P0106 on the 2021 Ford Escape
The bulletins listed name this code in NHTSA's summary, or are about the same components. A bulletin or a recall listed here may apply to the model year. None of it is a diagnosis.
Nobody has written a description of this code yet.
| 21B68-S1 | 2022-02-24. Service bulletin. In some of the affected vehicles, it may be possible that the TMAP (Temperature Manifold Absolute Pressure) sensor may ice over while driving in cold temperatures for extended periods of time. An iced over TMAP sensor may cause the check engine light to illuminate with diagnostic codes P1A0C, P2282, or P0106 in the PCM (powertrain control module). These codes may lead to the PCM disabling the eninge and a "Stop Safely Now" message appearing in the instrument cluster. |
|---|---|
| 21B68 | 2022-01-03. Service bulletin. Certain 2020-2021 Model Year Escape 2.5L HEV PHEV Vehicles Reprogram Powertrain Control Module (PCM) In some of the affected vehicles, it may be possible that the TMAP (Temperature Manifold Absolute Pressure) sensor may ice over while driving in cold temperatures for extended periods of time. An iced over TMAP sensor may cause the check engine light to illuminate with diagnostic codes P1A0C, P2282, or P0106 in the PCM (powertrain control module). These codes may lead to the PCM disabling the engine and a Stop Safely Now message appearing in the instrument cluster |
| TSB 21-2122 | 2021-05-04. Service bulletin. Some 2020-2021 Escape hybrid electric vehicles (HEV) built on or before 29-Mar-2021 may experience a lack of power, crank/no start, and Stop Safely Now message with diagnostic trouble codes (DTC) P2282, P0106 and/or P1A0C stored in the powertrain control module (PCM) in temperatures below 32’F/0’C. This may be due to various software parameters within the PCM and condensation buildup in the intake manifold. To correct the condition, follow the Service Procedure and reprogram the PCM. |
| SSM 49654 | 2021-03-31. Service bulletin. Some 2020-2021 Escape hybrid vehicles may experience an illuminated (MIL) and DTC P0106 and/or P2282 while operating at or below freezing and covering daily distances of about 60 miles (100 Km). Remove the throttle body per Workshop Manual (WSM) Section 303-04C and inspect the inside of the intake manifold for water/ice. If present, thaw the vehicle and remove liquid using a suction gun/large syringe and tubing. Swab the bottom of the intake by tying a shop towel to a rod to remove remaining liquid. Remove the manifold absolute pressure and temperature (MAPT) Sensor per WSM section 303-14C. Inspect/clean any ice or sludge build-up from MAPT sensor and reinstall. Inform the customer that this is an interim fix and that their vehicle is safe to drive. Schedule a follow-up appointment with the customer for May timeframe. Monitor OASIS in the 2nd quarter. |
4 on file from NHTSA, as of 2026-10-19. See them in the bulletin list. A bulletin lists model years: read the document for which vehicles it concerns.