# P1C86 on the 2015 Dodge Durango

The bulletins listed name this code in NHTSA's summary, or are about the same components. A bulletin or a recall listed here may apply to the model year. None of it is a diagnosis.

This code is specific to a manufacturer and is not described here.

## Bulletins for this model year that name P1C86

- [10217372](https://open.wenmarpro.com/bulletins/10217372), 2022-08-08: Part Description: ATX Shifter Issue Description: Prior to removing \(or disconnecting\) the automatic transmission shifter knob, for any service to the shifter or for console removal, disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service. This will prevent a P1C86\-14 DTC being stored in the electronic shift module \(ESM\). Failure to disconnect the battery before servicing the shifter may cause the P1C86\-14 DTC to be set again. Clear the code before replacing the shifter. In the event a P1C86\-14 DTC persist after following the above procedure, refer to 28 \- DTC\-Based Diagnostics, in the service manual.
- [10216134](https://open.wenmarpro.com/bulletins/10216134), 2022-07-25: Part Description: ATX Shifter Issue Description: Prior to removing \(or disconnecting\) the automatic transmission shifter knob, for any service to the shifter or for console removal, disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service. This will prevent a P1C86\-14 DTC being stored in the electronic shift module \(ESM\). Failure to disconnect the battery before servicing the shifter may cause the P1C86\-14 DTC to be set again. Clear the code before replacing the shifter. In the event a P1C86\-14 DTC persist after following the above procedure, refer to 28 \- DTC\-Based Diagnostics, in the service manual.
- [10151715](https://open.wenmarpro.com/bulletins/10151715), 2018-12-17: Part Description: ATX Shifter Issue Description: Prior to removing \(or disconnecting\) the automatic transmission shifter knob, for any service to the shifter or for console removal, disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service. This will prevent a P1C86\-14 DTC being stored in the electronic shift module \(ESM\). Failure to disconnect the battery before servicing the shifter may cause the P1C86\-14 DTC to be set again. Clear the code before replacing the shifter. In the event a P1C86\-14 DTC persist after following the above procedure, refer to 28 \- DTC\-Based Diagnostics, in the service manual.