehicles equipped with a 6.7L diesel engine or 2016 Transit vehicles equipped with a 3.2L diesel engine may exhibit an illuminated MIL with DTCs P24AE, P24B1, P24DA, P24C6 and/or P24C7 stored in the powertrain control module (PCM). Follow the Service Procedure steps to correct the condition.
17-22342018-01-29. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Some 2015-2016 F-Super Duty pickup vehicles equipped with a 6.7L engine may exhibit an illuminated malfunction indicator lamp (MIL) with DTCs P2201, P2459, P2463 and/or P246C. Reprogram the powertrain control module (PCM) to the latest calibration using Integrated Diagnostic System (IDS) or Ford J2534 Diagnostic Software (FJDS) release 106.01 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com.
SSM 462362017-03-10. Service bulletin. ELECTRICAL SYSTEM. SOME 2015-2016 F-SUPER DUTY VEHICLES BUILT ON OR AFTER 08/22/2014 AND UP-FITTED WITH HIGH ELECTRICAL LOAD ACCESSORIES SUCH AS A SNOW PLOW OR WINCH MAY EXHIBIT ERRATIC PANEL ILLUMINATION OF THE RADIO, CLIMATE CONTROL AND INSTRUMENT PANEL CLUSTER (IPC) WHEN THE CUSTOMER OPERATES THE UP-FITTED ACCESSORY. THE BODY CONTROL MODULE (BCM) RESPONSE TO EXCESSIVE VOLTAGE SPIKES MAY BE THE CAUSE. REPROGRAM THE BCM TO THE LATEST CALIBRATION USING IDS RELEASE 103.02 OR HIGHER. MAKE SURE YOU ARE CONNECTED TO THE INTERNET WHEN ENTERING MODULE PROGRAMMING TO OBTAIN THE LATEST UPDATES. CALIBRATION FILES MAY ALSO BE OBTAINED AT WWW.MOTORCRAFTSERVICE.COM. USE CAUSAL PART 15604 AND APPLICABLE LABOR OPERATIONS IN SECTION 10 OF THE SERVICE LABOR TIME STANDARDS (SLTS) MANUAL.
SSM 459202017-02-11. Service bulletin. ELECTRICAL SYSTEM; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. SOME 2015-2016 F-SUPER DUTY VEHICLES EQUIPPED WITH A 6.7L DIESEL ENGINE MAY EXHIBIT AN ILLUMINATED MIL WITH DTCS:P218F, P123E, P123F, P22A2, P2204, P207F, P204E, P2085, P204F, P202E, P130E, P203E AND P205E WHICH REMAIN PRESENT AFTER REPAIRING/ATTEMPTING TO CLEAR FAULT DTCS,USING A SCAN TOOL. THESE DTCS WILL NOT BE CLEARED WITH A SCAN TOOL. AFTER FIXING THE ROOT CONCERN FOR THE IDENTIFIED DTCS, IF ANY OF THESE DTCS HAVE STATUS FLAGS OF: -08,-18,-48,-58 AND -68. YOU MAY PROCEED TO CLEAR ANY ACCOMPANYING DEF FLUID SYSTEM FAULT MESSAGES IN INSTRUMENT PANEL CLUSTER(IPC). USE SELECTIVE CATALYTIC REDUCTION (SCR) SYSTEM PROCEDURES IN PC/ED MANUAL SECTION 2 FOR CORRECT DRIVE CYCLES TO CLEAR DEF SYSTEM FAULT MESSAGES. IF THE MIL IS NO LONGER ILLUMINATED AND THE DEF FLUID SYSTEM FAULT MESSAGES ARE NO LONGER PRESENT, NO FURTHER REPAIRS ARE NEEDED.
SSM 458942017-02-09. Service bulletin. ELECTRICAL SYSTEM:WIRING; ELECTRICAL SYSTEM. 2016 F-SUPER DUTY - INOPERATIVE BLOWER MOTOR, POWER FOLD MIRROR, RKE TRANSMITTER AND/OR NO COMMUNICATION WITH MS-CAN - BUILT ON OR BEFORE 5/1/2016
16-00492016-06-22. Service bulletin. ELECTRICAL SYSTEM. 6.7L DIESEL - FUEL KNOCK AT IDLE WITH MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATED WITH MULTIPLE DIAGNOSTIC TROUBLE CODES (DTCS) ISSUE Some 2011-2016 F-Super Duty vehicles equipped with a 6.7L diesel engine may exhibit a fuel knock type noise at idle, illuminated MIL with one or more of the following DTCs: P0263, P0266, P0269, P0272, P0275, P0278, P0281, P0284, P02DA, P02D0, P02D1, P02D2, P02D3, P02D4, P02D5, P02D6, P02D7, P02D8, P02D9, P02CC, P02CD, P02CE and/or P02CF stored in powertrain control module (PCM) memory.
15-01582016-06-22. Service bulletin. ELECTRICAL SYSTEM. SUMMARY TO BE PROVIDED ON A FUTURE DATE.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.