WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Chevrolet Silverado

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

2229 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
19NA2372019-11-25. Service bulletin. FUEL SYSTEM, DIESEL. This informational bulletin explains how to identify possible DEF contamination.
18NA3612019-11-25. Service bulletin. ENGINE AND ENGINE COOLING. This technical bulletin provides a procedure to flush the cooler lines to validate if there is excessive debris in the fuel system caused by a failed part.
18NA3062019-11-25. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This Warranty Administration bulletin provides information for dealers/Service advisors on when and how to submit a Pre-Repair Authorization (PRA) (US dealers only).
18NA2792019-11-25. Service bulletin. EQUIPMENT:ELECTRICAL. This informational bulletin provides information for dealers/technicians on the process to disable and enable passive unlocking.
18NA1612019-11-25. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. This technical bulletin provides a procedure for testing the battery cables for voltage drop, Checking for a bad ground at g218, Inspecting for a short at the starter B+ to shield and testing for a faulty battery.
16NA3722019-11-25. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin provides information on common diesel engine tick noises and how they are considered part of normal operation and no parts should be replaced for these normal operating conditions.
16NA3612019-11-25. Service bulletin. POWER TRAIN. This informational bulletin explains possible normal condition of a flare from 1st to 2nd, even if the trans had been repaired for the flare and its still noticed.
16NA3382019-11-25. Service bulletin. POWER TRAIN. This Bulletin provides guidelines for Dealers Not Required and for Dealers Required to Contact the PQC for engine or transmission assembly replacement and explains the PQC process, GWM Transaction submission, vehicle service record retention and proper handling of assembly returns.
N192255140 012019-11-12. Service bulletin. POWER TRAIN. N192255140 01 - Customer Satisfaction Program. Certain vehicles may have a condition in which the bolt for the secondary generator (RPO KHB) was torqued but did not receive the proper clamp load. It is possible the bolt will loosen over time.
N1922642112019-11-12. Service bulletin. ENGINE AND ENGINE COOLING. N192264211 - Customer Satisfaction Program - Certain vehicles may have a condition in which the block heater cable function was disabled or the customer was advised to not use this feature. Dealers will replace the engine block heater.
N1922642102019-11-12. Service bulletin. ENGINE AND ENGINE COOLING. N192264210 - Customer Satisfaction Program - Certain vehicles may have a condition in which the block heater cable function was disabled. Dealers will replace the engine block heater and cord.
N192210330 012019-11-12. Service bulletin. VEHICLE SPEED CONTROL:CRUISE CONTROL; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. N192210330 01 - Service Update (Revised service procedure). Certain vehicles received an instrument panel cluster (IPC) service calibration whick prevents the cruise control indicator and digital speed from displaying. Dealers are to reprogram the IPC.
N1922678702019-11-12. Service bulletin. ELECTRICAL SYSTEM. N192267870 - Service Update. Certain vehicles have a new feature that notifies customers via text or email of a low battery voltage. This feature will not function if the voltage becomes low and the vehicles is In Off Power Mode. A service engine soon (SES) light will illuminate upon starting or jump starting the vehicle and multiple U-Codes will be stored in the engine control module (ECM). The U-Code combinations will include two or more of the following codes: U0101, U0102, U0129, U0140, U18A2. Dealers are to reprogram the ECM.
PIT5509E2019-11-12. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicle that may have a "Check Trailer Wiring" or "Service Trailer Brake System? message on the Driver Information Center when a trailer is connected to the vehicle. Diagnostic Trouble Code C1114 set in the Chassis Control Module. Chassis Control Module has to determine the type of trailer brake system that is being used. The Chassis Control Module can be sensitive to a variety of trailer wiring issues. The technician will need to make a trailer tester using Electric Trailer Brake Magnets and 7-way trailer connector to determine if it is a vehicle or trailer issue. If the concern is not duplicated with the tester installed, the vehicle is operating correctly and the focus should be on the trailer wiring or 7 way connector.
PIT57172019-11-12. Service bulletin. ELECTRICAL SYSTEM; VISIBILITY. This Preliminary information communicates if the sunroof, rear sliding window, and/or wireless charging are found to be inoperative due to the F2DL and/or the F8DL fuse(s) being open. Inspect the center console harness area at the hinge pivot point for chaffed circuits.
PIP56862019-11-12. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. This Preliminary information communicates A vehicle may come into the dealer with a rough idle, lean running concern and/or air leak noise from the PCV system. Upon inspection the technician may find the SES lamp is illuminated and/or DTC?s P0171 and/or P0174 may be in active or stored history. This condition may be caused by an incorrectly installed foul air PCV tube or tube may be damaged
PIT5288H2019-11-12. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that may have any of these concerns remote keyless entry, passive Entry and Start Inoperative, No Fob detect message on driver information center, service tire pressure system, no audio, touch screen Inoperative, Steering Wheel Controls Inoperative, Service Stabilitrak, rear power windows inoperative, rear wiper inoperative, and or a dead battery. Technician may find Diagnostic Trouble Codes B3101, B144C, C0710, C0544, U1548, U1549, U154A, U0151, U0126, U0415, U0077, U0028 and/or U0029. Technician should inspect the left instrument panel for the wire harness being pinched. Technician will need to repair the wire harness and reroute the wire harness.
PIT5392D2019-11-12. Service bulletin. VEHICLE SPEED CONTROL:ACCELERATOR PEDAL. This Preliminary Information communication provides information to the technician about vehicles that have a detent / click with a feel of increased resistance when the accelerator pedal is about ¾ of the way. The new accelerator pedal design has a built-in detent position near the last 1/4 of pedal travel. Dealer should communicate to the customer this is a normal operating characteristic of the vehicle and no repair attempts should be performed.
PIT5535E2019-11-12. Service bulletin. LANE DEPARTURE. This Preliminary Information communication provides information to the technician about vehicles that may have Service Front Camera, Service Lane Departure Warning, and Service Lane Keep Assist Message. Technician may find Diagnostic Trouble Code B1008 Sym 4B set. Technician will need to check the windshield to ensure it is not aftermarket. Technician will also check for anything that may impair the front view camera and ensure the camera is properly mounted.
PIT5161G2019-11-12. Service bulletin. FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician about vehicles that may have a bump feel or clunk noise at a stop or on launch. Dealer should communicate to the customer this condition is a normal operating characteristic of their vehicle. The bump clunk issue may be due to fuel movement in the fuel tank when not completely full. The condition is eliminated after completely filling the fuel tank.
PIP56852019-11-12. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. This Preliminary information communicates A vehicle with a customer concern of a SES P0128, Engineering is aware of the concern and working on the a repair. At this time clear the codes and do not replace the thermostat for this concern. There will be a calibration released for the concern in this near future. This PI will be updated when the calibration is released.
PIT5660A2019-11-12. Service bulletin. ELECTRICAL SYSTEM. This Preliminary information communicates repair information if the HVAC mode door actuator becomes lost and does not move to the correct mode position.
PIT57152019-11-12. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information provides information to the technician about a additional diagnostic tip for a check engine lamp for DTC p3055 and P3056 and the start/Stop being inoperative.
PIT5702A2019-11-12. Service bulletin. ELECTRICAL SYSTEM. This Preliminary information communication provides information to the technician on installing Regular Production Option Code 9L7 Up-fitter Auxiliary Switches. Technician will need to reference the latest version of General Motors Up-fitter Integration Bulletin 153. The information can be found at http://www.gmupfitter.com/ under the "Technical Bulletin" Tab and then "Show all bulletins."
PIP5370E2019-11-12. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician that some vehicle may have an ?Exhaust Fluid Quality Poor? on the Driver Information Center or a diesel exhaust fluid warning lamp on or other exhaust fluid quality related concerns. Technician will inspect the diesel exhaust fluid for contamination. Technician should use Service Information for Contaminants in Diesel Exhaust Fluid Diagnosis and use special tool J26568 or EN50422 Diesel Exhaust Fluid Refractometer for fluid testing.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.