WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Chevrolet Tahoe

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1477 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
PIP58052021-06-14. Service bulletin. ENGINE. This Preliminary information communicates that the performance air cleaner kit (cold air intake system) can only be installed on vehicles that had the option ordered for the vehicle when it was produced. This performance air filter kit can not be installed on vehicles that were not ordered / produced with this option. This document also reinforces, the vehicles that did have the kit ordered and installed, a calibration is needed to make the kit work properly or DTC's may set.
000601026N2021-06-07. Service bulletin. ENGINE. This service bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.
PIP5776C2021-05-17. Service bulletin. ENGINE. This Preliminary information communicates that a vehicle may exhibit a misfire condition resulting in misfire codes P0300-P308. Upon diagnosis it may be discovered the lifter has come apart. It is recommended to replace the lifter guide and the four lifters.
PIP5752L2021-05-17. Service bulletin. ENGINE. This Preliminary information communicates A Vehicle may have a concern of service engine light, misfire and engine noise with possible of DTC P0300 P0106 P0506, Possible valve spring concern
PIE06182021-05-03. Service bulletin. ENGINE AND ENGINE COOLING. This engineering informational bulletin is requesting information from technicians to perform the check list provided and contact the engineer listed in regards
20NA1382021-05-03. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN. This bulletin provides information on Policies Applicable to All U.S. Dealers for Engine and Transmission Assembly Replacement Under Warranty, Policy or Customer Enthusiasm and information on Submission of Warranty Transaction in Global Warranty Management.
PIP5212C2021-04-19. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have run hot and or has a tick noise. Technician should inspect the head gaskets to ensure are not installed backwards. Technician should replace the head gasket if they are found installed backwards.
PIP57912021-04-19. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to dealership technicians to perform a sweep of the coolant flow control valve and test the circuits before replacing the Engine Coolant Flow Control Valve, and to assist engineering in root causing the P2B60.
PIT58172021-04-19. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates and issue with a SES MIL and the BCM keeping the ignition main relay on after the vehicle is turned off. Dealers are to replace the BCM.
20NA2182021-03-01. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE. This technical bulletin provides repair information to correct a customer concern of Possible Crank No Start or Extended Crank with DTC P12A6.
18NA0732021-03-01. Service bulletin. ENGINE. This service bulletin provides graphics, information and guidelines for engine component wear to assist service personnel as a guideline to perform necessary engine repairs and prevent unnecessary engine replacement.
PIE0601A2021-03-01. Service bulletin. ENGINE; ELECTRICAL SYSTEM. This engineering informational bulletin is requesting information from technicians to perform the check list provided and contact the engineer listed in regards to the Service Engine Soon Lamp being illuminated.
090604026S2021-03-01. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE; EQUIPMENT. This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
010601011L2021-03-01. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION; EQUIPMENT. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
N202319660 012021-03-01. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL. Service Update. Certain vehicles may present a broken engine valve spring. This may cause the engine to run rough, an engine knocking or ticking noise, a check engine light illumination, or a possible vehicle stall. Dealers are to perform the inspection procedure contained within this bulletin.
N202310850 022021-03-01. Service bulletin. ELECTRICAL SYSTEM; SEATS; ENGINE AND ENGINE COOLING; EQUIPMENT; AIR BAGS. Customer Satisfaction Program (Revised Service Procedure and Part Ordering Information). In certain vehicles, driver movement can disrupt the electrical connection to the seat-mounted inboard airbag system. This airbag system is supplemental and not required equipment under applicable Federal Motor Vehicle Safety Standards. If this occurs, the vehicle?s driver information center will display a ?Service Restraints System? message to the driver before resistance at the connection will prevent the deployment of the airbag. Dealers are to verify the DTC B14DC is present and replace the affected driver inboard side seat wiring harness connector assembly as necessary.
N202310850 Reope2021-03-01. Service bulletin. EQUIPMENT; SEATS; ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. Customer Satisfaction Program (VINS re-opened, software updated). In certain vehicles, driver movement can disrupt the electrical connection to the seat-mounted inboard airbag system. This airbag system is supplemental and not required equipment under applicable Federal Motor Vehicle Safety Standards. If this occurs, the vehicle?s driver information center will display a ?Service Restraints System? message to the driver before resistance at the connection will prevent the deployment of the airbag. Dealers are to verify the DTC B14DC is present and replace the affected driver inboard side seat wiring harness connector assembly as necessary.
N202310850 012021-03-01. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT; AIR BAGS; ENGINE AND ENGINE COOLING; SEATS. Customer Satisfaction Program (Revised Correction, Service Procedure and Warranty Information). In certain vehicles, driver movement can disrupt the electrical connection to the seat-mounted inboard airbag system. This airbag system is supplemental and not required equipment under applicable Federal Motor Vehicle Safety Standards. If this occurs, the vehicle?s driver information center will display a ?Service Restraints System? message to the driver before resistance at the connection will prevent the deployment of the airbag. Dealers are to verify the DTC B14DC is present and replace the affected driver inboard side seat wiring harness connector assembly as necessary.
20NA2282021-02-22. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM); FUEL SYSTEM, OTHER:FUEL FILTER. This technical bulletin provides a procedure to replace the fuel filter and perform a filter life procedure if found the reason for a failed fuel filter life reset during ECM transfer of data.
20NA2182021-02-22. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE; EQUIPMENT. This technical bulletin provides repair information to correct a customer concern of Possible Crank No Start or Extended Crank with DTC P12A6.
19NA2182021-02-22. Service bulletin. ENGINE AND ENGINE COOLING. This technical bulletin provides a service procedure to correct a condition of Ticking Noise from the Engine.
17NA1662021-02-22. Service bulletin. ENGINE AND ENGINE COOLING. This technical bulletin provides a procedure to measure vibration and install engine mounts to correct a Rough Idle in Drive concern.
N202319660 012021-02-22. Service bulletin. ENGINE AND ENGINE COOLING. Service Update. Certain vehicles may present a broken engine valve spring. This may cause the engine to run rough, an engine knocking or ticking noise, a check engine light illumination, or a possible vehicle stall. Dealers are to perform the inspection procedure contained within this bulletin.
N2023212302021-02-16. Service bulletin. LANE DEPARTURE; FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. Service Update. On certain vehicles the clamp may not be properly aligned and positioned on the hose, or the hose is rolled over on the pump port. The improper assembly can quickly develop into a significant leak early in the truck?s life. As the coolant level drops, a Low Coolant Warning or potential for engine overheat with DIC message is possible. Dealers are to inspect for both the vertical and horizontal hose at the auxiliary coolant pump, and repair as needed.
N202319660 012021-02-16. Service bulletin. ENGINE; EQUIPMENT. Service Update. Certain vehicles may present a broken engine valve spring. This may cause the engine to run rough, an engine knocking or ticking noise, a check engine light illumination, or a possible vehicle stall. Dealers are to perform the inspection procedure contained within this bulletin.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.