WenmarOpen by Wenmar Pro

Service bulletins for the 2020 Chevrolet Tahoe

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

855 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
PIP5719A2020-05-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates the possibility of dtc P12A6 with the possibility of a crank no start or extended crank concern.
140604004F2020-04-27. Service bulletin. ENGINE AND ENGINE COOLING. This informational bulletin explains the normal noises an engine may make when the ambient temperature outside is cold or the vehicle has sat for a few hours.
040601029J2020-04-06. Service bulletin. ENGINE; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. This informational bulletin explains Unscheduled Supplemental Services (including Flushing Services and Additives) and the Proper use of GM Simplified Maintenance Schedules.
19NA2182020-04-06. Service bulletin. EQUIPMENT; ENGINE. This technical bulletin provides a service procedure to correct a condition of Ticking Noise from the Engine.
20NA0382020-03-30. Service bulletin. FUEL SYSTEM, DIESEL; ENGINE. This informational bulletin explains the difference in AFM and DFM engines and what is and is not activated during this occurrence.
18NA0732020-03-30. Service bulletin. EQUIPMENT; ENGINE. This Bulletin provides graphics, information and guidelines for engine component wear to assist service personnel as a guideline to perform necessary engine repairs and prevent unnecessary engine replacement.
19NA2122020-03-02. Service bulletin. ENGINE. This diagnostic tip provides a procedure to aid in performing a diagnostic test to verify if the camshaft alignment pin has been sheared away to correct a crank/No Start condition.
15NA0102020-03-02. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. This informational bulletin provides information to dealership personnel for new vehicles with less than 1,000 miles that may not pass California smog inspection or smog inspection in other states.
PIP5130K2020-02-10. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician how to diagnose and repair a vehicle with an engine that runs with an intermittent crank no start with a Diagnostic Trouble Code P0011 or P00C6 current or history. The Camshaft Position Actuator Solenoid Valve may be sticking or binding causing the valve timing to be retarded. Dealer will need to cycle the Camshaft Position Actuator Solenoid Valve by energizing it using Global Diagnostic System 2.
PIP5503B2020-02-10. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE (PCV). This Preliminary information communicates to the dealer additional information on checking for the engne crankcase being overfull on oil causing an engine vibration concern. The technician is advised to inspect for contaminnants and adjust the engine oil level as needed.
PIP5335D2019-12-09. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on. Technician will find Diagnostic Trouble Codes P0340 and P0341 setting at times. Technician should use normal published Service Information diagnostics. If normal Service Information diagnostics does not isolate the concern, inspect for corrosion in connector X154 located on the front cover next to the vacuum pump.
010601011K2019-11-25. Service bulletin. ENGINE AND ENGINE COOLING. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
PIT5447C2019-11-12. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician on the steps needed to diagnose and repair vehicles that may have a rattle noise from the dash. Technician will need to inspect for the rear heater pipes contacting the passenger side exhaust manifold. If the rear heater pipe is found to be contacting the exhaust manifold, reposition the heater pipe so it no longer makes contact.
PIP5606E2019-10-15. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates A vehicle may have a tick noise from the engine cold, initial start in the morning. A lifter may not have sufficient amount of oil during cold start operation (not pumped up). As information comes in the Pi will be updated and when the final repair is out this this PI will be changed to a Bulletin
PIT5448F2019-10-15. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication advises the technician with a tip when the vehicle stops running after it has been idling for 2.5 hours. This is normal operation of the vehicle built with regular production code BTM and without Regular Production Option Code AVF. If the vehicle was built with regular production code BTM and AVF only has a 1 hour idle time.
090604026R2019-09-23. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
070601016F2019-09-23. Service bulletin. ENGINE AND ENGINE COOLING. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
000601026M2019-09-23. Service bulletin. ENGINE AND ENGINE COOLING. This informational bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.