Recalls that may apply to the 1995 Ford Contour
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Seats And Restraints are shown.
| None found. |
| 1996003 | 1996-01-09. Seats And Restraints. THESE VEHICLES MAY NOT COMPLY WITH THE REQUIREMENTS OF C.M.V.S.S 210 - SEAT BELT ASSEMBLY ANCHORAGES. THE HARDWARE THAT ATTACHES THE OUTBOARD ENDS OF THE FRONT SAFETY BELTS TO THE FRONT SEAT FRAMES MAY BE CRACKED OR FRACTURED. IF SO. THE LOAD THAT THE SAFETY BELT COULD SUSTAIN WOULD BE BELOW THAT SPECIFIED BY THE STANDARD. CORRECTION: REINFORCEMENT PLATES WILL BE INSTALLED TO THE ATTACHMENT HARDWARE OF BOTH OUTBOARD FRONT SAFETY BELTS. IF THE ATTACHMENT HARDWARE IS FRACTURED, A NEW SAFETY BELT WILL BE INSTALLED. |
|---|---|
| 1995032 | 1995-02-21. Seats And Restraints. THE PASSENGER SIDE SUPPLEMENTAL RESTRAINT SYSTEM (AIR BAG) MAY HAVE A CRACKED INFLATOR BODY. IF THE VEHICLE IS INVOLVED IN A DEPLOYMENT LEVEL CRASH, THE PASSENGER SIDE AIR BAG MAY NOT INFLATE PROPERLY WHICH COULD RESULT IN REDUCED OCCUPANT PROTECTION. IN ADDITION, THE IGNITER PLUG COULD SEPARATE FROM THE INFLATOR, WHICH COULD RESULT IN THE RELEASE OF HOT GASES AND COULD IGNITE FLAMMABLE MATERIAL OR POTENTIALLY CAUSE PERSONAL INJURY. CORRECTION: VEHICLES WILL BE INSPECTED AND A NEW PASSENGER SIDE AIR BAG MODULE WILL BE INSTALLED IF NECESSARY. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.